基于模拟器的单脉冲雷达幅相修正方法研究

以某型单脉冲测量雷达为研究对象,深入分析研究幅相一致性修正的必要性和修正原理,通过理论分析与公式推导,经过大量的试验验证,提出一种基于目标模拟的单脉冲测量雷达无塔幅相修正方法。该方法实现后,已成功应用于该型单脉冲测量雷达,解决了传统幅相修正方法受外界因素影响大的技术难题,同时降低了建造成本和维护难度,取得了良好的军事和经济效益。     

Detection of Target Multiplicity Using Monopulse Quadrature Angle

The feasibility of using the indicated quadrature angle of arrival of a monopulse radar to discriminate a single target from multiple targets, separated in angle within a radar resolution cell, is investigated. The analysis is performed for steady (fixed) and Rayleigh fluctuating targets which cover a broad range of target characteristics. In both cases, the interfering signals due to noise and clutter in the sum and difference monopulse channels are assumed to be independent, zero-mean Gaussian processes. Detection and false alarm probabilities are evaluated analytically and the receiver operating characteristics are obtained for both fixed and fluctuating target cases. It is shown that multiple targets can be discriminated from a single target condition by integrating the indicated monopulse quadrature angle of arrival from several independent pulses. It is also shown that the probability of detecting multiple targets increases as the fluctuation in the target radar cross section decreases, approaching the fixed amplitude case in the limit.     

Multipath Tracking Errors in Elevation-Scanning and Monopulse Radars

The tracking performance of elevation- scanning and monopulse radars in the presence of multipath propagation are compared. The key difference between these two generic types of radars is the way they respond to moving targets. There are no significant differences between their responses to pure specular multipath, nor to diffuse multipath for targets on radial courses. However, they are found to respond quite differently to the diffuse com ponent for low-altitude crossing targets. For these conditions the tracking errors for elevation-scanning radars may be several times those for monopulse radars.     

Signal Processors and Accuracy of Three-Beam Monopulse Tracking Radar

The problem of implementing a monopulse tracking radar is considered when three beams are used rather than the customary four. Signal processors are developed for both amplitude and phase comparison radar cases and the functional form is given for the general case (a combination or hybrid case). Accuracy is investigated by applying the Cramer-Rao inequality. General results are given for the maximum theoretical accuracy of estimating target amplitude, phase, and position angles when the radar is of the amplitude comparison type. Equations sufficient for obtaining accuracies in the phase comparison and combination cases are included.     

Model-based multifrequency array signal processing for low-angletracking

Tracking low-altitude targets over the sea is problematic because of interference between the direct and reflected signal. Standard monopulse trackers can experience large errors because of multipath maximum likelihood estimation (MLE) has been used to more accurately estimate the target height in the presence of multipath MLE is a model-fitting technique where the model parameters are chosen to maximize the likelihood function. It is shown that the type of observation model has a large effect on performance. Tracking performance is compared using three different observation models employing varying amounts of a priori information. Results are presented for different array sizes: eight and 32-element arrays and two-element subarrays typical of phase monopulse. Performance is compared with that of standard techniques such as Fourier beamforming and phase monopulse     

Analysis and design optimization of monopulse receivers forsecondary surveillance radar

The sensitivity to calibration and component errors of the receiver configurations used for monopulse processing of secondary surveillance radar (SSR) replies is analyzed. The effects of video gain error in amplitude processors and large Gaussian perturbations in phase processors are discussed. Phase processors are shown to be robust to variations in antenna difference pattern null depth. A half-angle phase processor that yields the benefits of phase processing without the sensitivity to system errors associated with conventional implementations is described     

Analysis and Design of Antennas for Air Traffic Collision Avoidance Systems

The analysis and design procedure of an antenna for a CW Doppler radar system being developed for pilot warning of midair collision hazards is presented. The antenna consists of two vertical arrays of half-wavelength dipoles mounted near a circular conducting cylinder. Each vertical array is composed of three vertical dipoles. Each array provides relatively uniform illumination (2-3 dB) in the forward 180 angular segment of the horizontal plane and approximately + 10-150 coverage in the vertical plane. The antenna could be used in a two-mode operation, either in a standard monopulse radar system (sum and difference amplitude patterns) or in a system where amplitude and phase are the measurable quantities.     

Diversity methods in phase monopulse tracking-a new approach

A novel approach relating target glint (difference between the phase-front gradient of the scattered field and the true target direction vector) to the analytic properties of the overall field is used to suggest a method by which the error in conventional (single frequency) phase monopulse trackers can be reduced. The approximate relationship between glint and amplitude is briefly developed, and an improved glint reduction scheme appropriate for single frequency data is described. The effectiveness in reducing direction angle error is demonstrated with simulated data. It is shown how techniques devised for multiple frequency data sets can be applied to multiple aspect data sets.<>     

Statistical description of monopulse parameters for trackingRayleigh targets

The conditional probability density function (pdf) is developed for each monopulse measurement of a Rayleigh target by conditioning the pdf of the complex monopulse ratio on the measured amplitude of the sum signal. The conditional pdf is used to develop the conditional Cramer-Rao Lower Bound (CRLB) for any unbiased estimator of the direction-of-arrival (DOA). Conditional maximum likelihood (CML) and conditional method of moments (CMM) estimators of the DOA are developed along with estimates of the variances associated with the monopulse ratio and DOA estimate. Using simulation results, the performances of the CML and CMM estimators of the DOA are compared with the performance of standard monopulse ratio and the performances of the variance estimators are also studied     

机载雷达中的单脉冲技术

 本文总结机载雷达中单脉冲技术的研究和应用,着重讨论幅度比较系统的关键技术,给出有关数据。 机载雷达中的单脉冲技术着眼于抗干扰性能和特殊应用。这些应用包括空对地测距、角分辨力改进、地形防撞。本文阐述了这些特殊应用。     

Analysis of a Multiplicative Feed System for Monopulse Tracking Applications

In angle tracking antenna applications, the angle sensing boresight accuracy capabilities are important. The ability of an antenna to precisely determine the bearing angle to a point source is determined by the slope of the control function pattern at boresight. In the presence of extraneous interference, the magnitudes of the sidelobe and backlobe responses are important. Control pattern slope (angular sensitivity) is primarily a function of aperture illumination. It can be described by a current distribution in intensity and phase at every point. Once distribution is defined, lobe structure is defined by the associated transform. When more than one feed is used, the distribution will be a vector sum of the individual feed distributions. The resulting secondary pattern can be defined in terms of the amplitude distribution and the phase center locations of the contributing feeds. With a four-horn monopulse configuration, the feed phase centers are displaced from the boresight axis. Placing the phase centers on the boresight axis by rotating the feeds through 45 degrees results in a different set of intensity and phase values. A quite different secondary pattern results. The control function obtained by the subtraction of the powers from a paired set of on-axis feeds results in a lower sidelobe level than that obtained with a conventional monopulse combiner for a given feed taper.     

Performance Analysis of Monopulse Receivers for Secondary Surveillance Radar

In modern secondary surveillance radar (SSR) the monopulse technique is currently introduced for the measurement of the azimuth of the targets. The monopulse technique is based on a suitable processing of signals received by a multiple antenna. In SSR the signals are generated by a transponder on the aircraft as replies to interrogations from ground equipment, and consist of trains of pulses. The monopulse measurements can be carried out on the basis of a single pulse from each train, so that it provides a great number of azimuth estimates. Many monopulse measurement devices exist, corresponding to different processing techniques. From the point of view of accuracy and precision, their behaviors differ with respect to the sources of errors, both internal (noise and imperfect calibrations) and external (interference and propagation effects). The four main types of monopulse receivers are analyzed here with respect to the effects of the internal error sources on the resulting measurement accuracy. After an introductory discussion of the performances of the receivers, a detailed analysis is carried out on the basis of a general mathematical model. The results are given in an analytical form and in some comprehensive diagrams.     

On the Optimum Squint Angles of Amplitude Monopulse Radar and Beacon Tracking Systems

The different quantitative criteria (and numerical results) for analytically determining the optimum squint angle of an amplitude monopulse system in the track mode are compared and reconciled, and the results are generalized to include mutual coupling.     

Unresolved Rayleigh target detection using monopulse measurements

When the returns from two or more targets interfere (i.e., the signals are not resolved in the frequency or time domains) in a monopulse radar system, the direction-of-arrival (DOA) estimate indicated by the monopulse ratio can wander far beyond the angular separation of the targets. Generalized maximum likelihood (GML) detection of the presence of unresolved Rayleigh targets is developed with probability density functions (pdfs) conditioned on the measured amplitude of the target echoes. The Neyman-Pearson detection algorithm uses both the in-phase and quadrature portions of the monopulse ratio and requires no a priori knowledge of the signal-to-noise ratio (SNR) or DOA of either target. Receiver operating characteristic (ROC) curves are given along with simulation results that illustrate the performance and application of the algorithm     

Self-calibrating SSR monopulse receiver

An extension of the monopulse technique for estimating the target azimuth in a secondary surveillance radar (SSR) is considered. The idea is to associate in pairs monopulse measurements coming from the amplitude processor (AP) at the dwell time processing level. This allows the automatic compensation of the bias errors due to the misalignments in the receiver channels, thus eliminating the necessity for periodic system calibration. This dual-pulse technique also allows for the practical use of the dot product receiver as a modification of the AP receiver. This, in turn, implies that the variance of each dual-pulse estimate is uniformly maintained at the monopulse maximum-likelihood level over the whole off-boresight angle (OBA) range     

Comment on "Performance Analysis of Monopulse Receivers for Secondary Surveillance Radar"

The increase in estimation error near boresight with a sum and difference amplitude comparison monopulse receiver can be prevented by using an adequate maximum likelihood estimator.     

比相单脉冲雷达测角与角闪烁研究

比相单脉冲雷达采用和差通道接收信号比相的方法测角。一般认为,雷达事实上并不是在测量目标的方向,而是在测量目标的角闪烁方向。从特殊的两点目标出发,分析了单点目标和复杂目标下比相单脉冲雷达和差通道方式测角的原理与内在异同,探讨了比相单脉冲雷达测角与角闪烁的关系,提出有关雷达测角的新的观点。     

Multiple Gaussian Targets: The Track-on-Jam Problem

When a radar with amplitude comparison monopulse arithmetic encounters signals from multiple Gaussian sources it will "point" to the centroid of the incident radiation. The probability density function (pdf) of the monopulse ratio when N independent samples of difference and sum signals are processed in a maximum likelihood receiver is derived. For finite jam-to-noise ratio the estimate has a bias which is independent of N. The variance in the estimate does however depend upon N. Central moments of order less than or equal 2N - 2 exist and are given by a simple formula. Plots of the pdf and its bias and variance for various jam-to-noise ratios, locations of the centroid with respect to the boresight direction, and number of samples processed are presented in the accompanying figures.