通信传输系统计算机仿真技术

 摘要 本文综述了基于Monte-Carlo方法的各种误码率仿真算法,概括了线性、非线性和编译码通信信道的建模问题,给出了信号通过线性系统的各种仿真方法。最后提出了通信传输系统仿真技术的发展方向和有待深入研究的几个问题。     

高速TCM传输技术及其应用

首先讨论了传统数字传输体制的特点，找出传统调制与编码的分离独立设计是制约数字通信系统性能进一步提高的本质根源；并由此论述了编码与调制相结合的高速数字传输体制，重点讨论了网格编码调制(TCM)技术的基本特点、集合分割映射原理、性能估算，并对TCM在AWGN信道中的性能进行了仿真。     

带通椭圆球面波函数能量聚集性分析

针对带通椭圆球面波函数的能量聚集性及其在通信系统中应用的有效性问题,对带通椭圆球面波函数的能量聚集性进行了理论分析,提出了带通椭圆球面波函数是具有最佳能量聚集性的时限带通函数形式,并与基带椭圆球面波函数、类椭圆球面波函数进行了比较分析,采用基于特征值分解的数值算法对函数进行了仿真分析。理论分析和仿真结果均表明,带通椭圆球面波函数可以应用于大多数现有的传输系统,并能有效地提高系统的功率利用率。     

Adjacent Channel Interference in a Binary Bandpass Communication System

The effect of adjacent channel interference on the probability of error in a binary bandpass communication system with an integrating and dumping detector is investigated. Narrowband filters are assumed in the receiver of the main signal and transmitters of both main and interfering signals. Plots of the probability of error as a function of signal to noise ratio in the main channel or as a function of carrier frequency difference between the main and interfering signals are presented, assuming that the filters are of the Butterworth type. These figures are helpful in the selection of minimal frequency spacing of adjacent channels.     

具有量化器的网络控制系统稳定性分析

数字设备硬件性能的提高和网络控制系统的发展使得量化问题成为目前研究的热点。由于网络控制系统具有带宽约束的特点,数据的传输和处理是零传输延迟和无限高精度的这一假定不再合适,有必要对量化对于控制系统性能的影响进行研究。针对考虑量化器的状态反馈镇定系统的模型从非线性的角度研究了量化器对于控制对象状态动态特性的影响。进而推广到考虑量化器的周期通信的网络控制系统模型上。用Matlab／Simulink仿真算倒,验证了结论的有效性。     

多载波DS—CDMA在数字微波通信系统中的应用

基于数字微波通信系统的特点，介绍了多载波SD-CDMA（Multicarrier-DS-CDMA,即MC-DS-CDMA）调制技术的基本原理及其应用于数字微波通信系统中的具体实现方法。从理论上详细地分析了MC-CDMA工作方式的性能，并将其与传统的数字微波通信系统进行了比较，阐明了将MC-DS-CDMA工作方式应用于数字微波通信系统的必要性。     

Adaptive suppression of passive intermodulation in digital satellite transceivers

For the performance issues of satellite transceivers suffering passive intermodulation interference,a novel and effective digital suppression algorithm is presented in this paper.In con trast to analog approaches,digital passive intermodulation (PIM) suppression approaches can be easily reconfigured and therefore are highly attractive for future satellite communication systems.A simplified model of nonlinear distortion from passive microwave devices is established in consid eration of the memory effect.The multiple high-order PIM products falling into the receiving band can be described as a bilinear predictor function.A suppression algorithm based on a bilinear poly nomial decorrelated adaptive filter is proposed for baseband digital signal processing.In consideration of the time-varying characteristics of passive intermodulation,this algorithm can achieve the rapidness of online interference estimation and low complexity with less consumption of resources.Numerical simulation results show that the algorithm can effectively compensate the passive intermodulation interference,and achieve a high signal-to-interference ratio gain.     

Trunking vs. conventional radio systems

Correctional Service Canada (CSC) has recently replaced the aging, out-of-date radio communications systems in all major CSC facilities with new conventional digital radio systems. Based on very specific and restrictive operational requirements coupled with developments in digital radio technology and the Associated Public Communications Officers (APCO) Project 25 digital radio standards, it was determined that digital radio communications would best meet CSC's needs. The CSC national radio replacement program was completed in March 2000. Switching to a digital radio communications system gave CSC an opportunity to consider changing the existing radio system from a number of conventional, single-site systems to a trunking system. Areas to be considered when determining the architecture for a radio communication network, whether radio trunking systems or conventional radio systems should be used, are presented, In addition, the paper will also outline the requirements and measures taken to keep the radio communication network active and operational while the equipment was converted from an analog technology to a digital one     

基于Windows平台的嵌入式仿真适配技术研究

嵌入式操作系统因其强大的实时性能而被广泛采用,特别是在需要实时通信和任务处理的大型系统中。然而嵌入式操作系统的高价格和不友好的用户界面限制了应用范围。作为一种发展趋势,在通用桌面操作系统(如Windows和Linux)上构建实时应用程序、充分利用其友好的图形用户界面、具备良好的多任务处理性能和出色的硬件兼容性对提高普通桌面操作系统的实时性具有重要意义。在Windows系统上进行实时扩展,以改进其调度和任务处理兼容性。实验结果表明,该扩展对任务处理有很好的效果,可满足应用程序的实时性要求。     

非线性系统中多传感器目标跟踪融合算法研究

 研究了在非线性系统中 ,基于转换坐标卡尔曼滤波器的多传感器目标跟踪融合算法。通过分析得出 :在非线性系统的多传感器目标跟踪中 ,基于转换坐标卡尔曼滤波器 ( CMKF)的分布融合估计基本可以重构中心融合估计。仿真实验也证明了此结论。由此可见分布的 CMKFA是非线性系统中较优的分布融合算法     

Synthetic Aperture Radar System Design for Random Field Classification

The optimum design of synthetic aperture radar (SAR) systems intended to classify randomly reflecting areas, such as agricultural fields, characterized by a reflectivity density spectral density is studied. Assuming areas of known shape and location, the binary case, and a certain Gaussian signal field property, and ignoring interfield interference, the problem solution is given. The optimum processor includes conventional matched filter processing, but is nonlinear; a coherent optical system realization is outlined. The performance is approximated using a x2 assumption and bounded by the Cernov bound. A fundamental design problem involves the system bandwidth analogously, in a special case, as in diversity communication systems; a solution is given based on the Cernov bound. A set of summary design curves is given and exemplified by a satellite SAR system design. Also discussed is the measurement of reflectivity spectral density amplitude with imaging sidelooking (synthetic or ?brute-force?) radars and the maximum likelihood estimator's accuracy and realization with a coherent optical system. It is also shown that a CW modulation is useable if the random reflectivity is, effectively, isotropic. Finally, the reflectivity density spectral density amplitude, when constant over the spatial bandpass of the measuring system, is related to the scattering cross-section density commonly measured.     

Nonlinear Adaptive Control of a Synchronous Machine

A nonlinear adaptive controller for a load-commutated brushless dc machine that allows the machine to develop high torque over a wide range of operating conditions, while satisfying voltage and current constraints on both stator and field circuits, is presented. The approach taken is fundamentally different from past work in that a nonlinear control is formulated from the steady-state model of the synchronous machine. Adaptive algorithms are presented for both the unknown load and motor cases.     

Cryptographic Digital Communication

This paper reviews the fundamentals of cryptographic digital systems and defines and discusses the two basic types of ciphers. The remainder of this article examines the word and bit error rates in digital al communication systems with block or stream ciphers. Upper bounds and ensemble averages of the error rates are obtained for both ciphers. The effect of modulation type on the degradation in communication system performance caused by the addition of cryptography is analyzed. A comparison is made between block and stream ciphers with respect to their effects on degradation.     

Single Channel Per Carrier Satellite Repeater Capacity, Part 2

This paper analyzes the performance of a number of speech processing techniques that have been considered for single voice channel per carrier transmissions via satellite. This transmission mode is applicable to demand assigiment systems, which make possible the most efficient loading of the satellite transponder applications where the traffic at individual earth terminals is not sufficient to justify a substantial number of dedicated channels. The analysis basically determines the operating point for the satellite transponder which minimizes the required earth terminal G/T. Both analog and digital modulation techniques are considered, and the effects of syllabic companding and voice actuation of carriers are demonstrated. The results are presented in general analytic form, applicable to any modulation technique for which carrier-to-noise density ratio, channel width, and guardband width may be specified. Full carrier modulation is assumed. Curves are also furnished showing the required G/T and uplink per carrier EIRP as a function of the number of voice channels per transponder and the transponder gain. "CCIR/CCITT type" speech quality is assumed, together with a transponder El RP and bandwidth typical of current domestic satellite configurations.     

一种宽带信道群时延测量方法

针对VLBI(Very Long Baseline Interferometry,甚长基线干涉测量)系统直接相位差分法的群时延测量精度与分辨率存在矛盾,以及线性最小二乘拟合法不适用于群时延失真链路的问题,采用一种基于非线性拟合的宽带信道群时延测量方法,对出现的问题进行分析与仿真,同时进行了实验验证并获取到实测数据。仿真表明,基于非线性拟合的宽带信道群时延测量方法适用于非线性相位系统,而且群时延的测量精度优于直接相位差分法2个量级。实测数据表明,在270~370 MHz频段内,传统的直接相位差分法和线性拟合测量法已失效,而该方法群时延的测量精度优于0.1ns,由此验证非线性拟合法能够以较高精度进行附加相位和群时延特性测量。     

一种改进的数字滤波平方定时的频域算法

在数字滤波平方定时的频域算法基础上,采用了前端进行带通滤波和后端实施卡尔曼滤波的处理方法对其进行改进。带通滤波器减小了定时误差估计的方差,而卡尔曼滤波则降低了整个定时误差估计过程中噪声的影响。实验与仿真的结果表明,改进后的方法达到了预期的效果。     

飞机总能量控制系统的研究Ⅱ─—非线性控制律综合与仿真

在已设计出的飞机总能量控制系统核心环节的基础上,研究了各种高度和速度控制模态下系统的构成和工作原理;研究了各种非线性安全保护功能在系统中的设置与实现;分析了极限推力状态下,飞机质点能量运动的特点;研究了对轨迹和速度的控制优先级的设置与实现技术;最后对此非线性多变量控制系统进行了综合与仿真,得到了满意的设计与仿真结果。     

Quadrature Sampling with High Dynamic Range

Many radio and sonar systems require signal outputs in complex low-pass form. To achieve this, it is possible to use uniform sampling of the bandpass signal, together with computation of the quadrature component by way of a Hilbert transform. The bandpass to low-pass translation is accomplished by undersampling. A hardware implementation is described which achieves 70 dB spurious-free dynamic range and a bandwidth of 30 kHz.     

Probability Density Function at the Output of the Delay-Lock Discriminator

The first-order probability density at the output of the correlation network of the delay-lock discriminator is determined using the methods developed by Arthur, Kac, and Siegert. The analysis assumes that the input signal is stationary and Gaussian and that the discriminator is locked on. No restrictions are made on the bandpass filter characteristics in the channels.     

星载DBF接收天线误差校正算法

 提出了一种改进的基于子空间的星载数字波束形成（DBF）接收天线的误差校正方法。根据阵列互耦效应主要取决于阵元间的几何距离这一特点,利用阵元空间排布的对称性简化了天线的互耦模型,将天线的互耦效应及射频(RF)通道失配统一为通道间的幅相不一致。通过在基带注入特定的阵内相位差降低了子空间算法的计算复杂度。在建立7单元正六边形平面阵仿真模型的基础上,分析不同信噪比(SNR)环境下校正算法的性能,经比较得出可以通过提高发射信号功率改善误差估计的精度,验证了算法的有效性。仿真分析结果表明该算法在卫星通信系统中有一定的工程应用价值。