Clutter Performance of Coherent Pulse Trains for Targets with Range Acceleration

The clutter performance of coherent pulse trains is examined when the duration of the pulse train is increased to values for which range acceleration effects must be taken into account. The problem of target detection against a clutter background with differential Doppler is studied in terms of the range acceleration effects on the conventional Doppler response. Specifically considered are the consequences on the sidelobe level and width of the main Doppler lobe. The analysis shows that the sidelobe level remains essentially unchanged when the range acceleration mismatch becomes significant. However, the main Doppler response broadens in proportion to the magnitude of the acceleration mismatch. Thus, an increase of the signal duration for better Doppler resolution is useful only until acceleration effects spread the Doppler spectrum of the clutter and eliminate the differential Doppler between targets and clutter.     

Resolution in Doppler and Acceleration with Coherent Pulse Trains

The resolution properties and clutter performance of a simultaneous Doppler and acceleration measurement are investigated in detail with particular emphasis given to coherent pulse trains. The analysis is based on the concept of a matched-filter receiver, although receiver weighting of the type that reduces Doppler sidelobes is also analyzed in detail. Near the main lobe of the acceleration response is a pedestal-ike sidelobe region, the height of which is about 1/N of the main response lobe power where N is the number of pulses in the train. The extent of this pedestal along the acceleration axis is proportional to N. The acceleration measurement in a clutter environment is best performed when both targets and clutter are confined to this pedestal region, since some response sidelobes outside of this region are extremely large.     

Clutter Suppression by Complex Weighting of Coherent Pulse Trains

Uniform coherent pulse trains offer a practical solution to the problem of designing a radar signal possessing both high range and range-rate resolution. The Doppler sensitivity provides some rejection of off-Doppler (clutter) returns in the matched filter receiver. This paper considers the use of a processor in which members of the received pulse train are selectively weighted in amplitude and phase to improve clutter suppression. The techniques described are particularly suitable for rejecting interference entering the processor through ambiguous responses (range sidelobes) of the signal. The complex weights which are derived are optimum in the sense that they produce the maximum clutter suppression for a given detection efficiency. In determining these weights, it is assumed that the distribution of clutter in range and range rate relative to targets of interest is known. Thus, clutter suppression is achieved by reducing the sidelobe levels in specified regions of the receiver response. These techniques are directly applicable to array antennas; the analogous antenna problem would be to reduce sidelobe levels in a particular sector while preserving gain. Complex weighting is most successful when the clutter is limited in both range and velocity.     

Optimum Processing of Unequally Spaced Radar Pulse Trains for Clutter Rejection

A train of radar pulses from one resolution cell can be processed coherently to reject echoes from external clutter and detect targets moving radially with respect to the clutter. Optimum methods of signal processing are defined for systems in which the interpulse spacings are multiply staggered to avoid target blind speeds. Likelihood ratio tests are developed for systems in which the target Doppler frequency is known a priori and for systems employing a bank of filters to cover the target Doppler band. To implement such tests, the N pulses in the train are added with complex weights and the amplitude of the sum compared with a detection threshold. The set of weights which maximizes the average signal-to-clutter ratio is also computed for a single-filter system with unknown target Doppler frequency. When the clutter autocorrelation function is exponential, the clutter covariance matrix can be inverted analytically. This latter result is useful for comparing different interpulse-spacing codes for a particular system application.     

Radar/Sonar Signal Design for Bounded Doppler Shifts

In many detection and estimation problems, Doppler frequency shifts are bounded. For clutter or multipath that is uniformly distributed in range and symmetrically distributed in Doppler shift relative to the signal, detectability of a point target or a communication signal is improved by minimizing the weighted volume of the magnitude-squared autoambiguity function. When clutter Doppler shifts are bounded, this volume is in a strip containing the range axis on the range-Doppler plane. For scattering function estimation, e.g., for weather radar, Doppler flow meters, and distributed target classifiers, it is again relevant to minimize ambiguity volume in a strip. Strip volume is minimized by using a pulse train, but such a signal has unacceptably large range sidelobes for most applications. Other waveforms that have relatively small sidelobe level within a strip on the range-Doppler plane, as well as small ambiguity volume in the strip, are obtained. The waveforms are composed of pulse pairs that are phase modulated with Golay complementary codes.     

Clutter Suppression Properties of Weighted Pulse Trains

A common but troublesome requirement on radar sensors is the detection of a target in the interference from undesired scatterers, or clutter. Systems with coherent processing of pulse trains are uniquely suited for the purpose because, with pulse trains, it is possible to concentrate the receiver output for particular values of Doppler and thus suppress the clutter by Doppler filtering. This paper discusses to what degree the effectiveness of the method can be enhanced by tapering, or weighting, of the pulse amplitudes. The general results are illustrated by computer-plotted response functions for weighted pulse trains. The clutter suppression efficiency of weighting is calculated both for unilateral weighting in the receiver and for bilateral weighting in both receiver and transmitter. The significance of additional phase weighting is discussed and the results for pure amplitude weighting are compared with publishedwork on phase and amplitude weighting.     

高信噪比、高分辨宽测绘带成像

针对传统高分辨和宽测绘带以及高信噪比和宽测绘带之间的矛盾,提出一种基于脉内扫描面阵合成孔径雷达(SAR)系统的二维空域联合处理算法实现高信噪比、高分辨宽测绘带成像。文中首先建立脉内扫描面阵SAR系统模型,该系统采用低脉冲重复频率(PRF)获得宽测绘带信息,同时利用脉内扫描方式获得高信噪比的回波信号。对于低PRF采样宽多普勒谱(对应方位高分辨)引起的多普勒模糊以及脉内扫描引起的距离模糊,提出一种二维空域联合处理算法解距离和多普勒模糊,并且详细地分析了地形高度变化对解模糊算法的影响。最后,通过仿真实验验证了本文算法的有效性。     

Ambiguity resolution of multiple targets using pulse-Dopplerwaveforms

To cancel clutter, both medium-PRF waveforms which are ambiguous in both range and Doppler and high-PRF waveforms which are ambiguous in range but unambiguous in ambiguities, a previous paper has shown that superior results for a single target can be achieved by using a clustering algorithm. Here, the problem of multiple targets is considered. A maximum likelihood (ML) technique which incorporates the clustering algorithm is developed for the multiple target problem. Simulation results show that four targets which have the same speed but are at different ranges can be resolved by using a medium-PRF waveform and employing the ML resolution technique     

A Technique for Improving the Clutter Performance of Coherent Pulse Train Signals

The clutter performance of a radar using coherent pulse train signls depends upon the phase and amplitude weighting used on transmit and receive. This paper describes an iterative technique to determine better weightings. Each iteration improves the signal-to-interference ratio, where the interference is the sum of the mean square noise voltage and the mean square clutter voltage at the time of peak signal. Two examples are presented to illustrate the method and to demonstrate that in many cases the procedure will yield weightings that may be used in a system where the transmitter permits no amplitude weighting.     

Doppler ambiguity resolution using multiple PRF

An algorithm for velocity ambiguity resolution in coherent pulsed Doppler radar using multiple pulse repetition frequencies (PRF) is presented. It relies on the choice of particular values for the PRFs. The folded frequency of the target signal is obtained by averaging the folded frequency estimates for each PRF, and a quasi maximum likelihood criterion is maximized for ambiguity order estimation. The fast implementation of this nonambiguous estimation procedure is based on the fast Fourier transform (FFT), The proposed waveform allows full exploitation of any (even) number of PRFs, which appears to be important for estimation improvement. The effects of the waveform parameters and the folded frequency estimation variance on the performance of the ambiguity order estimation procedure are evaluated theoretically and through computer simulations. Mean square error (MSE) curves are given to assess the Doppler frequency estimation accuracy. Finally, the new method is compared with a classical technique and the implementation of the algorithm in a clutter environment is addressed.     

Dispersion Effects in a Circular Phased Array

The dispersion effects that are produced when wideband linear frequency modulation (FM) signals are transmitted through a circular phased array are considered for both one-way and two-way transmissions through the array. The distortions resulting at the output of a matched fi'lter which is matched to the undistorted linear FM signal are studied. These distortions are 1) loss in peak pulse amplitude, 2) widening of the pulse, and 3) reduction in sidelobe level.     

A Generalized Clutter Computation Procedure for Airborne Pulse Doppler Radars

A general procedure for analyzing ground clutter effects in airborne pulse Doppler radars is described. The quantity computed is the expected clutter power at the output of any specified range gate/ Doppler filter processing cell. The procedure has been computerized and is quite general with respect to antenna gain pattern, clutter cross section variation, PRF, pulse and range gate shapes, and the various receiver processing functions. It is applicable only to distributed ground clutter and linear processing, and excludes the dynamic effects of continuous antenna scanning. To exemplify the use of the procedure, two studies conducted for a postulated high PRF radar are described, and the results are presented.     

Super resolution feature extraction of moving targets

High range resolution (HRR) moving target indicator (MTI) is becoming increasingly important for many military and civilian applications such as the detection and classification of moving targets in strong clutter background. We consider the problem of extracting the HRR features of moving targets with very closely spaced scatterers in the presence of strong stationary clutter, where the range migration and Doppler frequency are taken into account. A relaxation-based algorithm, which is robust and computationally simple, is proposed to deal with the above problem. Numerical results have shown that the proposed algorithm exhibits super resolution and excellent estimation performance     

Ambiguities in Spacebornene Synthetic Aperture Radar Systems

Several aspects of range and azimuth (time delay and Doppler) ambiguities in spaceborne synthetic aperture radars (SARs) are examined. An accurate method to evaluate the ratio of the intensities of the ambiguities to that of the signal is described. This method has been applied to the nominal SAR system on SEASAT and the variations of this ratio as a function of orbital latitude and attitude control error are discussed. It is also shown that the detailed range migration-azimuth phase history of an ambiguity is different from that of a signal. The images of ambiguities are, therefore, dispersed. Several examples of such dispersed images observed by the SEASAT SAR are presented. These dispersions are eliminated when the processing parameters are adjusted appropriately. Finally, a method is described which uses a set of multiple pulse repetition frequencies to determine the absolute values of the Doppler centroid frequencies for SARs with high carrier frequencies and relatively poor attitude measurements.     

Robust space-time adaptive processing for airborne radar in nonhomogeneous clutter environments

Space-time adaptive processing (STAP) holds tremendous potential for the new generation airborne surveillance radar, in which the phased array antennas and pulse Doppler processing mode are adopted. A new STAP approach using the multiple-beam and multiple Doppler channels is presented here for airborne phased array radar. The approach with space-time multiple-beam (STMB) architecture is robust to array errors and has very low system degrees of freedom (DOFs). Hence, it has low sample support requirement and it is very suitable for the practical planar phased array radar under nonhomogeneous clutter environments. Meanwhile, a new nonhomogeneous detector (NHD) based on the correlation dimension (CD) is also proposed here, which is used as an effective method to screen tracing data prior to detection processing. It can further improve the performance of the STAP approach in the severely nonhomogeneous clutter environments. Therefore, a scheme that incorporates the correlation dimension nonhomogeneity detector (CD-NHD) with the STMB is recommended, which we term CD-NHD-STMB. The experimental simulation results indicate that: 1) the STMB processor is robust to array element error and has high performance under nonhomogeneous clutter environments; 2) the CD-NHD is also effective on the nonhomogeneous clutter. As a result, the CD-NHD-STMB scheme is robust to array element error and nonhomogeneous clutter, and therefore available for airborne phased array radar applications.     

Near-Field Analysis of Helicopter Rotating Blades Modulation Interference

A near-field analysis is carried out to obtain the level of modulation interference due to rotating blades in a helicopter-borne pulse Doppler radar system. The interference power spectra are calculated for different values of antenna depression angle and helicopter (radar) speed at a constant helicopter altitude of 300 m. Numerical results for the case of 1 kW radiated power show that blade interference level is about 5 to 8 dBW/Hz less than that of the direct ground clutter in the clutter region. It extends, however, into the clutter-free region which may cause false alarms and degradation of the radar performance.     

Properties of Staggered PRF Radar Spectral Components

Expressions for moving target indicator (MTI) improvement factor limitation due to pulse repetition frequency (PRF) staggering and loss of target detectability for various values of Doppler frequency in the passband are presented. It is also shown that the product of variance of stagger periods and clutter variance is an important parameter determining the performance of a staggered PRF MTI radar.     

Rotating Blades Radio Interference in a Helicopter-Borne CW Doppler Radar

Radio interference generated in a helicopter-borne continuous wave (CW) Doppler radar system due to the rotating blades is analyzed. This problem has been previously treated for the case of pulse Doppler radar systems with very narrow (near zero) beamwidth. In this case the strong interference component returning directly from the blades (with no ground reflection) need not be considered as it reaches the receiver when it is still blinded. In the case of a CW Doppler radar, however, this interference component must be included. Numerical calculations show that the total blade interference power level, dominated by the direct component, is higher than that of the direct ground clutter in the radar clutter region. It decreases approximately as (f - fo)-4 in the radar clear region. It stays, however, well above the thermal noise level which might cause false alarm and degrade the radar performance.     

Radar Waveforms for Suppression of Extended Clutter

A common problem in waveform design is to adapt the transmitted signal to the target environment in order that the interference from extended fields of scatterers is reduced. This problem is investigated here for the special case of detection of a single target in the ``vicinity' of an extended clutter space. The paper considers the possibility of confining the matched-filter response in delay and Doppler, or ambiguity function, to a narrow strip with arbitrary orientation in the delay-Doppler plane. It is shown that strict confinement of the response is achievable only with waveforms that are unlimited in both time and frequency domain. With practical waveforms, which are necessarily of finite extent, one merely can trade close-target separability against detectability in the background clutter. Thus, one form of the resolution problem is exchanged against the other. The paper examines these effects quantitatively.