共查询到20条相似文献,搜索用时 78 毫秒
1.
2.
3.
4.
为降低EPDM绝热层中残留硬脂酸含量,分析了EPDM绝热层中硬脂酸与氧化锌的原材料性能和反应活性,当绝热层中无其他组分存在时,两者在橡胶高温硫化过程中可反应完全生成硬脂酸锌,此时硫化胶中硬脂酸基本不发生残留。通过液相色谱等手段测定绝热层硫化胶片中残留硬脂酸含量,研究了EPDM绝热层组分对硬脂酸与氧化锌反应的影响程度和影响机理,发现在一些常用的工艺助剂,如补强剂、阻燃剂和树脂等影响下,氧化锌与硬脂酸会发生可逆化学反应,导致绝热层硫化胶片中游离硬脂酸的含量增加,影响程度与工艺助剂本身特性和用量有关。 相似文献
5.
6.
7.
8.
9.
为了提高固体火箭发动机绝热层材料耐烧蚀性能,采用三元乙丙橡胶、芳纶短纤纤维、硼酚醛树脂、过氧化二异丙苯为无阻燃剂绝热层材料的基本体系,研究了空心微珠、陶瓷微珠、玻璃鳞片、聚碳酸酯、苯并噁嗪树脂、甲基苯基硅树脂等耐烧蚀填料对三元乙丙橡胶烧蚀性能的影响。结果表明,无机填料(空心微珠、陶瓷微珠、玻璃鳞片各10份)、聚碳酸酯15份、苯并噁嗪树脂15份、甲基苯基硅树脂15份,线烧蚀率依次减少,分别为(0.203~0.222)mm/s、0.185mm/s、0.165mm/s、0.154mm/s,甲基苯基硅树脂是最理想的耐烧蚀填料,对无阻燃剂耐烧蚀三元乙丙橡胶研究具有一定的参考价值。 相似文献
10.
耐烧蚀溴-锑体系三元乙丙橡胶绝热层的初步研制 总被引:1,自引:0,他引:1
在绝热层配方组分筛选的基础上,采用过氧化物硫化体系,芳纶纤维和耐烧蚀硼树脂作为耐烧蚀填料,阻燃剂为含溴的阻燃剂和三氧化二锑以及少量的硼酸锌,并通过L9(33)正交实验确定了含溴的阻燃剂、三氧化二锑、硼酸锌的最佳用量分别为20份、15份、3份。确定的最佳配方和工艺生产出的三元乙丙橡胶绝热层的密度为1.188g/cm3,线烧蚀率为0.118mm/s,质量烧蚀率为0.063g/s,表明该体系初步满足了某小型固体火箭发动机燃烧室内壁绝热层的基本技术要求。 相似文献
11.
介绍了一种新的刚体转动的四元数模型。这些模型可以提高再定向控制的对边界条件的适应能力,在此基础上还介绍了这些模型的一些实际应用。 相似文献
12.
A. A. Davydov 《Cosmic Research》2011,49(4):335-344
A communication satellite (small spacecraft) injected into a geosynchronous orbit is considered. Flywheel engines are used
to control the rotational spacecraft motion. The spacecraft after the emergency situation has passed into a state of uncontrolled
rotation. In this case, no direct telemetric information about parameters of its rotational motion was accessible. As a result,
the problem arose to determine the rotational satellite motion according to the available indirect information: current taken
from the solar panels. Telemetric measurements of solar panel current obtained on the time interval of a few hours were simultaneously
processed by the least squares method integrating the equations of rotational satellite motion. We present the results of
processing 10 intervals of the measurement data allowing one to determine the real rotational spacecraft motion and to estimate
the total angular momentum of flywheel engines. 相似文献
13.
The problem of optimal control over many-revolution spacecraft orbit transfers between circular coplanar orbits of satellites is considered. The spacecraft flight is controlled by a thrust vector of a jet engine with restricted thrust (JERT). The mass expenditure is minimized at a limited time of flight. The optimal control problem is solved based on the maximum principle. The boundary value problem of the maximum principle is solved numerically using the shooting method. A modified computation scheme of the shooting method is suggested (multi-point shooting), as well as a method (correlated with the scheme) of choosing the initial approximation with the use of a solution to the optimization problem in the impulse formulation. The scheme and method allow one to construct many-revolution spacecraft orbit transfers. 相似文献
14.
热变形对天线指向机构的指向精度具有重要影响,但利用传统的设计方法很难实现对指向精度的准确计算,尤其是热变形对指向精度影响的研究工作更是少见。为此建立了机构的三维实体热-结构耦合有限元分析模型,根据有限元分析结果并结合机构的运动链关系,构建了各关键运动副运动误差的计算方法;在此基础上实现了机构指向误差的计算,研究了运动副名义、最大以及最小配合间隙条件下,温度载荷对各关键运动副运动误差和指向精度的影响。研究结果表明,温度载荷对关键运动副的运动误差以及机构的指向精度具有重要影响,随着温度载荷偏离常温数值的增加,指向误差不断增大,名义配合间隙条件下的指向误差最大。 相似文献
15.
16.
为满足航天器微振动环境模拟的需要,开展了多自由度微振动时域波形复现控制方法研究。首先,介绍了基于时域波形复现的多自由度微振动环境模拟控制理论方法。其次,针对六自由度微振动激励系统,应用MATLAB软件建立了基于实测传递函数矩阵的多输入多输出微振动激励仿真系统,针对微振动时域波形复现闭环控制过程进行了算法编程,并给出了仿真的闭环控制流程图。最后,通过算例对多自由度微振动时域波形复现进行了数值仿真,以给定的白噪声为输入,模拟对实际存在的系统非线性、测量误差等影响因素的控制效果。仿真结果验证了多自由度微振动时域波形复现控制方法的可行性及有效性,所得结论可以为研究多自由度微振动时域波形复现控制系统提供参考。 相似文献
17.
18.
10月14日,国际空间大学董事会主席拉姆·哈迪姆访问中国航天科技集团公司,就集团公司承办国际空间大学2007年暑期进修项目的筹备情况与集团公司人力资源部部长陈学钏、副部长白燕强交换了意见。陈学钏部长向哈迪姆通报了集团公司筹备这次活动的工作进展情况。据陈部长介绍,中国 相似文献
19.
The problem of determining an estimation of current spacecraft motion parameters on the stage of its descent is solved on the basis of readings of an optoelectronic navigation system and additional information from the self-contained inertial navigation system at the most general assumptions on the nature of motion of the object and the statistical properties of the noise of the measuring devices. 相似文献