Difference beam aided target detection in monopulse radar

The classical detection step in a monopulse radar system is based on the sum beam only,the performance of which is not optimal when target is not at the beam center. Target detection aided by the difference beam can improve the performance at this case. However, the existing difference beam aided target detectors have the problem of performance deterioration at the beam center, which has limited their application in real systems. To solve this problem, two detectors are proposed in this paper. Assuming the monopulse ratio is known, a generalized likelihood ratio test(GLRT) detector is derived, which can be used when targeting information on target direction is available. A practical dual-stage detector is proposed for the case that the monopulse ratio is unknown. Simulation results show that performances of the proposed detectors are superior to that of the classical detector.     

Comparison of Two Scanning Radar Detectors: The Moving Window and the Feedback Integrator

A comparison is made between the moving window and feedback integrator detectors for a scanning radar. Detection probabilities and position estimates are calculated by using a Monte Carlo simulation. The moving window is a slightly better detector than the feedback integrator: it provides 0.5-dB better detection capability and 8 percent more accurate estimate of position. However, the feedback integrator can be implemented more easily.     

Effective Antenna Pattern of Scanning Radars

It is shown that weather radar signal averaging causes a broadened apparent pattern of the scanning radar antenna. The apparent pattern is obtained by convolving the original pattern with the averaging circuit impulse response. Echo displacement and pattern broadness are examined for square law, linear, and logarithmic detectors having exponential and finite time integrators.     

The Detection Performance of the Siebert and Dicke-Fix CFAR Radar Detectors

The Siebert and the Dicke-fix CFAR radar detectors, used to maintain a constant false alarm rate (CFAR) in radar receivers under very similar circumstances, are considered. The Siebert detector represents the maximum-likelihood detection procedure for a signal in Gaussian noise of unknown power level, whereas the Dicke-fix makes use of a bandpass limiter to normalize the input and thus ensure a constant false alarm rate. The detection performance of the two detectors is determined and a comparison shows that over a wide range of parameters, the Dicke-fix introduces a loss which is approximately 1 B larger than for the Siebert detector.     

Importance sampling for characterizing STAP detectors

This paper describes the development of adaptive importance sampling (IS) techniques for estimating false alarm probabilities of detectors that use space-time adaptive processing (STAP) algorithms. Fast simulation using IS methods has been notably successful in the study of conventional constant false alarm rate (CFAR) radar detectors, and in several other applications. The principal objectives here are to examine the viability of using these methods for STAP detectors, develop them into powerful analysis and design algorithms and, in the long term, use them for synthesizing novel detection structures. The adaptive matched filter (AMF) detector has been analyzed successfully using fast simulation. Of two biasing methods considered, one is implemented and shown to yield good results. The important problem of detector threshold determination is also addressed, with matching outcome. As an illustration of the power of these methods, two variants of the square-law AMF detector that are thought to be robust under heterogeneous clutter conditions have also been successfully investigated. These are the envelope-law and geometric-mean STAP detectors. Their CFAR property is established and performance evaluated. It turns out the variants have detection performances better than those of the AMF detector for training data contaminated by interferers. In summary, the work reported here paves the way for development of advanced estimation techniques that can facilitate design of powerful and robust detection algorithms     

Optimum and mismatched detection against K-distributed plusGaussian clutter

We derive the optimum radar receiver to detect fluctuating and non-fluctuating targets against a disturbance which is modeled as a mixture of coherent K-distributed and Gaussian-distributed clutter. In addition, thermal noise, which is always present in the radar receiver, is considered. We discuss the implementation of the optimum coherent detector, which derives from the likelihood ratio test under the assumption of perfectly known disturbance statistics, and evaluate its performance via a numerical procedure, when possible, and via Monte Carlo simulation otherwise. Moreover, we compare the performance of the optimum detector with those of two detectors which are optimum for totally Gaussian and totally K-distributed clutter respectively, when they are fed with such a mixed disturbance. We conclude that, though the optimum detector has a larger computational cost, it provides sensibly better detection performance than the mismatched detectors in a number of operational situations. Thus, there is a need to derive suboptimum target detectors against the mixture of disturbances which trade-off the detection performance and the implementation complexity     

Adaptive polarimetric target detection with coherent radar. I.Detection against Gaussian background

The derivation of a completely adaptive polarimetric coherent scheme to detect a radar target against a Gaussian background is presented. A previously proposed Generalized Likelihood Ratio Test (GLRT) polarimetric detector is extended to the case of a general number of channels; this exploits the polarimetric characteristics of the received radar echoes to improve the detection performance. Together with the fully adaptive scheme, a model-based detector is derived that has a lower estimation loss. A complete theoretical expression is derived for the detection performance of both proposed polarimetric detectors. They are shown to have Constant False Alarm Rate (CFAR) when operating against Gaussian clutter, but to be sensitive to deviations from the Gaussian statistic. The application to recorded radar data demonstrates the performance improvement achievable in practice     

Nonparametric rank detectors under K-distributed clutter in radar applications

This correspondence deals with a comparative analysis of parametric detectors versus rank ones for radar applications, under K-distributed clutter and nonfluctuating and Swerling II target models. We show that the locally optimum detectors (LODs) (optimum for very low signal-to-clutter ratio (SCR)) under K-distributed clutter are not practical detectors; on the contrary, asymptotically optimum detectors (optimum for high SCR) are the practical ones. The performance analysis of the parametric log-detector and the nonparametric (linear rank) detector is carried out for independent and identically distributed (IID) clutter samples, correlated clutter samples, and nonhomogeneous clutter samples. Some results of Monte Carlo simulations for detection probability (P/sub d/) versus SCR are presented in curves for different detector parameter values.     

UWB radar detection of targets in foliage using alpha-stableclutter models

We address the problem of detection of targets obscured by a forest canopy using an ultrawideband (UWB) radar. The forest clutter observed in the radar imagery is a highly impulsive random process that is more accurately modeled with the recently proposed class of alpha-stable processes as compared with Gaussian, Weibull, and K-distribution models. With this more accurate model, segmentation is performed on the imagery into forest and clear regions. Further, a region-adaptive symmetric alpha stable (SαS) constant false-alarm rate (CFAR) detector is introduced and its performance is compared with the Weibull and Gaussian CFAR detectors. The results on real data show that the SαS CFAR performs better than the Weibull and Gaussian CFAR detectors in detecting obscured targets     

Growler detection in sea clutter with coherent radars

Ship navigation through ice-infested waters is a problem of deep concern to the Canadian shipping and exploration industry. Conventional marine radars have difficulty detecting small pieces of glacial ice called growlers which are very hazardous to vessels if struck. In an effort to improve detection performance, X-band radar measurements were collected and analyzed to determine the characteristics of clutter and growler returns that could lead to their separability. These analyses suggested that coherent medium dwell-time processing (i.e., integration times of a fraction of a second) could provide improvement In growler detectability over conventional methods; and long dwell-time processing (i.e., integration times on the order of seconds) could provide even further improvement. We report on the performance of two new coherent, medium dwell-time detectors. A third detector which is representative of conventional marine radar serves as a basis for comparison Although significant improvement in growler detectability is achieved, the two coherent detectors still fall short of operational requirements. This leads to the development of a long dwell-time detector which provides considerably better performance. Empirical results indicate that this new detector could well satisfy stringent operational requirements     

Structures for radar detection in compound Gaussian clutter

The problem of coherent radar target detection in a background of non-Gaussian clutter modeled by a compound Gaussian distribution is studied here. We show how the likelihood ratio may be recast into an estimator-correlator form that shows that an essential feature of the optimal detector is to compute an optimum estimate of the reciprocal of the unknown random local power level. We then proceed to show that the optimal detector may be recast into yet another form, namely a matched filter compared with a data-dependent threshold. With these reformulations of the optimal detector, the problem of obtaining suboptimal detectors may be systematically studied by either approximating the likelihood ratio directly, utilizing a suboptimal estimate in the estimator-correlator structure or utilizing a suboptimal function to model the data-dependent threshold in the matched filter interpretation. Each of these approaches is studied to obtain suboptimal detectors. The results indicate that for processing small numbers of pulses, a suboptimal detector that utilizes information about the nature of the non-Gaussian clutter can be implemented to obtain quasi-optimal performance. As the number of pulses to be processed increases, a suboptimal detector that does not require information about the specific nature of the non-Gaussian clutter may be implemented to obtain quasi-optimal performance     

距离扩展目标检测中的 强散射点自适应估计方法

高分辨雷达通过积累多个距离单元上的目标回波,达到提高距离扩展目标检测性能的目的。由于目标散射中心的稀疏分布,常规的能量积累检测方法存在陷落损失,而基于目标强散射点的积累检测方法可有效克服因陷落损失造成的检测性能下降问题。利用最大类间方差法对目标强散射点进行自适应估计,并通过仿真验证了该方法改善检测性能的有效性。     

A Sequential Detector

The PRSD detector improves radar performance by controlling the distribution of energy in space, thus making a radar adaptive to its environment. An increase in performance over classical detectors may be realized in any of several ways: 1) greater maximum range; 2) smaller minimum detectable targets; 3) higher data rates; 4) lower average transmitted power, which allows smaller size and weight of equipment. The model of the PRSD detector described herein was tested with a semi-agile beam radar, and gave measured field performance improvement (for this particular radar) equivalent to an S/N increase ranging from 5 to 22 dB with a mean of 9.5 dB. This increase is greater than the 5-dB improvement predicted for the system in a white noise environment because many of the field tests were at locations subjected to heavy interference. The PRSD detector was extremely effective reducing the interference. In this paper, we will briefly review the theory of operation, describe the equipment and the method of test, and present experimental data. The data presented here are essential to a complete understanding of sequential detection since a rigorous theory encompassing multiple range bin radar has not been developed at this time. Finally, an extensive bibliography is appended.     

Studies of target detection algorithms that use polarimetric radardata

Algorithms are described which make use of polarimetric radar information in the detection and discrimination of targets in a ground clutter background. The optimal polarimetric detector (OPD) is derived. This algorithm processes the complete polarization scattering matrix (PSM) and provides the best possible detection performance from polarimetric radar data. Also derived is the best linear polarimetric detector, the polarimetric matched filter (PMF), and the structure of this detector is related to simple polarimetric target types. New polarimetric target and clutter models are described and used to predict the performance of the OPD and the PME. The performance of these algorithms is compared with that of simpler detectors that use only amplitude information to detect targets. The ability to discriminate between target types by exploring differences in polarimetric properties is discussed     

Multistatic-Radar Binomial Detection

The performance of multistatic-radar binomial detectors is investigated. Although conceptually similar to the well-knwn "M-out-of-N" detector frequently considered for monostatic systems, the multistatic detector must cope with false alarms generated by target et ghosting as well as by noise threshold crossings. A procedure for deriving the detection statistics of multistatic binomial detectors ors is presented. The procedure is applied to derive the detection probabilities for a spectrum of false alarm probabilities, target densities, and numbers of radar receivers.     

Robust adaptive radar detection in the presence of steering vector mismatches

In this paper, we consider the problem of robust radar detection in the presence of Gaussian disturbance with unknown covariance matrix. We design and assess three new robust adaptive detectors, capable of operating in the presence of unknown discrepancies between the nominal and the actual steering vector. Remarkably the new decision rules exhibit a bounded constant false alarm rate (CFAR) behavior and allow, through the regulation of a design parameter, to trade off target sensitivity with sidelobes energy rejection. Finally, computer simulations show that the proposed detectors achieve a visible performance improvement, in many situations of practical interest, over the traditional adaptive detection algorithms, especially in the presence of severe steering vector mismatches.     

CFAR behavior of adaptive detectors: an experimental analysis

We conduct an experimental analysis for assessing the constant false alarm rate (CFAR) behavior of four coherent adaptive radar detectors in the presence of experimentally measured clutter data. To this end we exploit several data files containing both land, lake, and mixed land and sea clutter, collected by two radar systems (the MIT Lincoln Laboratory Phase-One radar and the McMaster IPIX radar) at different polarizations, range resolutions, and frequency bands. The results show that all the receivers, in the presence of real data, don't respect their nominal probability of false alarm (P/sub fa/), namely they exhibit a false alarm rate higher than the value preassigned at the design stage. Nevertheless one of them, the recursive persymmetric adaptive normalized matched filter (RP-ANMF) is very robust, in the sense that it presents an acceptable displacement from the nominal P/sub fa/, in correspondence of all the analyzed scenarios.