| 各向异性板料成形极限面的研究 |
| |
| 引用本文： | 王辉,高霖,陈明和,赵明琦.各向异性板料成形极限面的研究[J].南京航空航天大学学报,2007,39(3):329-332. |
| |
| 作者姓名： | 王辉 高霖 陈明和 赵明琦 |
| |
| 作者单位： | 1. 南京航空航天大学机电学院,南京,210016
2. 马鞍山钢铁公司技术中心,马鞍山,243000 |
| |
| 摘 要： | 成形极限曲线(FLD)是表示板料成形性能的重要指标。由于板料各向异性的存在,导致了使用1条FLD来表示板料整个面内的成形极限存在很大误差。通过试验分析了板料面内的各向异性对板料应力和应变成形极限曲线的影响,研究了利用三维空间的成形极限曲面代替二维坐标下的FLD来表示材料整个面内的成形极限的方法,经过分析认为板料成形极限面可以为板料成形有限元仿真提供更准确的成形极限判据。
|
| 关 键 词： | 板料成形 成形极限面 各向异性 有限元仿真 |
| 文章编号： | 1005-2615（2007）03-0329-04 |
| 修稿时间： | 2006-03-022006-05-19 |
Forming Limit Surface of Anisotropic Sheet Metal |
| |
| Wang Hui,Gao Lin,Chen Minghe,Zhao Mingqi.Forming Limit Surface of Anisotropic Sheet Metal[J].Journal of Nanjing University of Aeronautics & Astronautics,2007,39(3):329-332. |
| |
| Authors: | Wang Hui Gao Lin Chen Minghe Zhao Mingqi |
| |
| Abstract: | Forming limit diagram(FLD) and forming limit stress diagram(FLSD) are widely used as a valuable tool for analyzing sheet metal forming.However the normal FLD or FLSD assumes that the forming limit is isotropic on the plane of the sheet.In order to more accurately capture the physics of the material behavior,the issue of forming limit anisotropy must also be addressed.The influence of the anisotropy on the plane of the sheet to the FLD and FLSD is studied by the experiment.The forming limit surface in sheet metal forming can give a more accuracy criterion for the failure of sheet metal in FEM simulation. |
| |
| Keywords: | sheet metal forming forming limit surface anisotropy finite element simulation |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
