| 电子束熔丝沉积快速制造成型技术与组织特征 |
| |
| 引用本文： | 陈哲源,锁红波,李晋炜.电子束熔丝沉积快速制造成型技术与组织特征[J].航天制造技术,2010(1). |
| |
| 作者姓名： | 陈哲源 锁红波 李晋炜 |
| |
| 作者单位： | 北京航空制造工程研究所高能束流加工技术重点实验室; |
| |
| 摘 要： | 利用电子束熔丝沉积快速制造技术制备了TC4钛合金薄壁结构和实体结构试样,分析了成型技术特点,探讨了组织形貌特征及形成机制。研究表明:对于薄壁结构,采用合理的工艺参数,获得的熔积层的宽度为7.4mm,层高为1.5mm;结构纵截面的组织形貌特征是原始β柱状晶与沉积高度方向大约成15°角,较为粗大,宽3～5mm,单个柱状晶贯穿几层到十几层熔积层不等。对于实体结构,熔积间距为4.7mm时得到的试样表面较为平整,熔积高度基本一致;试样纵截面可观察到明显的层带,而原始β柱状晶垂直向上生长。
|
| 关 键 词： | 电子束 熔丝沉积 快速制造 成型特点 |
The Forming Character of Electron Beam Freeform Fabrication |
| |
| Chen Zheyuan Suo Hongbo Li Jinwei.The Forming Character of Electron Beam Freeform Fabrication[J].Aerospace Manufacturing Technology,2010(1). |
| |
| Authors: | Chen Zheyuan Suo Hongbo Li Jinwei |
| |
| Institution: | Beijing Aeronautical Manufacturing Technology Research Institute;Beijing 100024 |
| |
| Abstract: | Electron Beam Free Form Fabrication(EBF3) is an advanced rapid manufacturing technology based on electron beam welding with filler wire.In this paper,two kinds of TC4 titanium components were prepared by EBF3,one is thin-wall parts and the other is cubic samples with large dimension.The depositing characteristics during the process,microstructure appearances and formation mechanism were discussed in detail.The results show that a single-clad track with the width of 7.4 mm and the height of 1.5 mm were prope... |
| |
| Keywords: | electron beam fused deposition rapid manufacturing forming character |
| 本文献已被 CNKI 等数据库收录！ |
|
