共查询到18条相似文献,搜索用时 140 毫秒
1.
直升机悬停控制系统鲁棒控制器的设计研究 总被引:1,自引:0,他引:1
针对直升机悬停时参数的变化,提出一种在直升机悬停系统原速度回路基础上增加鲁棒控制器的控制方案。给出了设计方法;仿真结果表明这种方案的可行性。 相似文献
2.
直升机/涡轴发动机综合系统鲁棒抗扰控制设计 总被引:4,自引:0,他引:4
提出了一种直升机/涡轴发动机综合系统鲁棒抗扰控制方法。分别设计了基于线性矩阵不等式(LMI)的鲁棒保性能控制的直升机四通道多变量控制器和涡轴发动机转速控制器;为了进一步提高发动机自由涡轮转速环的抗扰能力,结合自抗扰控制(ADRC)方法,构建了涡轴发动机转速鲁棒保性能控制+扭矩ADRC补偿的控制方案,充分利用了ADRC控制强的干扰补偿能力,避免了鲁棒设计方法的保守性。在UH-60直升机/涡轴发动机综合模型仿真环境下通过模拟直升机大幅急速升降操作,验证了直升机/涡轴发动机综合系统所采用的鲁棒抗扰控制,尤其是涡轴发动机鲁棒自抗扰控制,具有理想的抗扰控制效果,能够抑制直升机机动操作过程中大的扭矩扰动对涡轴发动机造成的不利影响,从而使直升机具有更好的机动能力。 相似文献
3.
基于遗传算法的直升机鲁棒飞行控制器设计 总被引:3,自引:1,他引:3
以旋翼机驾驶品质要求 ADS-33为设计目标,采用 H∞ 混合灵敏度方法设计直升机在低速飞行时的鲁棒控制器,设计中利用遗传算法优化加权阵参数,找到同时满足频域和时域性能要求的控制器。以 UH-60 A直升机为对象,所设计的直升机飞行控制系统不仅具有鲁棒稳定性,而且满足 ADS-33D水平 1操纵品质要求。 相似文献
4.
5.
研究了多变量鲁棒PI控制器实现系统稳定的设计方法,给出了鲁棒PI控制器存在的必要条件,并对PI控制器实现系统静态解耦进行了讨论。用该方法对某直升机飞行控制系统进行设计,给出了仿真结果 相似文献
6.
以某型直升机横航向通道为对象,将H^∞控制理论与计算方法引入直升机飞行控制系统设计中。通过对灵敏度函数和补偿灵敏度函数频率特性的回路整形,设计出有较强抗干扰能力和较好鲁棒稳定性的直升机H^∞控制系统。仿真计算表明,具有H^∞控制器的直升机横航向姿态保持系统,其指令跟踪和鲁棒稳定都性都有了明显的改善。 相似文献
7.
8.
9.
系统参数发生跳变时,为了解决多变量系统暂态响应变差的问题,提出一种基于多模型切换的鲁棒自适应控制器。该控制器由多个鲁棒自适应控制器组成,鲁棒自适应控制器保证系统存在未建模动态时能够使自适应系统稳定运行,引入的多模型策略保证系统参数跳变时具有良好的暂态性能。仿真结果表明,所提出的多模型鲁棒自适应控制器能够加快系统的响应速度,提高系统的暂态性能。 相似文献
10.
11.
A new hybrid control scheme is presented with a robust multiple model fusion control(RMMFC) law for a UH-60 helicopter and an active disturbance rejection control(ADRC) controller for its engines.This scheme is a control design method with every subsystem designed separately but fully considering the couplings between them.With three subspaces with respect to forward flight velocity,a RMMFC is proposed to devise a four-loop reference signal tracing control for the helicopter,which escapes the closed-loop system from unstable state due to the extreme complexity of this integrated nonlinear system.The engines are controlled by the proposed ADRC decoupling controller,which fully takes advantage of a good compensation ability for unmodeled dynamics and extra disturbances,so as to compensate torque disturbance in power turbine speed loop.By simulating a forward acceleration flight task,the RMMFC for the helicopter is validated.It is apparent that the integrated helicopter and engine system(IHES) has much better dynamic performance under the new control scheme.Especially in the switching process,the large transient is significantly weakened,and smooth transition among candidate controllers is achieved.Over the entire simulation task,the droop of power turbine speed with the proposed ADRC controller is significantly slighter than with the conventional PID controller,and the response time of the former is much faster than the latter.By simulating a rapid climb and descent flight task,the results also show the feasibility for the application of the proposed multiple model fusion control.Although there is aggressive power demand in this maneuver,the droop of power turbine speed with an ADRC controller is smaller than using a PID controller.The control performance for helicopter and engine is enhanced by adopting this hybrid control scheme,and simulation results in other envelope state give proofs of robustness for this new scheme. 相似文献
12.
应用基于Lyapunov直接法的非线性不确定系统鲁棒控制方法,为某型直升机垂直飞行模态设计了鲁棒控制律,该控制律能保证闭环系统具有全局稳定性。为验证所设计鲁棒控制律的有效性,对直机机垂直飞行的三 机动:设定点悬停、起飞着陆机和忽上忽下机动,分别进行了闭环系统仿真。仿真结果表明,所设计的控制律对系统参数的摄动具有很强的鲁棒性。 相似文献
13.
本文提出一种改进自动驾驶仪性能的方案。在导弹自动驾驶仪原回路的基础上增加Robust控制器,这种方案可提高驾驶仪对参数变化的Robust性能。本文详细叙述了Robust控制器结合自动驾驶仪的设计方法,并用仿真结果说明了Robust控制器在本算例中所起的作用。 相似文献
14.
15.
准确计算直升机的悬停升限依赖于诸如桨尖损失系数,非均匀旋翼诱导速度分布,旋翼下洗引起的直升机增重效应及发动机与旋翼之间的功率传递系数等气动参数的准确度。然而,由于复杂的旋翼空气动力现象,准确预估以上气动参数有较大难度。本文提出了一种确定直升机垂直飞行状态上述气动参数的方法,该方法通过建立直升机垂直飞行状态的运动方程,实测直升机垂直飞行时的相关信息,采用参数辨识的方法得到直升机垂直飞行时的气动参数,然后,利用辨识结果确定直升机的悬停升限。结果表明该方法能有效地确定直升机垂直飞行时的气动参数及相应的悬停升限,且具有飞行试验简便,不受直升机装载和外界环境条件变化限制的特点。 相似文献
16.
提出了一种改进的无人直升机H∞回路成形鲁棒控制器设计方法。首先将系统辨识技术引入到无人直升机高带宽控制器设计,根据飞行扫频数据,得到包含直升机动力学模型耦合特性的非参数频率响应,依据频率响应拟合待辨识模型得到无人直升机高精度的飞行动力学模型。然后根据该模型,采用改进的H∞回路成形方法设计了无人直升机内回路控制器,针对H∞回路成形方法中权值矩阵选取困难的问题,利用了最大右约数(GCRD)方法以实现实际系统和期望系统的传递函数矩阵之间的转换。与传统的对角型权值矩阵相比,使用此方法成形后的系统具有更宽的鲁棒稳定裕度,系统的解耦性和频带也显著提高,而且可以大大降低设计人员选取权值矩阵的复杂性和盲目性。通过仿真验证,所设计的无人直升机系统的飞行品质满足军用标准ADS-33E中一级区域的要求。 相似文献
17.
It is important to quickly predict the hover performance of main and tail rotors with sufficient precision for helicopter design. To investigate the effects of swirl velocities on the hover performance of main and tail rotors, and give a better prediction for the hover performance, a flight performance model was derived and a swirl velocity model was coupled into it. The test data of the UH-60A helicopter were used for validation. When the blade loading coefficient of the main rotor was higher than 005, the effects of the swirl velocities on the main rotor power became significant. The swirl velocities increased the profile torque of the main rotor. The increased torque required the tail rotor to produce more thrust with more power consumption. At a higher blade loading coefficient of the main rotor of 012, the swirl velocities increased the main rotor power, tail rotor power and total power by 380%, 524% and 508%, respectively. The profile power increase of the main rotor caused by the profile swirl velocity was less than that of the induced swirl velocity, but the power increase was higher at high rotor blade loadings. Considering the swirl velocities in the main rotor can improve the prediction precision of the hover performance, especially at high blade loadings 相似文献