Effects of output filter on cross regulation in SRC

Cross regulation performance of multioutput series resonant converter (SRC) topologies using capacitive or inductive filters is analyzed. The steady state cross regulation characteristics are derived using the state-plane techniques and are illustrated by the examples of two-output SRCs with capacitive and inductive filters. The characteristic curves show that over some range of output currents, the cross regulation performance of an SRC with an inductive filter is much improved over the SRC with capacitance filter and less dependent on the tolerances in leakage inductances and the loading on unregulated outputs. It is shown that the converter control characteristics of an SRC with an inductive filter are relatively unaffected by the addition of the second output. The theoretical results are verified by simulation     

An efficient active ripple filter for use in DC-DC conversion

When low ripple is required from a switched mode dc-dc converter, dissipative active filters offer an alternative to passive LC and coupled inductor filters. Analytical and experimental results are presented for a simple active ripple filter. The filter employs a pair of current transformers as sensors for feedforward and feedback control and two metal-oxide-semiconductor field-effect transistors (MOSFETs) as cancellation current drivers. Measurements demonstrate good ripple attenuation up to 5 MHz, more than 70 dB being obtained at 100 kHz, the switching frequency of a test converter. The overall efficiency was measured as 95%, with room for further improvement. The filter is suitable for input and output smoothing in dc-dc converters for aerospace and other critical applications     

一种针对结构损伤的非线性容错飞行控制方法

飞机结构损伤会引起气动参数变化,进而影响系统的静稳定性和控制精度。针对具有多输入的非线性飞机模型,利用带有二阶命令滤波器的自适应反步控制方法在线估计飞机气动参数,补偿结构损伤导致的气动参数变化对控制系统的影响,以实现容错飞行控制功能;引入的命令滤波器可以避免反步控制中复杂的求导运算。从理论上分析证明了带有二阶命令滤波器的自适应反步控制的闭环系统稳定性,并给出了控制跟踪误差的理论上界和二阶命令滤波器频率参数选取的下界。通过一个大型客机垂直尾翼脱落场景的仿真实验,验证了所提容错控制方法的有效性。     

Efficient Approximation of Kalman Filter for Target Tracking

A Kalman filter in the Cartesian coordinates is described for a maneuvering target when the radar sensor measures range, bearing, and elevation angles in the polar coordinates at high data rates. An approximate gain computation algorithm is developed to determine the filter gains for on-line microprocessor implementation. In this approach, gains are computed for three uncoupled filters and multiplied by a Jacobian transformation determined from the measured target position and orientation. The algorithm is compared with the extended Kalman filter for a typical target trajectory in a naval gun fire control system. The filter gains and the tracking errors for the proposed algorithm are nearly identical to the extended Kalman filter, while the computation requirements are reduced by a factor of four.     

Real-Time Tracking Filter Evaluation and Selection for Tactical Applications

Five important tracking filters that are often candidates for implementation in systems that must track maneuvering vehicles are compared in terms of tracking accuracy and computer requirements for tactical applications. A rationale for selecting among these filters, which include a Kalman filter, a simplified Kalman filter, an ?-? filter, a Wiener filter, and a two-point extrapolator, is illustrated by two examples taken from the authors' recent experience.     

Characterization of Kalman filter residuals in the presence ofmismodeling

The mean and covariance of a Kalman filter residual are computed for specific cases in which the Kalman filter model differs from a linear model that accurately represents the true system (the truth model). Multiple model adaptive estimation (MMAE) uses a bank of Kalman filters, each with a different internal model, and a hypothesis testing algorithm that uses the residuals from this bank of Kalman filters to estimate the true system model. At most, only one Kalman filter model will exactly match the truth model and will produce a residual whose mean and standard deviation have already been analyzed. All of the other filters use internal models that mismodel the true system. We compute the effects of a mismodeled input matrix, output matrix, and state transition matrix on these residuals. The computed mean and covariance are compared with simulation results of flight control failures that correspond to mismodeled input matrices and output matrices     

An Optimal Control Approach to Designing Constant Gain Filters

This paper applies optimal control theory to designing constant gain filters which minimize a weighted average of the filtered variances. Uniaxial second-order motion is studied in detail, and an example is given which indicates that a constant gain filter may be designed with performance comparable to a Kalman filter. An appendix is included which shows how the approach may be extended to higher order systems.     

Adaptive Tracking Filter for Maneuvering Targets

A general method of continually restructuring an optimum Bayes-Kalman tracking filter is proposed by conceptualizing a growing tree of filters to maintain optimality on a target exhibiting maneuver variables. This tree concept is then constrained from growth by quantizing the continuously sensed maneuver variables and restricting these to a small value from which an average maneuver is calculated. Kalman filters are calculated and carried in parallel for each quantized variable. This constrained tree of several parallel Kalman filters demands only modest om; puter time, yet provides very good performance. This concept is implemented for a Doppler tracking system and the performance is compared to an extended Kalman filter. Simulation results are presented which show dramatic tracking improvement when using the adaptive tracking filter.     

多滤波器并联方式解决直升机动力传动链扭振耦合

为了解决直升机动力传动链扭振系统与动力控制系统的耦合不稳定性问题,提出了一种采用多个陷波滤波器并联组合、根据发动机不同的工作模态选择不同滤波器实现扭振滤波的方法。对陷波滤波器进行了改进,使得引入控制系统通频带的附加相移减小,降低了对系统控制性能的影响。通过直升机联合试验,验证了该方法是有效的。      

A Comparison of Complementary and Kalman Filtering

A technique used in the flight control industry for estimation when combining measurements is the complementary filter. This filter is usually designed without any reference to Wiener or Kalman filters, although it is related to them. This paper, which is mainly tutorial, reviews complementary filtering and shows its relationship to Kalman and Wiener filtering.     

Square root parallel Kalman filtering using reduced-order localfilters

The basic parallel Kalman filtering algorithms derived by H.R. Hashemipour et al. (IEEE Trans. Autom. Control. vol.33, p.88-94, 1988) are summarized and generalized to the case of reduced-order local filters. Measurement-update and time-update equations are provided for four implementations: the conventional covariance filter, the conventional information filter, the square-foot covariance filter, and the square-foot information filter. A special feature of the suggested architecture is the ability to accommodate parallel local filters that have a smaller state dimension than the global filter. The estimates and covariance or information matrices (or their square roots) from these reduced-order filters are collated at a central filter at each step to generate the full-size, globally optimal estimates and their associated error covariance or information matrices (or their square roots). Aspects of computational complexity and the ensuing tradeoff with communication are discussed     

Interrelationship of single-filter and multiple-model adaptivealgorithms

An equivalent filter bank structure for multiple model adaptive estimation (MMAE) is developed that uses the residual and state estimates from a single Kalman filter and linear transforms to produce equivalent residuals of a complete Kalman filter bank. The linear transforms, which are a function of the differences between the system models used by the various Kalman filters, are developed for modeling differences in the system input matrix, the output matrix, and the state transition matrix. The computational cost of this new structure is compared with the cost of the standard Kalman filter bank (SKFB) for each of these modeling differences. This structure is quite similar to the generalized likelihood ratio (GLR) structure, where the linear transforms can be used to compute the matched filters used in the GLR approach. This approach produces the best matched filters in the sense that they truly represent the time history of the residuals caused by a physically motivated failure model     

采用一组卡尔曼滤波器检测发动机传感器故障

在发动机全功能数字电子控制系统中,提高传感器工作的可靠性是十分重要的,除了不断对传感器本身的性能加以改进提高外,现在广泛地采用了余度技术。近二十年来对解析余度(Analyt ical Redundancy)进行了广泛的研究,解析余度(AR)方法是基于各状态变量之间存在的解析关系,在系统可观条件下,利用无故障的输出测量值去估计(构造)已故障传感器正常工作状态时的输出信息,从而实现对故障的检测、隔离与重构,保证控制系统具有预定的控制性能。      

Improved Range Resolution Filters for Rectangular-Pulse Radar Systems

The performance of several new clutter-reduction filters suitable for rectangular-pulse radar systems is investigated. The new filters consist of various approximations and modifications of two filters known to be optimal for certain criteria: the well-known Urkowitz filter which optiizes the clutter improvement ratio, and the newer sidelobe reduction filter which minimizes output noise power subject to peak sidelobe constaints. The new filters are compared usig five basic criteria: clutter improvement ratio, signal-to-noise ratio, sidelobe peak ratio, pulse compression ratio, and filter complexity. The results are summarized in tabular and graphical form.     

Federated square root filter for decentralized parallel processors

An efficient, federated Kalman filter is developed for use in distributed multisensor systems. The design accommodates sensor-dedicated local filters, some of which use data from a common reference subsystem. The local filters run in parallel, and provide sensor data compression via prefiltering. The master filter runs at a selectable reduced rate, fusing local filter outputs via efficient square root algorithms. Common local process noise correlations are handled by use of a conservative matrix upper bound. The federated filter yields estimates that are globally optimal or conservatively suboptimal, depending upon the master filter processing rate. This design achieves a major improvement in throughput (speed), is well suited to real-time system implementation, and enhances fault detection, isolation, and recovery capability     

Decentralized reduced-order filters

Continuous and discrete methods of designing simple reduced-order local filters within a large-scale network are suggested. The filters are designed to estimate only the local variables of interest and not the entire state vector. The method has the advantage that one need not know the mathematical models of the subsystems generating the interconnection variables. The order of the filter can be small enough so that there is no computational burden associated with the filter. The disadvantage of the method is that performance is lost by using a reduced-order filter instead of a full-order filter. An example that demonstrates one application in the aerospace industry is presented     

Design and Application of an Adaptive Tracking Filter Control System

The design of an adaptive tracking filter control system and its application to large flexible booster vehicles is described. The problem of elastic vehicle stability is considered along with its solution by conventional and adaptive techniques. The improvement in vehicle stability, which may be achieved with the adaptive tracking filter technique as compared to conventional techniques, is shown. The control system evolved uses two adaptive tracking filters to phase stabilize the first and second bending modes, in addition to conventional compensation techniques. The application of this adaptive technique to a vehicle in which the modal frequencies are in close proximity (<2.5 percent separation) is discussed. The mechanization of the adaptive control system involves the selection of design techniques and components that are electrically and physically compatible with the intended airborne application. The development of a suitable frequency tracking technique and tracking filter is described, in addition to the electronic and mechanical design of the adaptive control system prototype.     

On a decoupled multitarget tracking algorithm

An analysis is conducted of the optimality of a decoupled tracking filtering algorithm for addressing the problem of tracking multiple targets with correlated measurements and maneuvers. It is proved that the decoupled filters are, in general, suboptimal and are not in fact Kalman filters. However, it is shown also that if the standard Kalman filter is asymptotically stable, the decoupled filters will converge asymptotically to the stable version of the standard Kalman filter. For the case of time-invariant measurement and process noise covariance, a simple sufficient condition guaranteeing the asymptotical stability of the decoupled filters are given     

用于检测操纵面损伤的故障检测滤波器

针对飞行中典型的操纵面损伤故障,以故障检测滤波器为基础,开发了一种建立在离散模型上的快速、稳定的故障检测及诊断算法,可以在几个采样周期内同时精确检测出多个操纵面的损伤程度,故障检测滤波器的稳定性、收敛性也得到证明,具有较好的实用性。几种组合故障下的仿真研究证实了上述结论。     

Survey of High-Power Microwave Filters

A summary of research and development work on high-power microwave filters is given here: first, design considerations in high-power microwave filters?power handling capacity, waveform distortion, multimode suppression, and stop and pass band characteristics; second, a discussion of filtering devices and techniques in two broad categories-dominant mode filters and harmonic filters (discussion covers methods of operation and significant characteristics of each filter developed to date); and third, a discussion of applications and limitations of filters in various systems and interference situations. Also included are the availability, cost, size, weight, etc. as functions of frequency for the various filter types.