首页 | 本学科首页   官方微博 | 高级检索  
     检索      

带前体压缩的前掠侧压式进气道实验及数值研究
引用本文:金志光,张堃元.带前体压缩的前掠侧压式进气道实验及数值研究[J].推进技术,2005,26(6):508-512.
作者姓名:金志光  张堃元
作者单位:南京航空航天大学,能源与动力学院,江苏,南京,210016
基金项目:国家“八六三”计划702专题(2003AA723020).
摘    要:为提高侧压式进气道流量系数,设计了一种前机身顶压与侧压相结合的前掠侧压式进气道,在马赫5.3小高超风洞中完成吹风实验,并用FLUENT软件对进气道流场进行了数值模拟,分析了主要流动特征,获得了进气道基本性能。实验结果表明,马赫5.3设计状态下,这种前掠侧压式进气道的流量系数可以达到0.85以上,比一般后掠进气道提高20%左右。通过数值及实验研究发现,进气道下游隔离段内由于上下壁面的巨大压差导致顶板对称面两侧出现对涡,涡面将隔离段内的流动分为高速高能区与低速低能区两种流动。

关 键 词:超燃冲压发动机  前掠侧压式进气道  风洞实验  数值仿真
文章编号:1001-4055(2005)06-0508-05
收稿时间:2005-03-19
修稿时间:2005-07-28

Experimental and numerical investigation of a forward sweep sidewall compression scramjet inlet with forebody compression
JIN Zhi-guang and ZHANG Kun-yuan.Experimental and numerical investigation of a forward sweep sidewall compression scramjet inlet with forebody compression[J].Journal of Propulsion Technology,2005,26(6):508-512.
Authors:JIN Zhi-guang and ZHANG Kun-yuan
Institution:Coll.of Energy and Power Engineering,Nanjing Univ.of Aeronautics and Astronautics,Nanjing 210016,China;Coll.of Energy and Power Engineering,Nanjing Univ.of Aeronautics and Astronautics,Nanjing 210016,China
Abstract:A generic forward sweep sidewall compression scramjet inlet with forebody compression was designed to improve the performance of mass capture.Experiment was conducted in NUAA 100mm×100mm Mach 5.3 wind tunnel. The flow field was numerically simulated by means of FLUENT software.Based on the numerical and experimental result,typical characteristics of the flow field were identified,and the main performance parameters were obtained.Experimental results indicate at Mach 5.3 design point,the forward sweep sidewall compression inlet has a mass capture ratio of above 0.85,which is about 20% higher than that of the conventional backward sweep inlet.Combined with the numerical result,Pitot-pressure distribution at the exit of the isolator shows a pair of vortexes occuring at the bottom of the isolator because of the high pressure difference between topwall and bottomwall,which separates the flow of the isolator into two regions.One region has high speed and high total pressure recovery and the other has low speed and low total pressure recovery.
Keywords:Scramjet  Forward-sweep sidewall compression inlet  Wind tunnel experimentation  Numerical simulation
本文献已被 CNKI 万方数据 等数据库收录!
点击此处可从《推进技术》浏览原始摘要信息
点击此处可从《推进技术》下载免费的PDF全文
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号