基于自适应滤波的电控旋翼桨距控制试验

提出了基于自适应滤波的电控旋翼桨距控制方法,并基于此开发了双闭环电控旋翼桨距控制系统,利用模型电控旋翼试验台进行了悬停状态下的桨距控制试验.试验结果表明:所研制的双闭环电控旋翼桨距控制系统能够有效、可靠地实现襟翼操纵和桨距控制.基于自适应滤波的桨距控制律可以很好地实现电控旋翼的总距、周期变距以及总距耦合周期变距操纵;桨距响应幅值满足要求,相位滞后约在10°～15°之间;从襟翼偏转到桨叶变距响应的滞后约20°～30°.不同桨叶/襟翼自身的结构及气动特性差异,会一定程度的影响桨距控制的实际效果.      

柔性航天器振动主动抑制及姿态控制

针对柔性航天器柔性附件振动主动抑制及姿态高精度快速稳定问题,研究了一种输入成形器（IS）-自适应有限时间干扰观测器（FDO）-有限时间积分滑模控制器综合的设计方法。首先,基于柔性模态的频率及阻尼信息,获得能够有效抑制柔性振动的输入成形器形式,并与系统参考输入进行卷积,得到期望参考输入;其次,基于航天器动力学模型,设计一种新型的自适应有限时间干扰观测器,避免了综合干扰上界必须已知的约束,且保证干扰估计误差有限时间收敛至零,实现对干扰及残余振动影响的快速精确估计;最后,基于观测器的估计值,设计多变量有限时间积分滑模控制器,保证对期望参考输入的高精度快速跟踪控制,并进行严格的稳定性证明。仿真结果表明,该综合设计策略能够保证柔性附件振动抑制75%,姿态稳定度达到10^-4数量级。     

Leading-edge flow separation control over an airfoil using a symmetrical dielectric barrier discharge plasma actuator

In order to promote an in-depth understanding of the mechanism of leading-edge flow separation control over an airfoil using a symmetrical Dielectric Barrier Discharge(DBD) plasma actuator excited by a steady-mode excitation, an experimental investigation of an SC(2)-0714 supercritical airfoil with a symmetrical DBD plasma actuator was performed in a closed chamber and a low-speed wind tunnel. The plasma actuator was mounted at the leading edge of the airfoil.Time-resolved Particle Image Velocimetry(PIV) results of the near-wall region in quiescent air suggested that the symmetrical DBD plasma actuator could induce some coherent structures in the separated shear layer, and these structures were linked to a dominant frequency of f0= 39 Hz when the peak-to-peak voltage of the plasma actuator was 9.8 kV. In addition, an analysis of flow structures without and with plasma actuation around the upper side of the airfoil at an angle of attack of18° for a wind speed of 3 m/s(Reynolds number Re = 20000) indicated that the dynamic process of leading-edge flow separation control over an airfoil could be divided into three stages. Initially, this plasma actuator could reinforce the shedding vortices in the separated shear layer. Then, these vortical structures could deflect the separated flow towards the wall by promoting the mixing between the outside flow with a high kinetic energy and the flow near the surface. After that, the plasma actuator induced a series of rolling vortices in the vicinity of the suction side of the airfoil, and these vortical structures could transfer momentum from the leading edge of the airfoil to the separated region, resulting in a reattachment of the separated flow around the airfoil.     

应用保护映射理论的高超声速飞行器自适应控制律设计

针对高超声速飞行器包线范围广、参数变化大的控制需求,应用保护映射理论提出一种高超声速飞行器的自适应控制律设计方法。首先建立整个飞行包线内的线性变参数(LPV)模型,在参数变化边界点设计一个初始的控制结构和参数,然后基于保护映射理论分析初始控制结构使闭环系统稳定的参数范围,通过迭代自动获取整个包线内满足性能指标的控制参数,进而通过多项式拟合设计出高超声速飞行器自适应控制律。所提出的方法能够根据初始控制结构自动寻找一系列满足性能要求的控制器参数,并确定这些控制参数满足闭环系统稳定的设计范围。仿真结果表明,所设计的自适应控制律能够确保高超声速飞行器大包线的设计要求,实现闭环系统的鲁棒稳定。     

基于前缘缝翼微型后缘装置的多段翼型被动流动控制

以麦道航空公司的三段增升构型为研究模型,采用剪切应力输运(SST)k-ω湍流模型在C-H型多块结构网格上求解二维非定常雷诺平均Navier-Stokes方程,研究了前缘缝翼微型后缘装置(MTED)在多段翼型被动流动控制中的应用。由于MTED改变了实际的缝翼缝道参数,因此首先研究了作为主要改变量的缝道宽度对该三段翼型气动性能的影响,当缝道宽度从参考构型的2.95%c增加至3.98%c时,最大总升力系数约减小4.61%。当在不同缝道宽度基本构型上增加相同MTED时,计算结果表明它对各个翼段的影响定性一致,即前缘缝翼升力增加、主翼升力减小以及后缘襟翼升力基本不变化。这些升力变化的综合作用是:MTED构型线性段总升力系数的变化不大,失速段的变化取决于缝道宽度,当缝道宽度为3.98%c时,高度为0.50%c的MTED构型的最大总升力系数约增加6.98%。     

Trajectory tracking control of a VTOL unmanned aerial vehicle using offset-free tracking MPC

Designing a stable and robust flight control system for an Unmanned Aerial Vehicle(UAV) is an arduous task. This paper addresses the trajectory tracking control problem of a Ducted Fan UAV(DFUAV) using offset-free Model Predictive Control(MPC) technique in the presence of various uncertainties and external disturbances. The designed strategy aims to ensure adequate flight robustness and stability while overcoming the effects of time delays, parametric uncertainties,and disturbances. The six degr...