直升机燃油系统地面模拟试验中试验台转角与油面角的关系

为了在直升机燃油系统地面模拟试验中准确地模拟油面角，本文介绍了试验台转角与油面角的关系，并给出了转换结果，同时，提出了一种用油箱内增压来模拟过载的设想，使在模拟试验时，油泵供油更趋真实，通过简化计算，给出了确定气压力的方法和判断依据。     

Detection of chi-square fluctuating targets in arbitrary clutter

In a recent paper, general expressions were derived for the density and cumulative probability functions of the amplitude of a linear matched-filter output given a nonfluctuating target in a clutter-limited environment. These expressions were based on the clutter amplitude density function. The results are extended to calculate the cumulative probability function of the output of a linear matched filter used to detect a chi-square fluctuating target in a clutter-limited environment. The resulting method is applied to a common radar clutter model, and experimental sonar data.     

Optimum FFT-based frequency acquisition with application toCOSPAS-SARSAT

In the case of a single sinusoid or multiple well-separated sinusoids, a coarse estimator consisting of a windowed Fourier transform followed by a fine estimator which is an interpolator is a good approximation to an optimal frequency acquisition and measurement algorithm. The design tradeoffs are described. It is shown that for the fine-frequency estimator a good method is to fit a Gaussian function to the fast-Fourier-transform (FFT) peak and its two neighbors. This method achieves a frequency standard deviation and a bias in the order of only a few percent of a bin. In the case of short-time stationarity, for a moderate number of averages and for an adaptive threshold detector, only between 0.5 and 1 dB is lost when averaging is traded off for FFT length, in contrast to the asymptotic result of 1.5 dB. The COSPAS-SARSAT satellite system for emergency detection and localization is used to illustrate the concepts. The algorithm is analyzed theoretically, and good agreement is found with test results     

Interference torque of a three-floated gyroscope with gas-lubricated bearings subject to a sudden change of the specific force

A numerical study is carried out to investigate the influence of a sudden change of the specific force on a three-floated gyroscope with a rotor supported on gas-lubricated bearings.The interference torque is calculated to evaluate the influence by modeling the transient behavior of the rotor-bearing system. In combination with dynamic equations of the rotor displacement,the Reynolds equation is solved on the surface of spiral-grooved conical bearings. It is assumed that a steady state has been obtained with a constant specific force, and then the specific force is suddenly changed and maintained constant after that. Responses of the sudden change are obtained by solving the equations. Numerical results show that the direction of the sudden change of the specific force is the main factor which influences the interference torque curve. With a sudden change along the input direction, the interference torque fluctuation has a constant frequency and a decreasing amplitude. With a sudden change along the output direction, the interference torque fluctuates in a small range. With a sudden change along the spin direction, the change of the interference torque combines a fluctuation and a gradually-changing quasi-equilibrium value. This study provides a supplement to the steady-state error model of the three-floated gyroscope.     

液体冲压发动机控制系统半实物仿真

运用小偏离线性化理论和Willoh方法，建立了液体冲压发动机和弹体动态数学模型。动态数学模型在微型计算上一体化运行，形成液体冲压发动机／弹体一体化实时数字仿真器。实时数字仿真器通过输入输出接口与液体冲压发动机的实际控制系统进行联接，组成液体冲压发动机、弹性和发动机控制系统半实物仿真系统。对冲压发动机飞行马赫数和控制 系统供油量的半实物仿真结果表明，系统能满足研制工作的需要。     

用于雷达波形的无损压缩编码

讨论了用算术编码实现波形数据的无损压缩。对波形数据进行无损压缩时 ,如果把每个可能的样本值看作一个符号 ,符号表会非常庞大 ,导致算法不可行。基于这种原因 ,本文用一个符号表示一定范围内波形数据 ,而不是单个波形数据 ,然后在此基础上设计了一种编码方案。先是无损线性预测 ,去除了波形数据之间的相关性。并假定产生的差值序列具有白功率谱 ,幅度服从高斯分布 ,第二步是算术编码。最后给出了对雷达回波数据进行压缩的实验结果。     

A Study of Pilot Reaction Capability to Sound Stimulus

An experiment is described which was used to evaluate a typical pilot's ability to activate a switch in response to a sound stimulus. Regularly spaced voice countdown, irregular voice countdown, initiation of a tone, and termination of a tone were each used as the stimulus. The individual under test was given a task similar to that involved in maintaining accurate flight conditions to occupy his attention. The regular voice countdown is shown to be least accurate in defining the switching time, providing a mean delay of approximately -0.09 second (actually a stimulus anticipation) and a standard deviation of a bit more than 0.2 second. In each of the other cases, a mean delay of approximately 0.25 second and a standard deviation of approximately 0.09 second were obtained. This compares favorably with previous experimental results.     

层板椭圆孔自由边缘效应

 复合材料层板的直边和圆孔自由边缘效应的三维应力分析,国内外已有不少的数值解和近似解析解。Rybicki等提出了各向异性板椭圆孔2维问题变换为圆孔问题的方法,本文论证了这种变换方法的3维情形,从而可根据圆孔自由边缘效应结果来估计椭圆孔自由边缘效应。     

Composite control method for stabilizing spacecraft attitude in terms of Rodrigues parameters

In this paper, the attitude stabilization problem of a rigid spacecraft described by Rodrigues parameters is investigated via a composite control strategy, which combines a feedback control law designed by a finite time control technique with a feedforward compensator based on a linear disturbance observer (DOB) method. By choosing a suitable coordinate transformation, the spacecraft dynamics can be divided into three second-order subsystems. Each subsystem includes a certain part and an uncertain part. By using the finite time control technique, a continuous finite time controller is designed for the certain part. The uncertain part is considered to be a lumped disturbance, which is estimated by a DOB, and a corresponding feedforward design is then implemented to compensate the disturbance. Simulation results are employed to confirm the effectiveness of the proposed approach.     

受均匀内压作用的偏置孔边径向裂纹的应力强度因子的一种求解方法

本文利用一种新的混合法——光弹性实验与权函数解法相结合求解了孔壁受均匀内压作用偏置圆孔边径向裂纹的应力强度因子,该方法具有简单、经济、精度高等优点,对分析复杂应力场中圆孔边穿透裂纹问题,该方法同样适用,且优点更为突出.     

Attitude control of a satellite with redundant thrusters

Redundant thrusters are generally used for a reliable attitude control system. Also, redundant thrusters yield a better performance if they are used appropriately. In this paper, the authors propose an efficient redundancy management algorithm to reduce the fuel consumption. The algorithm is based on a linear programming problem which is a constrained optimization problem. For the algorithm, a cost function is defined as a quantity related to the fuel consumption for a maneuver. The independent variables are the thrusters' on-times which are control input variables of a satellite dynamic model. The advantage of the proposed method is verified by numerical examples. The examples show that the proposed method consumes less fuel than an existing method for a given maneuvering command. A sub-optimal algorithm is also discussed for an onboard computation. The proposed algorithm is applied to two maneuvers: move-to-rest and rest-to-rest. This is verified by a numerical simulation.     

机载电子系统设备的智能故障诊断系统设计

探讨了动态机载电子设备智能故障诊断系统建设的主要问题,设计了基于现代无线通信网络的智能故障预测诊断系统的总体结构及解决方案,对其中的关键技术进行了论述,尤其是无线通信协议、机载电子设备的故障预测模型及智能故障诊断专家系统等,为该系统后期研发奠定了基础.     

云纹方法中一种新的试件栅拷贝技术

 本文介绍了一种新的试件栅拷贝技术,结合空间虑波,条纹倍增及光学图像处理技术,可以测定轴、旋翼、柱壳及锥壳等曲表面裂纹尖端附近弹塑性应变场。该方法甚至还可以适用于转动的轴、飞轮和旋翼等表面应变场的测量。     

The Measurement of Echo Direction in a Phased-Array Radar

For a planar-array antenna with a monopulse feed horn, this study describes a simple algorithm for the determination of the direction of target echoes. Antenna pattern measurements of the array indicate that the direction sines of a received wavefront can be independently obtained with one simple relation between a normalized difference channel output and a direction sine. This paper determines the accuracy of the algorithm.     

State Estimation and Divergence Analysis

A growing memory discrete dynamic model for performing temporal extrapolations along a predetermined path in a random field is presented. This dynamic model is used to drive a linear system that is itself driven by discrete white noise. The coupled system is used to derive a state estimation scheme that recursively processes noisy measurements of the system. In addition, using the aforementioned dynamic model as a reference (truth) model, the authors develop a covariance analysis to measure the estimation errors that occur when the dynamics along the path through the field are modeled as a Markov linear model and state estimation is performed using discrete Kalman filtering. The performance evaluation of an inertial navigation system influenced by the Earth's gravity field aboard a maneuvering ship is provided as a specific illustrative example.     

A comparative study on acoustic damping induced by half-wave, quarter-wave, and Helmholtz resonators

The damping characteristics of three-type resonators, a half-wave, a quarter-wave, and a Helmholtz resonator are studied experimentally by adopting linear acoustic test. A quantitative acoustic property of sound absorption coefficient in a model enclosure with the resonators is measured and thereby, the acoustic-damping capacity of a resonator is characterized. For a comparative study on acoustic damping, the damping capacity of a half-wave resonator is compared with that of the other resonators. A half-wave and a quarter-wave resonators have the same damping mechanism, but a quarter-wave resonator has much larger damping capacity than a half-wave resonator with the same diameter of a single resonator. It is found that shorter length of a resonator has the advantage of longer one with respect to the damping capacity. The damping capacity of a Helmholtz resonator increases with cavity volume and does as the orifice length decreases. A Helmholtz resonator has the highest damping capacity of three-type resonators and a half-wave resonator has the lowest. Besides, a Helmholtz resonator requires the smallest number of resonators for optimal damping. The design criterion of each resonator on the optimal damping is provided by the normalized parameter of open-area ratio and the similarity behavior for the optimal damping is observed for various enclosure diameters.     

Measurement of Distributed Targets with the Random Signal Radar

A model of a distributed target as a collection of independent, Poisson distributed point scatterers or scattering centers in a range-velocity target space is introduced and is characterized by a deterministic function called the ?scatterer density function.? This function is the density of the point scatterers in the range-velocity space and can be estimated in a relatively straightforward manner by any radar having adequate resolution in both range and velocity and no ambiguities in the region occupied by the distributed target. The use of the random signal radar with a correlator receiver is considered here and the statistical properties of the correlator output, when the return signal is from a distributed target, are derived. It is shown that the spectral density is simply related to the scatterer density function. The technique is illustrated by an example in which the target is a tornado modeled as a cylinder with constant angular velocity. The example suggests that is a possible to remotely estimate the radar cross section per unit volume as a function of distance from the center of the tornado.     

雷击建筑物时防雷系统中雷电流的分布研究

主要讨论雷直击建筑物时雷电流在防雷系统中的分布特性，介绍利用计算机进行数值计算的方法。通过典型算例、传统的电磁暂态计算程序——EMTP的计算结果和利用清华大学高压实验室的冲击大电流发生装置，对此结构模型进行模拟试验，将3种结果进行比较，从而验证了本研究所编制的计算机程序的正确性。为进一步研究室内电磁场的暂态分析做好基础。     

大小叶片轴流级反问题设计及数值模拟

 在常规轴流级流线曲率法通流设计和任意中弧线叶型造型方法的基础上,引入了适合于大小叶片的当量扩散因子叶型损失模型,发展了用Miller-Lewis-Hartmann(M-L-H)模型分别计算大叶片和小叶片激波损失的复合激波模型,制定了大小叶片装配方法,建立了大小叶片通流反问题设计系统。用该系统对某级增压比为2.20的单级高负荷后掠风扇进行了后掠和前掠大小叶片改型设计。经计算流体力学(CFD)检验,维持后掠造型的改型,在不提高设计点增压比的条件下,级绝热效率相当,流量和失速裕度都得到了提高;而大小叶片结合前掠的改型,当考虑单排静子的最大载荷将设计级增压比提高至2.31时,级绝热效率略微降低约0.3%,流量略减,失速裕度则显著提高。算例也表明通流反问题设计系统适合于大小叶片轴流级的设计。