共查询到17条相似文献,搜索用时 234 毫秒
1.
2.
3.
天线组阵能否完全替代大口径天线有一个关键性难题,就是天线阵是否支持上行链路组阵。深空航天器无法将不同地面天线的上行信号对齐,所以上行链路信号的调整必须在地面完成。针对上行组阵发射机相位调整问题,提出一种基于VLBI(Very Long Baseline Interferometry,甚长基线干涉测量)技术的接收模式天线上行组阵标校方案,并对标校精度进行了简要分析。将上行链路时延分解为几何时延和发射系统时延,建立了几何时延模型,通过标定接收时延和发射时延,便可以得到天线阵元间的相位标校值。理论分析结果表明,该方案具有一定的可行性,对上行组阵相位标校的研究具有一定的借鉴意义。 相似文献
4.
提出了一种改进的基于子空间的星载数字波束形成(DBF)接收天线的误差校正方法。根据阵列互耦效应主要取决于阵元间的几何距离这一特点,利用阵元空间排布的对称性简化了天线的互耦模型,将天线的互耦效应及射频(RF)通道失配统一为通道间的幅相不一致。通过在基带注入特定的阵内相位差降低了子空间算法的计算复杂度。在建立7单元正六边形平面阵仿真模型的基础上,分析不同信噪比(SNR)环境下校正算法的性能,经比较得出可以通过提高发射信号功率改善误差估计的精度,验证了算法的有效性。仿真分析结果表明该算法在卫星通信系统中有一定的工程应用价值。 相似文献
5.
6.
为定量分析上行天线组阵增益损失的影响因素,提出一种通过建立数学模型分析合成损耗的估计方法.首先基于天线原理和电磁波传输理论建立了天线组阵上行链路信号的数学模型,以统计学理论对数学模型进行分析,得到了影响上行链路信号的若干因素.通过分析得出,深空探测信号在远距离传输中因大气相位扰动引起的误差是造成天线组阵增益损失的最主要因素.再通过对大气相位扰动误差的进一步分析,构建S频段和X频段下大气相位扰动的空间自相关模型和时间自相关模型,得到组阵基线长度和工作仰角同合成损耗的关系.经过对各误差源的分析可知,在目前的技术水平下,能够满足上行天线组阵工程应用的精度要求. 相似文献
7.
针对深空测控通信背景下大规模组阵的天线布局优化问题,给出了优化目标(即单元波束内合成波束附近的旁瓣最小化)以及优化边界条件(包括天线数、天线口径、工作频段、最小间距和最大布局范围等),并在此基础上建立了优化模型,理论分析表明,布局优化后的归一化旁瓣峰值比布局随机化的归一化旁瓣峰值低lnN/N(N为天线数)。最后基于梯度优化算法给出具体的优化流程并进行了仿真,仿真结果表明,在给出的优化边界条件下,优化后的合成波束方向图旁瓣峰值降到约-10dB,与理论分析结果基本一致。 相似文献
8.
针对低轨空间科学卫星在轨任意姿态无固定对天面造成的无法连续GPS(Global Positioning System,全球定位系统)定位的问题,在HXMT(Hard X-ray Modulation Telescope,硬X射线调制望远镜)卫星中提出了星载全空间可见的GPS接收系统,并指出了双天线多径干扰对定位精度的影响。建立模型,对双天线下主瓣直达信号和后瓣镜像干扰信号叠加合成的信号进行定位精度分析,结果表明,空间中83.3%以上的GPS卫星信号对该系统带来的定位误差影响不大于单天线的定位误差影响。通过半物理动态仿真验证以及外场试验进行验证,实际工程测试数据结果表明采用剔星策略后定位精度提高约13.4%。从而证明了星载全空间可见的GPS接收系统方案的正确性,并可广泛应用于工程实际。 相似文献
9.
10.
卫星导航系统(GNSS)地面站天线对卫星进行上行注入时,信号到达卫星时较弱,容易受到干扰,故地面站注入天线需同时具备平时多目标注入和干扰时单目标功率增强的能力。利用卫星导航系统中地面站之间能够实现精密时间同步的特点,提出了一种基于分布式卫星导航地面站抛物面天线的空间功率合成方法,使用相位预补偿实现分布式天线阵到达目标卫星信号的相位粗同步;分析了相位误差、辐射功率误差对空间功率合成效率的影响,得到了阵元初始相位标定精度与相对定位精度的约束关系;并对合成信号的抗干扰能力和信号质量进行了研究。理论和仿真结果表明,当相位精度因子小于0.2时,4个等辐射功率天线在10°仰角以上波束扫描范围内的功率合成效率均在75%以上,且可以通过控制初始相位标定精度与相对定位精度实现更高的合成效率;而在合成效率要求75%以上时,天线辐射功率误差对合成效率的影响基本可以忽略。采用分布式波束扫描天线能够对地面站上行注入进行功率增强,可实现注入波束和功率的灵活配置,有效解决制约机动式和小型化地面站功率提升的瓶颈问题。 相似文献
11.
Experimental results from a four-element, linear, half-wavelength spacing, adaptive-array antenna under the control of the least mean square (LMS) algorithm are presented. The array is found to be capable of nulling a 70-MHz signal to -35 dB below a desired signal over a 5-MHz bandwidth. The antenna processing gain is constant over a desired signal-to-jammer signal power ratio range from -20 dB to 5 dB. A sharp reduction in processing gain is observed for angular separations between jammer and desired signal of less than 10°. Antenna patterns taken with weights set in 300 iterations of the LMS algorithm show that the one strong, one weak jammer combination has a longer weight convergence time and reduced processing gain compared with a two strong jammers combination. Contours of constant desired signal-to-jammer signal power ratio, after adaptive antenna processing, reveal a complex shape for communication between air and ground due to the finite angular resolution of the adaptive antenna. 相似文献
12.
Jiang Zhihong Huang Fukan Wan Jianwei Cheng Zhu 《中国航空学报》2007,20(4):339-345
This paper presents a modified frequency scaling algorithm for frequency modulated continuous wave synthetic aperture radar (FMCW SAR) data processing. The relative motion between radar and target in FMCW SAR during reception and between transmission and reception will introduce serious dilation in the received signal. The dilation can cause serious distortions in the reconstructed images using conventional signal processing methods. The received signal is derived and the received signal in range-Doppler domain is given. The relation between the phase resulting from antenna motion and the azimuth frequency is analyzed. The modified frequency scaling algorithm is proposed to process the received signal with serious dilation. The algorithm can effectively eliminate the impact of the dilation. The algorithm performances are shown by the simulation results. 相似文献
13.
14.
作为雷达技术发展历史中的里程碑,合成孔径雷达(SAR)通过使用空中合成天线阵列技术及先进的目标回波信号处理技术能够提供清晰的地球表面图像。由于它的这一突出特点,SAR已经成为许多飞行器的重要任务载荷并被广泛应用于军事及民用领域。从航空电子系统总体需求角度出发,为了深刻理解SAR系统的工作原理并得到更好的SAR图像产品,有必要对系统数学模型的建立、SAR回波信号的仿真以及信号处理算法进行深入的研究。本文试图从这三方面讨论SAR系统设计中的关键问题。 相似文献
15.
Chan Y.T. Lee B.H. Inkol R. Yuan Q. 《IEEE transactions on aerospace and electronic systems》2001,37(4):1155-1162
The conventional analog Adcock-Butler matrix (ABM) antenna array direction finder suffers from systemic errors, component matching problems, and bandwidth limitations. Three digital bearing estimators are developed as candidates to replace the analog signal processing portion of the ABM. Using the same antenna array, they perform all signal processing in the frequency domain, thereby benefitting from the computational efficiency of the fast Fourier transform (FFT) algorithm. The first estimator requires two analog-to-digital converters (A-D) and three antenna elements. It multiplies the difference between the discrete Fourier transforms (DFTs) of the output signals from two antenna elements with that from a third antenna element. At each frequency component, the phase of this product is a function of the bearing. A weighted least squares (LS) fit through all the phase components then gives a bearing estimate. The second estimator is similar to the first but uses three A-D and all four antenna elements. The output signal from the additional antenna element provides an independent estimate of the weights for the LS fit, giving an improvement in accuracy. The third estimator applies the physical constraint existing between the time-difference-of-arrival (TDOA) of a signal intercepted by two perpendicular sets of antenna elements. This yields a better estimator than simple averaging of the bearing from each set of antenna elements. The simulation studies used sinusoids and broadband signals to corroborate the theoretical treatment and demonstrate the accuracy achievable with these estimators. All three direction finders have superior performance in comparison with the analog ABM 相似文献
16.
为更好地开展深空无线电干涉测量试验,基于DiFX(Distributed FX,分布式FX型相关处理)、SPICE(Spacecraft Planet Instrument Camera-matrix Events,航天器行星仪器照相机矩阵事件)、HOPS(Haystack Observatory Postprocessing System,Haystack克天文台后处理系统)及AIPS(Astronomical Image Processing System,天文图像处理系统)等开源软件,搭建了一套可用于深空探测器信号相关处理的无线电干涉测量数据处理系统。首先介绍了该系统的整体架构及组成,然后介绍了系统各组成模块的功能及工作原理,最后利用该系统对嫦娥三号着陆器开展了观测试验,并对观测数据进行了处理。试验结果表明,该系统能成功实现深空航天器信号的相关处理、条纹拟合,以及时延解算等功能,有望为我国嫦娥五号任务及火星探测任务数据处理提供支持。 相似文献
17.
在室内WiFi环境下,针对常见指纹匹配算法所忽略的信号波动问题,提出了一种基于自适应修正曼哈顿距离和AP选择的指纹匹配算法,并结合加权K近邻方法实现定位。首先采用AP选择算法获取部分受干扰程度小和出现频率高的AP,在指纹匹配时仅使用该部分AP的接收信号强度进行计算;在分析WiFi信号传播衰减公式和信号波动的基础上,提出了将自适应修正曼哈顿距离作为指纹匹配的度量距离,使用该距离旨在平滑信号波动对指纹相似度计算的影响;最后采用加权K近邻方法估计测试点的坐标。实验结果表明,在加权K近邻方法的框架下,基于自适应修正曼哈顿距离的定位算法在定位精度上优于基于欧氏距离、曼哈顿距离、余弦距离和Sorensen距离的定位算法。 相似文献