Nonparametric rank detectors on quantized radar video signals

Uniform randomization of ties is required for defining distribution-free ranks of independent and identically distributed quantized samples. Formulas of rank probabilities are given and applied to radar detection under quantized video samples. For some detectors, and assuming Gaussian noise, the asymptotic loss L_∞(q) is calculated versus the normalized quantization step q, and the loss L(q) is estimated by Monte Carlo simulations. Both of these resulted in monotonic functions of q (0<q<1.1) that are independent of the other parameters. Furthermore, L(q)≈L_∞(q )⩽0.45 dB, as q<0.8. The quantization step q is normalized with respect to the noise standard deviation     

Frequency diversity in millimeter wave satellite communications

Dual-band frequency diversity seems to be an effective fade countermeasure to rain-induced attenuation in satellite communications above 20 GHz. This method, particularly suited for satellites operating in two frequency bands, typically K_a band and C or K_u band, achieves very low levels of outage probability especially where the rain fades are severe. A theoretical analysis of a frequency diversity system is performed to evaluate the amount of reserve capacity needed to counteract fading in a satellite network. The problems that arise in implementing adaptive fade countermeasures because of the dynamic characteristics of fading are discussed, and the results of the simulations performed using the attenuation time series at 11.6 GHz, measured with the Sirio satellite throughout four years, are presented     

CCRS C/X-airborne synthetic aperture radar: An Rand D tool for the ERS-1 time frame

The airborne synthetic-aperture radar (SAR) system developed for the Canada Centre for Remote Sensing (CCRS) is described. It consists of two radars, at C-band and X-band. Each radar incorporates the following features: dual-channel receivers and dual-polarized antennas; a high quality, 7-look, real-time processor; a sensitivity time control for range-dependent gain control; a motion-compensation system for antenna steering in azimuth and elevation; and baseband I and Q signal phase rotation. The system also uses a high-power transmitter with a low-power back-up. The SAR maps to either side of the aircraft, at high or low resolution, at incidence angles which in high resolution span 0° to 80°. Radar operating parameters, data products, key specifications and the motion compensation scheme used are presented. Properties of the real-time imagery are discussed and examples of C-band SAR data in the three operating modes are given     

Estimation of radar detection and false alarm probability

The accuracy with which detection and false alarm probabilities can be estimated with a limited amount of measured radar data is addressed. A simple simulation method for estimating the statistical performance of a radar detection system is presented. Confidence limits and a rule of thumb for accuracy for the estimated probabilities are presented along with procedures for calculating them. It is concluded that the minimum value of N used in a detection radar signal simulation should be 10/P_FA when the simple simulation method is used, where P_FA is the probability of false alarm, and that a value closer to 100/P _FA is preferable     

Simplified analysis of PWM converters using model of PWM switch.II. Discontinuous conduction mode

For pt.I see ibid., vol.26, no.3, p.490-6 (1990). According to the method of state-space averaging, when a pulsewidth modulation (PWM) converter enters discontinuous conduction mode (DCM), the inductor current state is lost from the average model of the converter. It is shown that there is neither theoretical nor experimental justification for the disappearance of the inductor state as claimed by the method of state-space averaging. For example, when the model of the PWM switch in DCM is substituted in the buck, boost, or buck-boost converter while the inductor is left intact, the average model has two poles: the first pole f_p1 agrees with the single pole of state-space averaging, while the second pole f_p2 occurs in the range f_p2⩾F_s/π. It is shown that the right-half plane zeros present in the control-to-output transfer functions of the boost, buck-boost, and Cuk converters in continuous conduction mode are also present in discontinuous conduction mode     

An exact expression for resolution cell area in special case ofbistatic radar systems

An exact expression for the bistatic resolution-cell area (A _B) is developed for the special case in which either the transmit or receive antenna has a broad azimuth beamwidth or is omnidirectional. Quantitative examples are presented to illustrate the variation of A_B with location. A comparison is made with the performance of a commonly used approximation formula     

Superconducting antennas

The applicability of superconductors to antennas is examined with emphasis on the roles of external and internal fields. Six potential implementations have resulted. These are superdirective arrays, millimeter-wavelength arrays, electrically small antennas, matching of antennas, phasers for electronic scanning, and traveling-wave array feeds. Most superdirective arrays are still impractical, because of high Q and strict tolerances. Large millimeter arrays appear feasible, due to a major reduction in feed losses. For electrically small antennas, high Q again limits applicability. However, matching of small superdirective arrays and all electrically small antennas, including large transmit antennas, is very attractive, as matching network losses are greatly reduced. Switched-line phasers offer a major size reduction; phase control by means of temperature of a single line poses some problems. Traveling-wave array beam steering by means of temperature also appears possible. The last two utilize the kinetic inductance provided by thin films     

Distribution of general noncentral positive definite quadratic formin K-dimensions

The authors present a series solution using Hermite polynomials to the long-standing problem of computing the probability P that positive definite noncentral quadratic form d(x) of a Gaussian random vector x∈R satisfies d( x)⩽r² for any given r∈R. This problem has wide applications in radar, tracking, air traffic control, etc. The fast-converging series solution presented is very accurate and can be performed rapidly using the recursion relations for Hermite polynomials     

On the uniform sampling of a sinusoidal signal

It is generally accepted that a monochromatic signal such as sin 2πWt (W>0) must be sampled at a uniform rate greater than the ostensible Nyquist rate of 2W samples per to effect a reconstruction of the signal. It is shown that a sinusoid of frequency W Hz is completely determined by its samples taken at the uniform rate of 2r samples per second, where r>0 is arbitrary subject only to the restriction that W ≠kr for any positive integer k. In particular, a pure sinusoid may be sampled uniformly without loss of information at arbitrarily small rates     

Disturbance estimation and compensation in linear systems

Discrete-time estimation and compensation are discussed as a solution to the problems encountered when disturbances are present and degrade the performance of continuous automatic control systems. The method described, under a mild set of conditions, allows the designer to locate the closed-loop system poles substantially anywhere and provide disturbance rejection as large as desired by increasing the dimensions of the disturbance estimator. This estimation/compensation scheme results in a gain characteristic, below some frequency (ω_c ), with a slope of q×20 dB/decade. The value of q and ω_c can be chosen by the designer, within the physical limitations of the problem, so that the system error resulting from either deterministic or stochastic disturbances is sufficiently reduced. The method has been investigated for use with known linear, time-invariant systems     

Performance of receivers with linear detectors

The false-alarm and detection probabilities of a receiver summing M independent outputs of a linear detector are calculated by numerical saddlepoint integration. The saddlepoint approximation is also considered. Both constant-amplitude and Rayleigh-fading signals are treated, and the relative efficiency of the quadratic and the linear detectors for these is calculated for a broad range of values of M . The numerical integration method is the more efficient, the smaller the false-alarm probability or the false-dismissal probability, that is, under just those conditions for which the terms in the Gram-Charlier series oscillate most violently and the series becomes least reliable. The simpler saddlepoint approximation yields values that in those same regions have been found close enough to the exact probabilities to be adequate for most engineering purposes. The larger the number M of samples, the more efficient methods are     

GPS C/N/sub 0/ estimation in the presence of interference and limited quantization levels

The carrier-to-noise density ratio (C/N₀) is considered an important parameter describing the GPS receiver performance. This paper compares the performance of two popular coarse-acquisition (C/A) C/N₀ algorithms appearing in literature: the variance summing method (VSM) (Psiaki et al., 2003, Psiaki, 2001), and the power ratio method (PRM) (Van Dierendonck, 1996, Sayre, 2003), in terms of their estimates in 1) additive white Gaussian noise (AWGN), 2) narrowband continuous wave interference (CWI), 3) their response to quantization and saturation effects, and their 4) dynamic range. The algorithms were implemented as a part of a software receiver. Two LI GPS data sets are examined; one was obtained from a GPS raw data collection setup, while the other was obtained from a GPS signal simulator. The collected set was stored with almost constant C/N₀ level while the simulated one contained variable C/N₀ levels. The effect of adding AWGN on the C/N₀ estimate was directly proportional with the noise power. The C/N₀ estimates suffered more when the CWI frequency was closer to the IF of the receiver. The PRM suffered from saturation at higher C/N₀ levels. The VSM showed good tracking at high C/N₀ levels and better immunity to limited quantization levels, while its C/N₀ estimate suffered from rapid fluctuations in power levels when sudden power steps occurred     

A parallel square-root algorithm for modified extended Kalmanfilter

A parallel square-root algorithm and its systolic array implementation are proposed for performing modified extended Kalman filtering (MEKF). The proposed parallel square-root algorithm is designed based on the singular value decomposition (SVD) and the Faddeev algorithm, and a very large scale integration (VLSI) systolic array architecture is developed for its implementation. Compared to other square root Kalman filtering algorithms, the proposed method is more numerically stable. The VLSI architecture described has good parallel and pipelining characteristics in applying to the MEKF and achieves higher efficiency. For n-dimensional state vector estimations, the proposed architecture consists of O(2n²) processing elements and uses O ((s+17)n) time-steps for a complete iteration at each instant, in contrast to the complexity of O((s+6) n³) time-steps for a sequential implementation, where s≈log n     

The autocorrelation of m-sequences over nonprime finitefields

Nonbinary m-sequences (maximal length sequences) for spread-spectrum communication systems that have a two-level autocorrelation are presented. The autocorrelation function of an m -sequence over the Galois field of q elements GF(q), where q=p^k, for p a prime and k an integer greater than 1, is developed and shown to be bilevel when the elements of GF(q) are expressed as elements of a vector space over the pth roots of unity     

Efficient algorithms for finding the K best paths througha trellis

A set of algorithms is presented for finding the best set of K mutually exclusive paths through a trellis of N nodes, with worst-case computation time bounded by N³log n for a fixed-precision computation. The algorithms are based on a transformation of the K-path trellis problem into an equivalent minimum-cost network flow (MCNF) problem. The approach allows the application of efficient MCNF algorithms, which can obtain optimal solutions orders of magnitude faster than the algorithm proposed by J.K. Wolf et al. (1989). The resulting algorithms extend the practicality of the trellis formulation (in terms of required computations) to multiobject tracking problems with much larger numbers of targets and false alarms. A response by Wolf et al. is included     

Design of high-efficiency series-resonant converters aboveresonance

Power losses in series-resonant converters (SRCs) operated above resonance are examined for the purpose of developing design guidelines leading to SRC designs with the highest possible operating efficiencies. Loss expressions are formulated and analyzed as functions of normalized voltage conversion ratio M and normalized output current J for the controlled transistor switches, antiparallel diodes, bridge diodes, and resonant capacitor. Overall losses range from a low of nearly 9% to a maximum of about 17%. Operating efficiencies corresponding to these losses range from a high of 92% to a low of 85%. Operation at the maximum efficiency of 92% occurs at values of M close to unity and is not highly dependent on J. However, in a practical closed-loop regulated SRC, operation with M too close to unity could provide an insufficient design margin, given component tolerances or other variations     

Optimal serial distributed decision fusion

The problem of distributed detection involving N sensors is considered. The configuration of sensors is serial in the sense that the Jth sensor decides using the decision it receives along with its own observation. When each sensor uses the Neyman-Pearson test, the probability of detection is maximized for a given probability of false alarm, at the Nth stage. With two sensors, the serial scheme has a performance better than or equal to the parallel fusion scheme analyzed in the literature. Numerical examples illustrate the global optimization by the selection of operating thresholds at the sensors     

Detection probabilities for correlated Rayleigh fading signals

Both the method of saddlepoint integration and its associated saddlepoint approximation are applied to calculating the probability of detecting correlated Rayleigh-fading signals in Gaussian noise by means of a detector that integrates M samples of the output of a quadratic rectifier. The quadrature components of the signal samples are modeled as an autoregressive moving-average process, and specific results are exhibited for a first-order Markov process. By these methods the fluctuation loss can be computed for much larger values of M and for larger values of the detection probability than previously. Values calculated by the saddlepoint approximation prove to be close enough to the exact values to be useful over a broad range of signal parameters     

Convergence bounds of an SMI/Gram-Schmidt canceler in colored noise

The performance of the sampled matrix inversion (SMI) adaptive algorithm in colored noise is investigated using the Gram-Schmidt (GS) canceler as an analysis tool. Lower and upper bounds of average convergence are derived, indicating that average convergence slows as the input time samples become correlated. When the input samples are uncorrelated, the fastest SMI algorithm convergence occurs. When the input samples are correlated then the convergence bounds depend on the number of channels N, the number of samples per channels K , and the eigenvalues associated with K×K correlation matrix of the samples in a given channel. This matrix is assumed identical for all channels     

False alarm control using Doppler estimation

A technique which uses maximum-likelihood estimates (MLEs) of target Doppler and target amplitude is developed for rejecting clutter residues. Multiple estimates are made and consistency checks are applied to the estimates. Simulation results indicate that for large clutter-to-noise ratios (C/N⩾55 dB) the probability of false alarm from clutter residues is reduced from 1.0 to below 0.01