Aerodynamics of smart flap under ground effect

Aerodynamic characteristics of two-dimensional smart flap under the ground effect have been assessed by a numerical simulation. In this process, a pressure-based implicit procedure to solve Navier–Stokes equations on a nonorthogonal mesh with collocated finite volume formulation is used. The boundedness criteria for this procedure are determined from the Normalized Variable Diagram (NVD) scheme. The procedure incorporates the k–ε eddy–viscosity turbulence model. Cantilever beam with uniformly varying load with roller support at the free end is considered for the configuration of the smart flap. The method is first validated against experimental data. Then, the algorithm is applied for turbulent aerodynamic flows around airfoil with smart and conventional flaps for different attack angle, flap angle and ground clearance where the results of two flaps are compared. The comparisons show that the quality of the solution is considerable.     

直升机桨叶连续后缘襟翼设计与气动影响分析

在直升机旋翼减振应用中,连续后缘襟翼和常规分离式襟翼相比具有重量轻、结构紧凑、气流平稳等优点。选用压电纤维复合材料作为驱动材料,基于NACA23012翼型设计带有连续变形后缘襟翼的桨叶段,对襟翼及其驱动结构进行选材设计分析;采用流固耦合方法分析连续后缘襟翼对剖面翼型气动特性的影响。结果表明:连续后缘襟翼在直升机桨叶工作迎角、马赫数范围内可实现有效偏转,显著改变翼剖面气动升力和力矩,证明了连续后缘襟翼在旋翼减振控制中的潜在应用价值。     

Gurney Flap绕流气动特性研究

采用C-H型多块结构网格和SST k-ω湍流模型求解二维定常雷诺平均NS方程,对NACA4412单段翼型后缘附近和NACA63(2)-215B多段翼型襟翼后缘附近的Gurney Flap绕流进行了数值模拟。讨论了局部网格对计算结果的影响,重点研究了Gurney Flap位置和高度对气动特性的影响。计算结果表明:对于NACA4412单段翼型,Gurney Flap位置对气动性能的影响较小,但随着高度的增加,零升攻角和失速攻角减小,最大升力系数增大,同时阻力系数和力矩系数增加;对于NACA63(2)-215B多段翼型,Gurney Flap对气动性能的影响类似于NACA4412单段翼型情形。     

球面收敛调节片喷管RCS数值模拟研究

结合物理光学迭代法(IPO)和等效棱边电磁流法(EEC),自主开发了电大尺寸腔体电磁散射特性计算程序,并通过对某试验模型雷达散射截面积(RCS)进行计算,完成了程序的可靠性验证。利用该程序对带有电磁信号遮挡板且采用3种不同尾缘修形技术的球面收敛调节片矢量喷管(SCFN)进行了RCS数值模拟研究。结果表明:随着入射方位角的增大,喷管的RCS整体上有减小的趋势;喷管尾缘的修形只有在雷达波以较大方位角入射时对减小RCS效果明显;电磁信号遮挡板的存在很大程度上减弱了喷管的电磁信号特征。     

大型客机后缘襟翼滑轨整流罩气动外形设计方法

大型客机后缘襟翼机构伸出机翼下表面会带来气动损失,必须设计相应整流罩。整流罩的外形尺寸对气动力影响较大,会直接影响飞机的气动特性。设计整流罩时应该遵循整流罩外形设计要求,使其引起的高速巡航阻力尽可能小。在查阅相关文献、对比研究大量整流罩图片、分析研究计算机辅助设计(CAD)中NURBS曲面曲线描述方法的基础上,建立了一套详细的大型客机后缘襟翼滑轨整流罩外形设计方法,该方法在满足整流罩包裹住机构、减小气动损失等基本要求的同时,缩短了整流罩设计周期。     

民机襟翼用滑轨材料磨损表面图像分析

利用MZ-4018滚动轴承滑轨摩擦磨损试验机进行磨损试验,通过体视显微镜和工业相机对襟翼滑轨材料试验件磨损表面进行图像采集;采用wiener滤波和Laplace算子进行预处理,以实现图像平滑,增强图像的边缘和细节信息;迭代法和最大间类方差法确定两阈值,以此作为选取种子点的标准,确定生长准则后进行图像分割;最后利用形态学方法进行磨损边界提取并对磨损面积进行测算;实现了对襟翼滑轨材料磨损特征的定量分析。     

大型飞机高升力系统的发展及关键技术分析

高升力系统是大型飞机实现安全起飞和着陆功能的独立分系统,对飞机的安全性和经济性等方面有重要影响.现代大型飞机的高升力系统在作动能量传输方式上采用集中驱动,在控制信息处理模式上采用容错式双余度数字电传控制.高升力系统的关键技术体现在高效率机械作动系统的设计和处理多状态复杂控制逻辑的高升力控制系统设计等方面.     

Performance analysis of variable speed tail rotors with Gurney flaps

Gurney Flaps (GFs) are used for improving the performance of variable speed tail rotors. A validated analytical helicopter model able to predict the main and tail rotor power is utilized. The fixed height GF has substantially small influence on the tail rotor power in hover and low to medium speed forward flight, and can obtain significant power reduction in high speed flight. This ability can be enhanced by decreasing the tail rotor speed. With the deployment of GF, the collective pitch of the tail rotor decreases, and the maximum tail rotor thrust increases. The GF can compensate the reduction of the maximum thrust by the decrease in the tail rotor speed. The GF with a height of 5% of the chord length can almost remedy 50% of the thrust reduction introduced by decreasing 10% of the tail rotor speed. With the increase of GF height, the maximum thrust generated by the tail rotor increases. The GF with larger height can cause the increase in the tail rotor power in hover and low to medium speed flight. The retractable GF can obtain more power savings than the fixed height GF. However, the benefit is substantially small even in high speed flight. Considering the side effects introduced by the active GF, the fixed height GF may be more preferable. The mechanism for the retractable GF to generate more tail rotor thrust is to increase the lift in advancing side due to the higher dynamic pressure.     

飞机后缘襟翼运动同步性设计和计算

在飞机的起飞、降落、巡航飞行中,襟翼运动起着重要的作用.全机有多块内、外襟翼,当分别绕各自不同的转轴运动时,会产生不同的圆锥运动.为实现所有的内、外襟翼同步运动,需对每块襟翼上的不同作动器进行精心设计、布局,及对作动器运动参数进行计算.这既非常关键,又相当复杂,一直是设计中的难题.介绍了现代客机襟翼作动器运动学计算方法...     

Y─12飞机起飞操纵性能改进措施

针对Ｙ─１２（Ⅱ）型飞机在进行小重量起飞性能试飞时出现的主轮自动离地现象进行了讨论分析，找出了产生主轮自动离地现象的主要原因，提出了解决问题的方法和改进措施，并分析研究了对起飞性能的影响因素，为改善起飞操纵性提供了依据。