共查询到20条相似文献,搜索用时 15 毫秒
1.
介绍了一种新的刚体转动的四元数模型。这些模型可以提高再定向控制的对边界条件的适应能力,在此基础上还介绍了这些模型的一些实际应用。 相似文献
2.
A. A. Davydov 《Cosmic Research》2011,49(4):335-344
A communication satellite (small spacecraft) injected into a geosynchronous orbit is considered. Flywheel engines are used
to control the rotational spacecraft motion. The spacecraft after the emergency situation has passed into a state of uncontrolled
rotation. In this case, no direct telemetric information about parameters of its rotational motion was accessible. As a result,
the problem arose to determine the rotational satellite motion according to the available indirect information: current taken
from the solar panels. Telemetric measurements of solar panel current obtained on the time interval of a few hours were simultaneously
processed by the least squares method integrating the equations of rotational satellite motion. We present the results of
processing 10 intervals of the measurement data allowing one to determine the real rotational spacecraft motion and to estimate
the total angular momentum of flywheel engines. 相似文献
3.
The problem of optimal control over many-revolution spacecraft orbit transfers between circular coplanar orbits of satellites is considered. The spacecraft flight is controlled by a thrust vector of a jet engine with restricted thrust (JERT). The mass expenditure is minimized at a limited time of flight. The optimal control problem is solved based on the maximum principle. The boundary value problem of the maximum principle is solved numerically using the shooting method. A modified computation scheme of the shooting method is suggested (multi-point shooting), as well as a method (correlated with the scheme) of choosing the initial approximation with the use of a solution to the optimization problem in the impulse formulation. The scheme and method allow one to construct many-revolution spacecraft orbit transfers. 相似文献
4.
热变形对天线指向机构的指向精度具有重要影响,但利用传统的设计方法很难实现对指向精度的准确计算,尤其是热变形对指向精度影响的研究工作更是少见。为此建立了机构的三维实体热-结构耦合有限元分析模型,根据有限元分析结果并结合机构的运动链关系,构建了各关键运动副运动误差的计算方法;在此基础上实现了机构指向误差的计算,研究了运动副名义、最大以及最小配合间隙条件下,温度载荷对各关键运动副运动误差和指向精度的影响。研究结果表明,温度载荷对关键运动副的运动误差以及机构的指向精度具有重要影响,随着温度载荷偏离常温数值的增加,指向误差不断增大,名义配合间隙条件下的指向误差最大。 相似文献
5.
6.
为满足航天器微振动环境模拟的需要,开展了多自由度微振动时域波形复现控制方法研究。首先,介绍了基于时域波形复现的多自由度微振动环境模拟控制理论方法。其次,针对六自由度微振动激励系统,应用MATLAB软件建立了基于实测传递函数矩阵的多输入多输出微振动激励仿真系统,针对微振动时域波形复现闭环控制过程进行了算法编程,并给出了仿真的闭环控制流程图。最后,通过算例对多自由度微振动时域波形复现进行了数值仿真,以给定的白噪声为输入,模拟对实际存在的系统非线性、测量误差等影响因素的控制效果。仿真结果验证了多自由度微振动时域波形复现控制方法的可行性及有效性,所得结论可以为研究多自由度微振动时域波形复现控制系统提供参考。 相似文献
7.
8.
10月14日,国际空间大学董事会主席拉姆·哈迪姆访问中国航天科技集团公司,就集团公司承办国际空间大学2007年暑期进修项目的筹备情况与集团公司人力资源部部长陈学钏、副部长白燕强交换了意见。陈学钏部长向哈迪姆通报了集团公司筹备这次活动的工作进展情况。据陈部长介绍,中国 相似文献
9.
The problem of determining an estimation of current spacecraft motion parameters on the stage of its descent is solved on the basis of readings of an optoelectronic navigation system and additional information from the self-contained inertial navigation system at the most general assumptions on the nature of motion of the object and the statistical properties of the noise of the measuring devices. 相似文献
10.
11.
金属网由于柔韧性好、使用方便等优势而在电缆屏蔽工程上得到广泛应用。本文对电缆用的金属网屏蔽效能进行工程计算,通过计算,对金属网不同材料、不同规格、单层与双层屏蔽及有缝隙情况下的屏蔽效能进行比较与分析,对工程应用有一定的指导意义。 相似文献
12.
13.
14.
V. V. Laricheva 《Cosmic Research》2013,51(4):304-314
Properties of differential equations of multi-orbit trajectory motion of a spacecraft are investigated analytically. The spacecraft moves under the action of small perturbations (in particular, low thrust) in the plane of a central Newtonian field of attraction. The conditions are specified for existence of a partial singular aperiodic solution, in the neighborhood of which the behavior of osculating elements changes sharply. In this case, phase variables (the angular position of the pericenter and the true anomaly) are found to undergo the sharpest changes. The exact superposition of solutions is suggested for the equations of motion transformed to the form of a quasi-linear, weakly non-stationary system: a partial singular aperiodic solution and fast solutions oscillating around it. Asymptotic representations are obtained for both components of the superposition. They are fairly exact in the region of smallness of perturbing terms at a long variation of the argument. 相似文献
15.
16.
17.
I. V. Barmin M. V. Volkov A. V. Egorov E. F. Reut A. S. Senchenkov 《Cosmic Research》2001,39(4):380-390
This paper generalizes the results of measuring the residual accelerations arising when investigations in space materials science are carried out onboard the unmanned Fotonspacecraft. The levels of vibroaccelerations are analyzed in the frequency band of 1–500 Hz for the technological devices UZ01, UZ04, and POLIZON, developed by the Federal Unitary State Enterprise Barmin Design Bureau of General Machine Building (V.P. Barmin KBOM). The levels of accelerations are estimated in the frequency band of 0–1 Hz in the zone of technological operations of these facilities. The basic sources of vibroaccelerations acting upon the frames of devices are determined in the capsule zone, where technological processes of producing new materials take place. In the frequency band of 1–500 Hz the vibroaccelerations are shown to be generated by the operation of Fotonspacecraft units and a drive of capsule translation during the technological process. On the capsule frame they reach the values of (1–3) × 10–3
g. The level of linear accelerations in the infralow-frequency band is determined by rotational motions of the Fotonspacecraft. It depends on the device location with respect to the spacecraft center of mass and does not exceed (1–7) × 10–6
gin the steady-state regime in the zone of technological activity. 相似文献
18.
19.
The theory of generalized elastic potentials is used for solving the problem of a space with cracks of arbitrary shape. Two solutions are proposed. In the first case, the solution is represented by a double-layer potential and a functional equation for determination of the unknown density is constructed in which difficulties stipulated by high polarity of the integrand may be eliminated. The other method consists of an analysis of a space with a thin smooth cavity and the solution of corresponding singular integral equations.Methods to improve the convergence of successive approximations used in solution of the equations are described and some particular cases of three-dimensional solids are considered. A special function is introduced on the external surface of the solid, which allows consideration of a whole space with cracks having fictitious stresses on their edges; this solution has some bearing on the main problem and also provides an integral equation for the auxiliary function. Another approach consists of the elimination of cracks by introduction of corresponding potentials and solution of the auxiliary problem for a continuous solid with special boundary conditions. 相似文献
20.
A method of estimating the stability of the problem of orbit determination under disturbances caused by finite accuracy of calculation and geographical siting of observation stations is proposed. 相似文献