首页 | 本学科首页   官方微博 | 高级检索  
     检索      

微型脉冲推力器点火启动过程计算与点火药量选择
引用本文:周海清,张平.微型脉冲推力器点火启动过程计算与点火药量选择[J].固体火箭技术,2004,27(4):276-279.
作者姓名:周海清  张平
作者单位:北京理工大学机电工程学院,北京,100081
摘    要:建立了微型脉冲推力器点火启动模型,模型中考虑了两相流动和颗粒对推进剂表面的冲击传热。根据数值计算结果,给出了不同产物颗粒含量下的点火药量选择参考范围。该参考范围对于产物颗粒含量小于50%的点火药是适用的;由于过多的颗粒含量将对装药表面产生强烈的热力冲蚀破坏作用,产物颗粒含量超过50%的点火药不适合微型火箭发动机。

关 键 词:微型火箭发动机  脉冲推力器  点火  两相流  瞬态热分析  装药设计  数值分析
文章编号:1006-2793(2004)04-0276-04
修稿时间:2004年6月21日

Ignition start-up course calculation and ignition charge mass selection of impulse micro-thruster
Abstract:Ignition start-up model of impulse micro-thruster is established, considering two phase flow and impact heat transfer of particle on the surface of propellant. Based on numerical calculation results, selection range of ignition charge mass with different particle content is given. It is suitable for ignition charge whose particle content is less than 50%. Because excessive particle content can cause strong heat impact failure on the grain surface, ignition charge whose particle content is more than 50% isn't suitable for micro-rocket motor.
Keywords:micro-rocket engine  impulsive thruster  ignition  two-phase flow  transient heat analysis  grain design  numerical analysis
本文献已被 CNKI 维普 万方数据 等数据库收录!
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号