An LMS Adaptive Array for Multipath Fading Reduction

Multipath fading often poses a serious hindrance in radiocommunication. The application of a least-mean-square (LMS)adaptive array to the problem of multipath fading reduction is discussed. However, it is known that multipath components are in general correlated with one another. We examine the effect of the correlation on the performance of the LMS adaptive array. When the correlation coefficient does not equal or approximate 1, the LMS adaptive array suppresses the multipath signals significantly by nulling. On the other hand, when the correlation coefficient nearly equals 1, the LMS adaptive array prevents the output signalpower from decreasing. Therefore, the LMS adaptive array mayreduce the multipath fading effectively for any correlation coefficient value. A reference signal in the LMS adaptive array is also discussed. It is shown that synchronization in the referencesignal generation must be extremely accurate. Moreover, aprocessor configuration is proposed which may generate thereference signal with the required accuracy.     

The Performance of an LMS Adaptive Array with Frequency Hopped Signals

The performance of an LMS adaptive array with a frequency hopped, spread spectrum desired signal and a CW interference signal is examined. It is shown that frequency hopping has several effects on an adaptive array. It causes the array to modulate both the amplitude and the phase of the received signal. Also, it causes the array output SINR (signal-to-interference-plus-noise ratio) to vary with time and thus increases the bit error probability for the received signal. Typical curves of the desired signal modulation and the time-varying SINR at the array output are presented. It is shown how the array performance depends on hopping frequency, frequency jump size, interference frequency, signal arrival angles, and signal powers.     

The Effect of a Pulsed Interference Signal on an Adaptive Array

The performance of a least mean square (LMS) adaptive array in the presence of a pulsed interference signal is examined. It is shown that a pulsed interference signal has two effects. First, it causes the array to modulate the desired signal envelope (but not its phase). Second, it causes the array output signal-to-interferenceplus-noise ratio (SINR) to vary with time. The desired signal modulation is evaluated as a function of signal arrival angles, powers and interference pulse-repetition frequency (PRF) and pulsewidth. It is shown that the signal modulation is small except when the interference arrives close to the desired signal. To evaluate the effect of the time-varying SINR, it is assumed that the array is used in a differential phase-shift keyed (DPSK) communication system. It is shown that the SINR variation causes a noticeable but not disastrous increase in the bit error probability.     

Adaptive Array Behavior with Sinusoidal Envelope Modulated Interference

The behavior of a LMS (least mean square) adaptive array with modulated interference is described. An interference signal with sinusoidal, double-sideband, suppressed-carrier modulation is assumed. It is shown that such interference causes the array to modulate the desired signal envelope but not its phase. The amount of the desired signal modulation is determined as a function of signal arrival angles and powers and the modulation frequency of the interference. Such interference also causes the array output signal-to-interference-plus-noise ratio (SINR) to vary with time. However, it is shown that when the desired signal is a digital communication signal, the averaged bit error probability is essentially the same as for continuous wave (CW) interference.     

Adaptive Array Behavior with Periodic Envelope Modulated Interference

A method is presented for determining the effects of envelope modulated interference on a least mean square (LMS) adaptive array. The interference is assumed to have periodic envelope modulation with a bandwidth that is small compared with the carrier frequency. For such interference, the method allows one to calculate the periodic steady-state behavior of the array weights and the resulting array performance. As an example, we compute the effects of an ordinary amplitude modulated (AM) interference signal on the array. It is shown that such interference causes the array to modulate the desired signal envelope but not its phase. With a differential phase-shift-keyed (DPSK) desired signal, AM interference is found to have about the same effect on bit error probability as CW interference.     

Adaptive Array Behavior with Periodic Phase Modulated Interference

We consider a least mean square (LMS) adaptive array [1] receiving a phase modulated interference signal. The phase modulation is assumed to be periodic and to have finite bandwidth. Under these assumptions, we determine the time-varying array weights, the modulation on the array output desired signal, and the time-varying output interference-to-noise ratio (INR) and SINR (signal-to-interference-plus-noise ratio). We present numerical results describing the behavior of a 2-element adaptive array that receives an interference signal with sinusoidal phase modulation. We show how each signal parameter (arrival angle, power, modulation index, and modulation frequency) affects the performance of the array.     

Reference Loop Phase Shift in an N-Element Adaptive Array

Adaptive arrays based on the LMS algorithm require the generation of a reference signal which is usually derived from the array output. A particular problem associated with this technique is that of a phase shift in the reference signal loop. The effects of this phase shift on the performance of an N-element adaptive array are discussed. It is shown that a reference loop phase shift causes the array weights to cycle, thereby frequency translating the signals at the output. The weight-cycling frequency is related to various system parameters of an N-element array. In particular, it is observed that the cycling frequency increases as the number of antennas (N) increases.     

Results from a Four-Element Adaptive Antenna Experiment

Experimental results from a four-element, linear, half-wavelength spacing, adaptive-array antenna under the control of the least mean square (LMS) algorithm are presented. The array is found to be capable of nulling a 70-MHz signal to -35 dB below a desired signal over a 5-MHz bandwidth. The antenna processing gain is constant over a desired signal-to-jammer signal power ratio range from -20 dB to 5 dB. A sharp reduction in processing gain is observed for angular separations between jammer and desired signal of less than 10°. Antenna patterns taken with weights set in 300 iterations of the LMS algorithm show that the one strong, one weak jammer combination has a longer weight convergence time and reduced processing gain compared with a two strong jammers combination. Contours of constant desired signal-to-jammer signal power ratio, after adaptive antenna processing, reveal a complex shape for communication between air and ground due to the finite angular resolution of the adaptive antenna.     

Performance of a Modified Applebaum Adaptive Array

The performance of a modified Applebaum adaptive array is studied. The new array is obtained by removing the desired signal component from the output signal fed back to the correlator of an Applebaum type adaptive array. Various signal scenarios, including single desired signals or multiple simultaneous desired signals are examined. The new array is less sensitive to beam pointing errors and does not cause power inversion of desired signals. In the case of multiple simultaneous desired signals, the new array does not degrade the SNRs of strong desired signals.     

An Adaptive Array Signal Processing Algorithm for Communications

An algorithm is described for initial synchronization in a communication system with a digital adaptive array. This algorithm can also be used for message extraction. A set of consecutive complex video samples of the array output is processed to obtain optimum adaptive array weights, based on a least mean square (LMS) error criterion. This computation is performed for each of the possible alternative signals which may be present during an observation interval. The correct synchronization time or message symbol is selected as the one which yields the minimum LMS error. Assuming orthogonality of the alternative codes, a probability distribution for the output of this processor has been derived.     

基于Kalman滤波的GPS/INS接收机自适应干扰抑制方法

 考虑到惯导信息辅助GPS(GPS/INS)接收机对干扰抑制实时性的要求,提出一种基于Kalman滤波的GPS/INS接收机自适应干扰抑制方法。自适应广义旁瓣相消(GSC)多采用低复杂度最小均方(LMS)算法更新权矢量,收敛速率较低,严重时会导致接收机定位中断。首先利用Householder变换构建GSC下支路的阻塞矩阵,用于阻塞任意二维阵型阵列接收的期望信号;再用Kalman滤波自适应更新下支路权矢量,从而有效提高阵列输出信干噪比(SINR)。理论分析和仿真结果说明本文方法可有效抑制干扰对接收机的影响,且具有实时性高的特点。     

The Effect of Differential Time Delays in the LMS Feedback Loop

The effect of differential time delay in the feedback loops of an LMS adaptive array is examined. Differential time delay is shown to have two effects on array performance. First, it causes the weights to oscillate during weight transients. Second, it degrades the output signal-to-interference-plus-noise ratio (SINR) from the array. Weight oscillation occurs when the phase shifts in the LMS loop are not matched at the signal carrier frequency. SINR degradation depends on signal bandwidth: the wider the bandwidth, the larger the degradation.     

An Adaptive Interference Canceling Array Utilizing Hybrid Techniques

The steady state properties of an adaptive array utilizing prior knowledge of both approximate signal arrival direction and signal characteristics are presented. The method combines the features of a directionally constrained array and an array with a self-generated reference signal. Explicit results are obtained for output signal, interference, and noise powers assuming a single interferer is present. The inclusion of a self-generated reference circuit is shown to reduce the sensitivity to pointing error typical of arrays utilizing a zero order directional constraint, the improvement being a consequence of the reduction of the desired signal component fed back to the sidelobe canceling circuit. A relationship between the degree of sensitivity reduction and the quality of the reference signal is developed. Results of computations of signal to interference plus noise ratios for a 7-element 10-wavelength nonuniformly spaced array as a function of pointing error are presented. These results show the behavior with one interferer inside and outside the beamwidth of the quiescent array and with multiple interferers for various degrees of perfection of the reference generating circuit. In all cases the computations confirm that the otherwise severe effects of small pointing errors are substantially reduced.     

Convergence Rate of the Extended SMI Algorithm for Narrowband Adaptive Arrays

An extended sample matrix inversion (SMI) algorithm can be used for minimizing the mse (mean-squared error) between the output of an N-element adaptive array and a desired reference signal. This algorithm is shown to yield mse within 3 dB of minimum (on the average) after (2N - 1) observations of the antenna element outputs.     

Improved Feedback Loop for Adaptive Arrays

This paper is concerned with the problem of time constants in adaptive arrays. The paper presents a improved form of an adaptive array feedback loop, which has the property that its time constants are fixed. This property is an advantage over the well-known least mean square (LMS) loop, for which time constants depend on received signal power. Fixed time constants are of interest because they simplify dynamic range problems for adaptive arrays in communication and radar systems.     

Eliminating Reference Loop Phase Shift in Adaptive Arrays

Adaptive array processors utilizing the Widrow LMS algroithm with an internally generated reference signal have been shown to be subject to weight cycling caused by phase shift in the reference extracting loop. Adaptive compensation schemes that eliminate the reference loop phase shift are suggested here. Two such schemes are proposed. They differ in the amount of hardware complexity needed as well as in the rate at which each one eliminates the phase shift. Computer calculations are used to compare the rates of convergence of the two schemes.     

Interference Canceler Array with Reference Generating Loop

Adaptive arrays utilizing an internally generated reference signal to drive least mean square (LMS) weight determining loops have experienced difficulty arising from phase shifts induced by the reference generating circuits. The phenomenon observed is that the expected value of the weights oscillate in the steady state modulating the incoming signal. A scheme is reported which avoids this problem. It differs from earlier methods in that the reference generator has no infinite limiter so that the amplitude of the reference is not constant and in that one element is left unweighted. Alternative schemes were considered wherein the reference signal is drawn from all the array elements or from the weighted elements only. Only the latter is fully reported here, and is found superior. It is shown that in the presence of a desired signal and independent element noise, the processing scheme proposed produces weights whose expected values converge to a constant nonoscillatory state provided certain mild constraints are satisfied. In particular, if a cos ? ? 1, a being the gain and ? the phase shift of the filter in the reference generator, the weights converge. In addition, the steady state signal-to-noise power ratio (SNR) is determined. It is found that with a cos ? close to unity the SNR is that of an (N-1) element array coherently combined, where N is the number of elements. The SNR falls off with departures of a and ? from 1 and 0, respectively, but not drastically.     

The Effects of Gaussian Interference on Communication Systemswith Adaptive Arrays

The performance of a bandlimited binary phase-shift-keyed (BPSK) communication system is examined when the received BPSK signal is corrupted by both thermal noise and a directional Gaussian noise interfering signal. The system uses an LMS adaptive array to suppress this interference. The effects of signal power levels, arrival angles, bandwidths, and the array bandwidth are examined. The performance of a system that uses tapped delay lines for the array weights is also examined. It is shown that the performance of a system with tapped delay lines is not affected by the interference bandwidth for a single interferer.     

Upper Bound of a Loop Gain in a Power Inversion Adaptive Array

A loop gain is an important parameter in a power inversion adaptive array. The upper bound value of the loop gain is obtained which prevents the array suppressing a desired signal seriously. This result is very useful for determining the loop gain.     

小波域的自适应波束形成算法

在分析传统自适应波束形成的基础上,首次提出了一种小波域的自适应波束形成算法。与通常的自适应波束形成算法相比,该算法利用小波变换对小波空间进行了分解,信号经小波变换自相关性会下降,收敛速度提高,同时在此分解过程中,根据信号与白噪声在不同尺度上的小波变换模极大值表现完全不同的特性进行信号的消噪。理论分析和仿真结果表明了该算法收敛速度较快,且计算量增加较少,易于实时实现,而且具有较好性能。同时仿真实验表明该算法收敛速度与小波基和尺度的选择有关,尺度越大收敛速度越快;对于同一小波基系列,小波基的正则性越好收敛速度越快。