M-correlated sweeps performance analysis of mean-level CFARprocessors in multiple target environments

This paper is devoted to the detection performance evaluation of the mean-level (ML) constant false-alarm rate (CFAR) detectors processing M-correlated sweeps in the presence of interfering targets. The consecutive pulses are assumed to be fluctuating according to the Swerling I model. Exact expressions are derived for the detection probability of the conventional mean-level detector (MLD) and its modified versions under Rayleigh fluctuating target model. Performance for independent sweeps can be easily obtained by setting the sweep-to-sweep correlation coefficient equal to zero. Results are obtained for both homogeneous and nonhomogeneous background environments. It is shown that for fixed M, the relative improvement over the single sweep case increases as the correlation between sweeps decreases. For the same parameter values, the minimum MLD has the best performance in the presence of extraneous target returns among the reference noise samples     

Detection of Slow Fluctuating Targets with Frequency Diversity Channels

In this paper an exact closed-form expression for the radar detection probability is derived and results are plotted for a frequency diversity radar receiver. The receiver model performs post-detection integration on all received pulses in all diversity channels. The target model assumed is the slow fluctuating Rayleigh-distributed (Swerling case I target) scatterer. Each of the M frequency diverse channels receives N amplitude-correlated returns to give a total of NM post square-law detection integrations. The tabulated data falls between the two extreme cases, that for which all the returns are amplitude-correlated and that for which each return is independent. The plotted results fall close to the figures obtained through simple empirical relationships.     

Sidelobe blanking with integration and target fluctuation

In radar systems, sidelobe blanking (SLB) is used to mitigate impulsive interference that enters the radar through sidelobes of the main antenna. SLB employs an auxiliary antenna channel with the output being compared with that of the main antenna channel and a decision is then made as to whether or not to blank the main channel output. SLB performance determination involves the evaluation of several probability functions. Based on the classical Maisel SLB architecture, this work extends previous performance results, in which detection was limited to the case of a single radar pulse with either Marcum or Swerling I target fluctuation. Probability expressions have been generalized to include both an arbitrary number of integrated pulses and target fluctuation models based on the gamma distribution. The Swerling fluctuation models are all special cases of the gamma distribution. Results are derived in terms of two generalized probability functions, one for detection and the other for blanking. With these generalized probability functions, the SLB design and performance results can be determined. Examples are presented and discussed.     

Performance Analysis of the Censored Mean-Level Detector

The censored mean-level detector (CMLD) is an alternative to the mean-level detector that achieves robust detection performance in a multiple-target environment by censoring several of the largest samples of the maximum likelihood estimate of the background noise level. Here we derive exact expressions for the probability of detection of the CMLD in a multiple-target environment when a fixed number of Swerling II targets are present. The primary target is modeled by Swerling case II, and only single-pulse processing is analyzed. Optimization of the CMLD parameters is considered, and a comparison to other detectors is presented.     

Adaptive Detection Algorithms for Multiple-Target Situations

The performance of a mean-level detector is considered for the case where one or more interfering target returns are present in the set of cells used in estimating the clutter-plus-noise level. A serious degradation of detection probability is demonstrated for all of the single-pulse Swerling target fluctuation models (i. e., cases 0, 2, and 4). Indeed, for fixed mean radar cross sections of the primary and interfering targets, the probability of detecting the primary target is asymptotic to values significantly less than unity as the signal-to-noise ratios of the returns approach infinity. A class of alternative adaptive detection procedures is proposed and analyzed. These procedures, based on ranking and censoring techniques, maintain acceptable performance in the presence of interfering targets, and require only a minor addition in hardware to a conventional mean-level detector.     

Adaptive Detection Probabilities for Fluctuating Target Models in Nonhomogeneous Gaussian Noise

Under the assumption that the average noise power may vary from cell to cell, new, more easily computed expressions are given for the probability of detecting a fluctuating target by means of a cell-averaging CFAR test. The generalized chi-square family of fluctuating targets is considered with the Swerling I and III models given as special cases.     

Fluctuating Target Detection in Clutter Using Sidelobe Blanking Logic

In an earlier paper, Maisel [6] considered two-channel detection systems using a sidelobe blanking logic when a nonfluctuating target was present. This paper is an extension of the earlier work to include fluctuating targets. The Swerling I, II, III, and IV models are considered when single-pulse detection is of interest. An adaptive threshold procedure is also briefly discussed whereby the probability of false alarm at any given resolution cell is maintained constant, even though the input clutter level may vary from cell to cell or from beam position to beam position. Useful data are presented for detection probabilities in the range 0.5 to 0.9, for false alarm probabilities in the range 104 to 10-8, and for a false detection probability of 0.1 for a sidelobe target yielding an apparent signal to total noise power density ratio of 13.0 dB in the main beam receiver.     

A Simple Formula for Radar Detection Probability on Swerling I Targets

A formula is presented for the detection probability on a single scan of a Swerling I target. The formula does not use the Gaussian probability function and is accurate to 1.5 dB for the integration between 10 to 1000 pulses and for false alarm probabilities between 0.693 × 10-3 and 0.693 × 10-6.     

Constant-False-Alarm-Rate Signal Processors for Several Types of Interference

Distribution-free methods and maximum-likelihood estimation technique have been previously suggested for constant-false-alarm-rate (CFAR) processors. The first technique assumes no a priori environmental knowledge and the second assumes almost complete environmental knowledge. Several intermediate environmental assumptions are considered. The performance of single-pulse transmission signal processors that produce CFAR for the different environments is analyzed. Probability of target detection is evaluated for Rayleigh interference and Swerling I target. It is shown that adaptive threshold techniques implemented by logarithmic amplifiers, instead of linear amplifiers, can attain better false-alarm-rate control with only small loss in target detectability.     

Calculation of Probability of Detection with Target Scintillation

This paper presents a computational method for the calculation of probability of detection using measured radar target cross-section data. The described method can also be used for probability of detection calculations when the radar target cross section follows a specified probability density function. Using the computational procedure of the paper, a number of curves are generated which can be used for probability of detection calculations with exponential and Gaussian radar target cross-section distributions. The results obtained using theoretical distributions are compared with the corresponding results using actual target cross-section measurements. The results of computer runs are compared to the corresponding values in the literature where available.     

Probability of Detecting a Fluctuating Target Immersed in Both Noise and Clutter

The probability of detecting either a Swerling 1 or Swerling 2 target immersed in both Rayleigh-distributed noise and log-normally distributed clutter is calculated. Results are presented which demonstrate the effect of noise-to-clutter ratio, signal-to-noise ratio, and number of pulses integrated on the detection statistics.     

针对雷达LPI波形验证的目标RCS估算

根据某型雷达低截获概率波形设计的需要,分析了雷达探测目标的高频散射机理,并运用物理光学法、等效电磁流法计算了约定目标在不同姿态下和不同电磁波频率照射下的RCS值,从而为验证雷达波形在能探测到目标情况下的LPI性能提供了支撑。实验结果表明,基于电磁场理论的目标RCS估算方法是研究雷达LPI波形的一种有效工具,方法也适合于其他领域RCS估算的需要。     

OS-CFAR theory for multiple targets and nonuniform clutter

The performance of a cell averaging constant false-alarm rate (CA-CFAR) detector degrades rapidly in nonideal conditions caused by multiple targets and nonuniform clutter. The ordered-statistic CFAR (OS-CFAR) is an alternative to the CA-CFAR. The OS-CFAR trades a small loss in detection performance relative to the CA-CFAR in ideal conditions for much less performance degradation in nonideal conditions. A formula is given for the detection probability of the OS-CFAR when there are multiple Swerling I targets in the CFAR window, and a formula is given for the probability of false alarm in nonuniform Raleigh clutter     

Distributed CFAR detection in homogeneous and nonhomogeneousbackgrounds

The performance of distributed constant false alarm rate (CFAR) detection with data fusion both in homogeneous and nonhomogeneous Gaussian backgrounds is analyzed. The ordered statistics (OS) CFAR detectors are employed as local detectors. With a Swerling type I target model, in the homogeneous background, the global probability of detection for a given fixed global probability of false alarm is maximized by optimizing both the threshold multipliers and the order numbers of the local OS-CFAR detectors. In the nonhomogeneous background with multiple targets or clutter edges, the performance of the detection system is analyzed and its performance is compared with the performance of the distributed cell-averaging (CA) CFAR detection system     

Performance analysis of linearly combined order statistic CFARdetectors

Linearly combined order statistic (LCOS) constant false-alarm rate (CFAR) detectors are examined for efficient and robust threshold estimation applied to exponentially distributed background observations for improved detection. Two optimization philosophies have been employed to determine the weighting coefficients of the order statistics. The first method optimizes the coefficients to obtain efficient estimates of clutter referred to the censored maximum likelihood (CML) and best linear unbiased (BLU) CFAR detectors. The second optimization involves maximizing the probability of detection under Swerling II targets and is referred to as the most powerful linear (MPL) CFAR detector. The BLU-CFAR detector assumes no knowledge of the target distribution in contrast to the MPL-CFAR detector which requires partial knowledge of the target distribution. The design of these CFAR detectors and the probability of detection performance are mathematically analyzed for background observations having homogeneous and heterogeneous distributions wherein the trade-offs between robustness and detection performance are illustrated     

Loss in Single-Channel MTI with Post-Detection Integration

The detection performance of a single-channel MTI receiver with post-detection integration, for a Swerling I target, has been evaluated by a Monte Carlo simulation. It is shown that a fairly good approximation is obtained by applying the ?effective number of independent integrated samples? to the standard detection curves. The ?I-only? loss is about 2 dB for integration of more than 20 pulses; thus this receiver is acceptable if implementation constraints dictate it.     

Impact of target RCS fluctuations on radar measurement accuracy

The impact of target radar cross section (RCS) fluctuations on the thermal noise limited accuracy of radar measurements of range, range rate, and angle is evaluated for Swerling fluctuation models. The impact is expressed as a modification of the large-signal approximation to the standard deviation σ of measurement error     

Performance of a Mean Level Detector Processing M-Correlated Sweeps

The performance of a mean level detector processing M-correlated consecutive sweeps is derived. Performance when sweeps are independent can be obtained simply as a special case. The background noise is assumed stationary Gaussian and pulses are fluctuating according to the Swerling I model. Results are obtained for both finite and infinite reference noise samples. It is shown that for fixed M the relative improvement over the single hit case increases when the correlation between sweeps decreases and as the probability of false alarm is kept at lower rates.     

Recursive Methods for Computing Detection Probabilities

Recursive methods are drived for computing detection probabilities for general fluctuating targets in Gaussian noise. For the generalized chi-square family of fluctuating targets, very simple and convenient recursive algrithms result. The methods are also extended to cell-averaging CFAR. Although the detection probability is expressed iw: terms of an infinite series, a convenient expression is derived for the resulting error when the series is truncated. Cell-averaging CFAR results are computed for nonfluctuating, Swering case I, and Swerling case II fluctuating targets.     

Decentralized CFAR signal detection

The authors develop the theory of CA-CFAR (cell-averaging constant false-alarm rate) detection using multiple sensors and data fusion, where detection decisions are transmitted from each CA-CFAR detector to the data fusion center. The overall decision is obtained at the data fusion center based on some k out of n fusion rule. For a Swerling target model I embedded in white Gaussian noise of unknown level, the authors obtain the optimum threshold multipliers of the individual detectors. At the data fusion center, they derive an expression for the overall probability of detection while the overall probability of false alarm is maintained at the desired value for the given fusion rules. An example is presented showing numerical results