首页 | 本学科首页   官方微博 | 高级检索  
     检索      

罐车制动时液体晃动的仿真分析
引用本文:刘奎,康宁.罐车制动时液体晃动的仿真分析[J].北京航空航天大学学报,2009,35(7):799-803.
作者姓名:刘奎  康宁
作者单位:北京航空航天大学,交通科学与工程学院,北京,100191;北京航空航天大学,交通科学与工程学院,北京,100191
摘    要:采用Volume of Fluid (VOF) 模型对罐车制动时液体的晃动进行了数值模拟,对单室受力、受力位置及整车轴荷分配进行了计算,并通过与实验结果的对比验证了计算方法的可靠性.计算结果表明,无防波板时,随减速度增加,单室 x,y方向受力峰值增大,整车轴荷比增大;随充液比增加,单室x方向受力峰值先增大后减小,y 方向受力峰值增大,制动初始与结束时充液比越大轴荷比越大,1s左右充液比越大轴荷比越小;单室带防波板时,随防波板面积增加, x,y 方向受力峰值减小,当防波板面积大于横截面的40%时,增加防波板面积能显著改善罐体受力,且防波板面积越大轴荷比峰值越小.

关 键 词:罐车  VOF模型  液体晃动  两相流
收稿时间:2008-06-30

Simulation of liquid slosh in braking process of tank truck
Liu Kui,Kang Ning.Simulation of liquid slosh in braking process of tank truck[J].Journal of Beijing University of Aeronautics and Astronautics,2009,35(7):799-803.
Authors:Liu Kui  Kang Ning
Institution:School of Transportation Science and Engineering, Beijing University of Aeronautics and Astronautics, Beijing 100191, China
Abstract:The liquid sloshing in braking process of tank truck was simulated by volume of fluid(VOF) model.The forces and their locations of a single room and weight distribution of a truck were calculated.The reliability of the calculation method was validated by comparing with experimental results.The results show that the maximum of Fx(force in direction x),Fy(force in direction y) and C(The ratio of weight acting on the front axle and rear axle) increase as the deceleration increases without a baffle.When the liq...
Keywords:tank truck  volume of fluid (VOF) method  liquid sloshing  two phase flow
本文献已被 CNKI 万方数据 等数据库收录!
点击此处可从《北京航空航天大学学报》浏览原始摘要信息
点击此处可从《北京航空航天大学学报》下载免费的PDF全文
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号