单向电永磁作动器结构优化与动态特性分析

针对电磁作动器的使用要求，设计出一种具有能耗低、吸力大及响应快等特点的新型单向电永磁作动器。结合有限元仿真软件，利用有限元法研究作动器的结构参数如铁芯齿形结构、平面结构、无永磁结构、铁芯的倾斜角度及衔铁位移（气隙厚度）等因素对作动器电磁吸力和响应速度的影响。结果表明，电磁吸力随着作动衔铁位移的增加而大幅度减小；倾角结构的铁芯设计能使作动器性能达到最佳，且铁芯的倾斜角度为50°时，电磁吸力有最大值3071N。     

污水处理装置在冶金行业中的应用

对污水处理装置的技术参数、技术要求及设计方案的选择、工作原理做了进一步的阐述。对工业循环冷却水的处理有实际指导意义。     

表贴式永磁电机的两种充磁方式

研究了表贴式永磁电机的两种充磁方式。首先利用已有文献电机参数验证了有限元模型的正确性,对比分析了两种充磁方式下电机磁密和磁钢磁势的分布特点,研究表明内转子结构平行充磁方式具有提供更大的气隙磁通潜力,而外转子结构则相反。接着研究了两种充磁方式,不同气隙下气隙总磁通随极对数和磁钢厚度的变化规律。同时明确了两种充磁方式各自使用场合,给出了最佳磁钢厚度的取值范围。本文工作有助于正确选择表贴式永磁电机的充磁方式和磁钢厚度,以发挥磁钢潜力,改善电机性能。     

新建他激反激变换器方程及其解析解

引用文 [1 ]的思路 ,寻找他激反激变换器的运行状态特征参量 (磁通密度增量、剩余磁通密度和占空比 )与构成这一变换器的基本物理参量之间的函数关系。首先阐明由于频率给定 ,他激反激变换器稳态运行时会出现无剩磁工况和有剩磁工况两种。而后确定这两种工况下 ,磁路等效储能空间单位体积每个周期的传输能量 (命名为“磁能传输密度”)。在这基础上 ,分别建立和解出他激反激变换器在不同工况下稳定运行时应满足的方程。最后根据所得的解析解阐明这种变换器的特性。本文和文 [1 ],以磁路分析为基础建立了一种新的反激变换器理论。     

质量矩导弹的神经网络及自适应非线性控制

本文对质量矩控制导弹的动力学方程简化和控制系统的设计进行了研究。详细阐述了所提出的控制方法，介绍了径向基单隐层神经网络进行误差补偿的算法原理，用Lyapunov理论证明了所采用方法的稳定性。在给出了质量矩导弹的六自由度动力学方程和简化后的方程后，用所提出的方法设计控制系统。通过仿真分析，得出了本文所提出的方法具有较好的误差补偿能力的结论。     

Investigation of the differential rotation of the large-scale magnetic elements for the solar activity cycles 20 and 21

The differential rotation of the patterns of the large-scale solar magnetic field during solar activity cycles 20 and 21 is investigated. Compact magnetic elements with the polarity of the general solar magnetic field have larger speed of rotation than the elements with the opposite polarity. The surface of the Sun was divided by 10°-zones. In all of them the average rotation rate of the magnetic elements with negative polarity is little higher than that of the magnetic elements with positive polarity, except for 50°-zone of the south hemisphere and at the 10° latitude of the north hemisphere.

The rates of differential rotation for large-scale magnetic elements with negative and positive polarities have similar behavior for both cycles of the solar activity.

The rotation rate varies at polarity reversal of the circumpolar magnetic fields. For the cycle No 20 in 1969–1970 the threefold reversal took place in the northern hemisphere and variations of rotation rate can be noticed for magnetic elements both with positive and negative polarity for each 10°-zone in the same hemisphere.     

Reconstructed 3-d magnetic field structure and hard X-ray two ribbons for 2000 Bastille-day event

The Bastille-day event in 2000 produced energetic 3B/X5.6 flare with a halo CME, which had great geo-effects consequently. This event has been studied extensively and it is considered that it follows the two-ribbon flare model. The flare/CME event was triggered by an erupting filament and TRACE observations showed formation of giant arcade structures during the flare process. Hard X-ray (HXR) two ribbons revealed for the first time in this flare event (Masuda et al., 2001). The reconstruction of 3-D coronal magnetic fields revealed a magnetic flux rope structure, for the first time, from extrapolation of observed photospheric vector magnetogram data and the flux rope structure was co-spatial with portion of the filament and a UV bright lane (Yan et al., 2001a, 2001b). Here we review some recent work related to the flux rope structure and the HXR two ribbons by comparing their locations and the flux temporal profiles during the flare process so as to understand the energy release and particle accelerations. It is proposed that the rope instability may have triggered the flare event, and reconnection may occur during this process. The drifting pulsation structure in the decimetric frequency range is considered to manifest the rope ejection, or the initial phase of the coronal mass ejection. The HXR two ribbons were distributed along the flux rope and the rope foot points coincide with HXR sources. The energy dissipation from IPS observations occurred within about 100 R _⋅ is consistent with the estimate for the flux rope system. This revised version was published online in August 2006 with corrections to the Cover Date.     

一个简单有效的磁记录纠错系统

介绍一种简单有效的纠错编码方法 ,用于资源卫星高密度数字磁记录器 ,使误码率由 10 -6降低到 10 -11,同时介绍它的基本工作原理、实现方案及试验结果。     

电励磁双凸极电机调速系统的原理与实现

介绍了新型电励磁双凸极电机的结构和原理，然后结合全桥变换器阐述了电励磁双凸极电机的控制方法，接着详细介绍了电励磁双凸极电机转速、电流双闭环控制调速系统的原理和实现方法，最后以一台500W12/8极电励磁双凸极电机调速系统为例进行了系统实验。实验结果表明，电励磁双凸极电机调速系统具有结构简单、控制方便和良好的动静态性能。     

镀膜光纤声光相位调制器频率响应特性的研究

本文对光纤声光相位调制器（OF—AOPM）的频率特性进行研究。分析了OF—AOPM的调相原理，研究结果表明：在调制频率远离氧化锌压电薄膜的半波谐振频率的时候，光相位的调制不仅依靠径向应力。同时还依靠轴向应力。通过同时考虑径向和轴向应力的变化，得出了OF—AOPM在整个频率域范围内的响应特性。