An Lms Adaptive Array Using a Pilot Signal

A least mean square (LMS) adaptive array requires a reference signal. When the desired signal contains a pilot signal, it may be used as the reference signal. In this paper the steady-state performance of an LMS adaptive array in which the pilot signal is used as the reference signal is examined. It is shown that the LMS adaptive array occasionally suppresses the desired signal. The loop gain, which is an important parameter, is also considered.     

The Effect of Integrator Pole Position on the Performance of an Adaptive Array

The LMS adaptive array requires an integrator in each weight feedback control loop. In practice the integrator is often replaced by a low-pass filter, i.e., by a filter with a single pole at s = - ? (where s is complex frequency). The effect of this pole position on array performance is examined. It is shown that to obtain optimal performance from the array, ? must be less than k?2, where k is the loop gain and ?2 is the thermal noise power per element. When at exceeds k?2, the output signal-to-inter ference-plus-noise ratio from the array is degraded for intermediate values of interference power.     

Source localization using a non-cocentered orthogonal loop and dipole （NCOLD） array

A uniform array of scalar-sensors with intersensor spacings over a large aperture size generally offers enhanced resolution and source localization accuracy,but it may also lead to cyclic ambiguity.By exploiting the polarization information of impinging waves,an electromagnetic vector-sensor array outperforms the unpolarized scalar-sensor array in resolving this cyclic ambiguity.However,the electromagnetic vector-sensor array usually consists of cocentered orthogonal loops and dipoles（COLD）,which is easily subjected to mutual coupling across these cocentered dipoles/loops.As a result,the source localization performance of the COLD array may substantially degrade rather than being improved.This paper proposes a new source localization method with a non-cocentered orthogonal loop and dipole（NCOLD）array.The NCOLD array contains only one dipole or loop on each array grid,and the intersensor spacings are larger than a half-wavelength.Therefore,unlike the COLD array,these well separated dipoles/loops minimize the mutual coupling effects and extend the spatial aperture as well.With the NCOLD array,the proposed method can effciently exploit the polarization information to offer high localization precision.     

Loop gain of a spacecraft switched shunt power system

A novel approach of deriving the loop gain of a spacecraft switched shunt power system is presented. The system hardware elements contain both the analog and the digital components. Transfer functions of the analog circuits are easily identified employing the conventional approach. Gain function of the digital block is however conceived following a quite unconventional route. The digital gain is shown to include the effects of comparator thresholds, digital clock, shift register, sinusoidal amplitude, and ac frequency. The dependence of the digital gain on voltage thresholds, clocking period, and the integrational property of threshold comparator is expected. The dependence on sinusoidal amplitude contradicts the traditional concept of small signal analysis. The overall loop gain in the analytic form yields a computational result that matches the actual measurement very well. This fact proves, to some extent, the validity of the digital gain function and the basis of its derivation     

Reference Loop Phase Shift in Adaptive Arrays

Adaptive arrays for use in communication systems require the generation of a so-called reference signal, which is usually derived from the array output. A particular problem associated with this technique, the problem of reference loop phase shift, is discussed. It is shown that phase shift in the reference loop causes the array weights to cycle, and also causes the array to frequency-modulate the signal. In spite of this frequency change, the array maintains a maximum SNR at the output.     

用于非线性有源天线的耦合锁相环特性分析

为实现非线性有源天线阵波束扫描,研究了互耦锁相环(PLL)的基本特性。通过对互耦PLL的相位动力学方程的稳定性进行分析,建立了具有延时的阵列模型;通过调节环路延时,互耦PLL不同的非线性动力学特性;采用四单元的耦合锁相环阵列实验电路对理论分析进行了验证,从而提出了在设计基于耦合锁相环的非线性有源天线时,必须对环路延时进行控制,防止环路出现振荡和混沌现象。     

Two-State Feedback Loop Adaptive Arrays for Pulsed Interference Signals

A two-state feedback loop is presented which increases the effectiveness of an adaptive array in the presence of pulsed interference signals. In the case of the two-state feedback loop, one state permits the maximum adpative response, consistent with the loop stability, and is activated in the presence of an interfering pulse. During the other state, which is activated when the interfering pulse is off, the weights are frozen at the values reached at the end of the last interfering pulse and are maintained until the next disturbance occurs. It is shown that an adaptive array with the proposed two-state loops steers permanent minima in the direction of the interfering signals, irrespective of their duty cycle. The performance of a communication system protected by such an adaptive array improves significantly over one protected by a conventional adaptive array.     

Crossarray Beamforming with a Parametric Receiving Array and a Line Array

A beamforming technique involving cross correlation of the outputs of two directional arrays is investigated. The performance characteristics of the crossarray system are determined and related to the characteristics of the two individual arrays. It is found that the crossarray beam pattern is the average (in decibels) of the beam patterns of the individual arrays, and that the crossarray gain (rejection of spatially distributed noise) is 1.5 dB greater than the average (in decibels) of the individual array gains. The most interesting applications for this system may be those where the two arrays are quite different, as in the case of a parametric acoustic receiving array (PARRAY) and a broadside line array.     

Phased array of large reflectors for deep-space communication

In this paper the problem of uplink array calibration for deep-space communication is considered. A phased array of many modest-size reflectors antennas is used to drastically improve the uplink effective isotropic radiated power of a ground station. A radar calibration procedure for the array phase distribution is presented using a number of in-orbit targets. Design of optimal orbit and the number of calibration targets is investigated for providing frequent calibration opportunities needed for compensating array elements phase center movements as the array tracks a spacecraft. Array far-field focusing based on the near-filed in-orbit (low Earth orbit (LEO)) calibration targets is also presented and array gain degradation analysis based on the position error of the array elements and in-orbit targets has been carried out. It is shown that errors in the in-orbit targets positions significantly degrade the far-field array gain while the errors in array elements positions are not very important. Analysis of phase errors caused by thermal noise, system instability, and atmospheric effects show insignificant array gain degradation by these factors     

Reference Loop Phase Shift in an N-Element Adaptive Array

Adaptive arrays based on the LMS algorithm require the generation of a reference signal which is usually derived from the array output. A particular problem associated with this technique is that of a phase shift in the reference signal loop. The effects of this phase shift on the performance of an N-element adaptive array are discussed. It is shown that a reference loop phase shift causes the array weights to cycle, thereby frequency translating the signals at the output. The weight-cycling frequency is related to various system parameters of an N-element array. In particular, it is observed that the cycling frequency increases as the number of antennas (N) increases.     

一种MIMO雷达幅相误差估计方法

 针对单基地相关多输入多输出(MIMO)雷达中存在的阵列幅相误差问题进行了研究。给出了单基地相关MIMO雷达的阵列模型,并提出了一种MIMO雷达幅相误差估计方法。利用发射正交信号对阵列接收信号进行匹配滤波,可分离得到类似传统阵列的"虚拟阵列",利用分时信源数据将该阵列中真实导向矢量中信源波达方向(DOA)引起的相位与幅相误差分离开,通过构造代价函数得到波达方向估计值,进而分别得到发射阵与接收阵的幅相误差的估计值,同时给出了误差引入量分析。最后通过仿真验证了该方法的有效性。本文介绍的方法简单可行,适用于任意构型MIMO雷达的幅相误差估计。     

Weight Jitter Phenomena in Adaptive Array Control Loops

An analysis of weight jitter in adaptive array control loops is presented. lt is shown that steady state weight jitter and statistical dependence between input signal and weight processes are related factors. A Markov characterization for the first-order adaptive array loop is presented and Fokker-Planck techniques are used to obtain the steady state probability density of the weight process for the case of a one-loop array. From this density the mean and the variance of the weight process are obtained and the dependence of these statistics upon loop and input signal parameters is explored.     

Analysis of a Signal Processor for an Antenna Array

A signal processor that provides ratio-squared predetection combining, has been investigated for application in an adaptive antenna array. The analysis and experimental data presented here pertain to the signal processing gain when the antenna array is illuminated by a coherent signal source and a partially coherent noise source. For a noise source which is coherent, the processing gain depends on relative strength of the signal and noise, relative directions of arrival, and the usual "array factor." The array exhibits capturing effects much as in an FM receiver. The effective antenna pattern is a superposition of two beams of different magnitudes, one directed to the signal source and the other to the noise source. When the noise is partially coherent, the behavior of the signal processor is quite complex. Analytical prediction and experimental simulation measurement on a four-channel system indicate that the partially coherent noise may be regarded as the source of an incoherent noise component plus a coherent noise component with the magnitude of the latter determined by the coherence coefficient for the noise source.     

基于反馈的振荡器注频锁相研究

注频锁相技术是非线性有源阵列天线的关键技术之一,论文提出了一种带反馈的振荡器注频锁相闭环结构。与开环结构相比,该电路能够提高锁频带宽,可用来构成非线性有源天线阵。仿真结果表明该电路相噪低,具有更宽的锁相带宽。     

基于FPGA的数字Costas环的设计与实现

通过对数字Costas环路原理的分析，提出了新的环路鉴相方式，且环路参数可根据锁定情况及时修改，确保锁相环路稳定工作。详细阐述了环路各部件的参数及电路设计。ChipScopePro实时观测FPGA内部信号和Matlab仿真结果表明．该Costas环路具有十分优良的性能。     

Robust model following control of parallel buck converters

A robust model-following (RMF) control technique for average current mode controlled (ACC) parallel buck dc-dc converters, RMFACC, is presented. RMFACC achieves that the loop gain of the voltage loop is little sensitive to the variation of power stage parameters: number of modules, input voltage, load, and component tolerances. The design of the voltage loop is 'decoupled' from the design of the disturbance rejection transfer functions in an important degree, so that the output impedance and audio susceptibility are greatly reduced without the need of high loop gain crossover frequencies. A comparative study between conventional ACC and RMFACC is shown.     

Stability Analysis of a Buck Regulator Employing Input Filter Compensation

The interaction between the input filter and the regulator often causes serious degradation of performance. The reduction in loop gain due to input filter interaction can result in system instability. An exact stability analysis of the buck regulator system is presented. The input filter parameter values are varied and system instability is predicted for the case without feedforward. The eigenvalues of the system can be brought back into the unit circle and the system thus stabilized with the addition of the feedforward loop. Measurements made for the cases with and without feedforward confirm the analytical prediction.     

地空导弹LQG/LTR增益调度自动驾驶仪设计(英文)

采用线性二次高斯/回路传递复现(LQG/LTR)增益调度技术设计地空导弹增益调度自动驾驶仪。为消除传统"试错"设计过程在系统中所引起的人为不确定性,提出一种基于极点配置的目标回路设计方法。此方法提供了由体现性能指标要求的期望极点构造矩阵微分Riccati方程(MDRE)的具体算法。同时,还证明了引入积分环节扩展被控对象动力学,能够有效抑制LQG/LTR增益调度控制器的快模态,从而为LQG/LTR增益调度技术的工程应用扫清了一个障碍。采用所提出的方法设计了地空导弹LQG/LTR增益调度自动驾驶仪。设计及仿真结果表明,控制器的快模态得到了明显抑制,同时,在飞行马赫数和高度变化的情况下,自动驾驶仪具有稳定的动力学特性。     

Measured Gain Improvement Characteristics of a Space Diversity Antenna System

A two-element adaptively phased array withelement gains of 18 dB was assembled andevaluated at 136 MHz. The gain improvementof the system over that of a single element wasmeasured while tracking ATS-C. The measuredgain improvement fell within 0.5 dB ofthe theoretical maximum 90 percent of thetime, corresponding to a normalized improvementof 2.5 dB for the two-element array. Athorough analysis of the AGC weighting processused in the system was made with particularemphasis placed on the effects of gainand noise figure variations between arraychannels.     

Rapid convergence by cascading Applebaum adaptive arrays

An adaptive array architecture is described which has improved convergence speed over the conventional Applebaum array when the eigenvalue spread of the input signal covariance matrix is large. The architecture uses N+1 Applebaum adaptive arrays in a two-layer cascaded configuration. The gain constants in the first layer are set so that large interfering sources are quickly nulled, but small interfering sources are suppressed more slowly. Since the first layer removes the large interfering signals, the gain constant for the second layer can be set to a large value to quickly null the smaller interferers. The adaptation time is examined for several combinations of signal levels and array sizes. It is shown that, in many signal environments, the computational requirements for the cascaded array compare favorably with those of conventional sample matrix inversion (SMI) methods for large arrays