共查询到20条相似文献,搜索用时 140 毫秒
1.
基于舰空导弹武器系统的可靠性特征,设计了型号总体贮存可靠性分配与预计的工作流程.针对舰空导弹及各分系统不同的可靠性结构,提出了运用不同的方法或方法组合进行可靠性分配与预计的策略.以某型舰空导弹动力分系统为例,在分析其可靠性基础上,建立了可靠性模型和故障树模型;对该分系统进行了可靠性分配和预计,获得了该分系统设备、组件的... 相似文献
2.
可靠性预计法是三大可靠性分析法之一,应力分析预计法又是一种较精确且应用较广泛的可靠性预计法,本文讨论了可靠预计技术的局限性,提出了在预计复杂的航空电子系统的可靠性时,提高可靠性预计法实用性的几条措施。 相似文献
3.
可靠性预计分基本可靠性预计和任务可靠性预计二类。基本可靠性预计是估计由于产品的不可靠性导致对维修与后勤保障的要求;任务可靠性预计是估计产品在执行任务过程中完成其规定功能的概率。由于基本可靠性预计比较简单,因此本文仅对任务可靠性预计进行深入的研究。 相似文献
4.
研究了电子产品潜在故障的聚类分析方法,提出了计算每一故障类对应分布现了设备可靠性的有效预计.给出了基于故障聚类分析的设备可靠性预计的具体实施步骤. 相似文献
5.
6.
概述了软件可靠性的重要性及预计评估、参数估计方法和数据收集的意义与过程;综述了国外软件可靠性模型的建立情况;最后应用作者开发的软件可靠性预计评估程序(SRPP)对一组数据进行可靠性计算,给出软件可靠度R(t)、MTTF及故障率或故障强度λ(t)等指标;并根据模型有效性的比较准則,对计算结果进行了比较。 相似文献
7.
8.
航空发动机可靠性指标平均故障间隔时间(MTBF)的预计方法有多种,在发动机立项阶段数据缺乏的情况下建议优先选用统计回归法进行发动机可靠性指标MTBF的预测。为了在发动机预先研究阶段能够预计发动机的可靠性水平,利用系数修正的方法对国外的预计回归公式进行修正,可以得到1个新的回归预计公式,但该公式存在飞机参数不明确时无法进行应用的缺点,因此,基于仅利用发动机性能参数进行多元线性统计回归分析得到了新的预计公式,结果表明:新的预计发动机MTBF的回归公式可以在配装飞机不明确的情况下,仅利用发动机本身的性能参数即可大概估算出发动机的MTBF水平,预计效率高,可以为发动机立项论证时可靠性指标MTBF提供参考依据。综合来看,该方法可以实现立项阶段根据飞机参数、发动机性能参数进行发动机可靠性指标MTBF的快速预计,有一定的参考价值。 相似文献
9.
通过对比,揭示了可靠性强化试验在防滑刹车控制盒的设计过程中,能快速激发设计的潜在缺陷,并且以故障的形式表现出来,然后,通过对故障原因的分析,改进设计来消除缺陷,进一步提高产品的可靠性。 相似文献
10.
11.
12.
Real-time performance and reliability are two most important issues in applications of time-triggered controller area network (CAN) bus systems at present. A scheduling matrix of time-triggered CAN-bus system is established using average-loading algorithm. Periodic messages are guaranteed to transmit without delay by distributing independent transmission windows within the system matrix. Considering the traditional CAN-bus transmission mechanism and the time-triggered feature, an algorithm is improved to calculate the worst-case delay of event-triggered messages in time-triggered CAN-bus systems. The failure probability is calculated for event-triggered messages whose worst-case delay exceeds their deadlines. Different levels of redundant structures of CAN-bus circuits are analyzed and the maintenance management is proposed to improve the system reliability. Finally, the reliabilities of different structures are calculated and the influences of maintenance on the system reliability are analyzed. 相似文献
13.
14.
基于二次稳定性准则,从可靠性这一新的角度考虑不确定系统的稳定性问题,提出了基于鲁棒可靠性的不确定系统鲁棒镇定控制器设计方法,将鲁棒控制器设计归结为基于可靠性的优化问题:以鲁棒可靠度为约束,极小化控制代价。依据该法设计的控制系统可满足稳定性意义上的鲁棒可靠性要求,并给出保证系统稳定性所要求的基本参数的最大鲁棒界限。适用于不确定参数的摄动范围准确已知和未知等情况。对F4E型战斗机的稳定控制器设计及对比研究表明了所提方法是实用、有效和可行的。 相似文献
15.
16.
Aviation and aerospace system are typical Phased-Mission Systems(PMSs) featured with varying configuration, phased load condition and cross phase failure correlation. The coupling effect of Functional Dependency(FDEP) and Physical Dependency(PDEP) has a unique influence on the failure behavior of PMS. In this article, the coupling effect is analyzed, and the degradation of components is modeled with the positive drift wiener process, in which the drift coefficient is related to environmental con... 相似文献
17.
构件振动可靠性设计方法初探 总被引:9,自引:4,他引:5
本文提出一种进行构件振动可靠性设计的方法,建立了激振力频率与构件固有频率干涉的概率模型,并利用Goodman曲线,给出了将导致构件损坏的强迫共振响应的概率计算公式及其使用条件。原则上,本文方法对其固有频率相对不太密集的构件更为适用,如航空发动机中的叶片。 相似文献
18.
依据结构强度-工作应力理论模型,应用数理统计方法和对某固体发动机大量试验数据的实例计算,证明了总体变异系数法和样本变异系数法在结构可靠性计算中的一致性。在置信度为0.90时,其结构可靠度大于0.9954。同时表明总体变异系数法是较佳方法,影响结构可靠在的主要因素是样本标准差。 相似文献
19.
该文论述了指数寿命型可靠性增长试验中的Bayes分析方法。文中首先给出了可靠性分析的模型,然后运用历次阶段性试验中的可靠性增长数据建立动态参数模型,在此基础上给出各阶段可靠性增长试验中失效率的Bares估计。 相似文献
20.
《中国航空学报》2020,33(12):3437-3446
Fault tolerance designs are essential techniques for systems that require high levels of reliability, such as aircraft or spacecraft control system. Imperfect Fault Coverage (IFC) may lead to the failure of a system or subsystem even with adequate redundancy. Previous studies of IFC mostly concentrated on evaluating Coverage Factor (CF), whereas the system failure behaviors with IFC have rarely been involved. Failures that occur in low-layer may be covered by high-layer. However, if the coverage is imperfect, uncovered failure will have functional and physical impact on the system behavior. In this thesis, the failure behavior and reliability of IFC of multi-layer systems are studied and a Binary Decision Diagram (BDD)-based modeling and simulation method are proposed to evaluate system reliability. As a case, the failure behavior of an aero engine electronic controller with IFC is studied. The results show that the IFC may impact system behavior without taking the IFC into account, the system maintenance intervals may reduce, and thus the maintenance costs will increase. 相似文献