事件触发机制下的充液航天器姿态控制

针对液体大幅晃动、通信资源受限的充液航天器姿态控制系统，提出一种自适应滑模控制与事件触发机制相结合的控制策略。首先，针对固-液耦合的充液航天器姿态控制系统，选用滑模变结构控制来削弱液体大幅晃动的非线性影响，并设计自适应更新律在线估计不确定参数来提高系统的鲁棒性。然后，考虑星载计算机资源的限制，设计相对阈值的事件触发机制来决定控制输入信号的更新，从而减少控制器与执行器之间的信号更新对通信网络的占用。最后，仿真结果表明，在液体大幅晃动下，所提控制策略不但可以使航天器姿态控制系统最终收敛到任意小的界内，而且可以减少96%的控制信号传输，减轻航天器的通信负载。      

SiC/CVD SiC复合涂层的抗氧化及抗热震性能研究

为了提高C/SiC复合材料耐高温性能,采用泥浆浸渍裂解与真空化学气相沉积(CVD)在材料表面制备了SiC/CVD SiC复合涂层,通过XRD、SEM分析了涂层组成与结构;研究了复合涂层的高温抗氧化(700～1 500℃)和抗热震性能。结果表明,泥浆浸渍法制备的SiC涂层具有一定的封孔效果,可使材料开孔率下降,但高温抗氧化效果并不佳,1 200℃氧化10 min后材料弯曲强度保留率下降明显仅有86%。CVD SiC涂层结构致密,与SiC封孔涂层结合较好,在700～1 500℃具有较好的抗氧化效果,随着氧化温度的升高,氧化后涂层完好,表面O元素逐渐增加,材料失重率缓慢增加但不大于0.5%,且材料性能并未下降。涂层材料在1 200℃-10 min短时热震5次后材料弯曲强度保留率仍有95%以上,且未出现开裂、剥落等热震损伤。在1 200℃-30 min长时热震10次后,涂层材料基本被完全氧化,材料失去保护作用,弯曲强度下降至90%左右。     

不同重力环境下空间机构电机驱动力差异

为了分析空间机构在不同重力环境中的驱动力差异，以单关节机械臂为研究对象，进行不同重力环境下直流电机驱动力差异分析。首先基于拉格朗日方程推导出单关节机械臂的动力学模型，为分析不同重力环境下，负载、摩擦和转速的变化对电机驱动力的影响，通过设计一套基于单关节驱动的机械臂试验装置，进行地面重力环境、地面模拟微重力环境和落塔微重力环境试验。然后基于试验数据详细分析了不同重力环境下空间机构电机驱动电流的差异，并基于试验数据对电机动力学方程中的摩擦参数进行辨识，从而获得基于试验数据修正的机械臂动力学仿真模型，为空间机构动力学设计与应用提供理论与试验依据。     

Backstepping sliding-mode control of stratospheric airships using disturbance-observer

In the presence of unknown disturbances and model parameter uncertainties, this paper develop a nonlinear backstepping sliding-mode controller (BSMC) for trajectory tracking control of a stratospheric airship using a disturbance-observer (DO). Compared with the conventional sliding mode surface (SMS) constructed by a linear combination of the errors, the new SMS manifold is selected as the last back-step error to improve independence of the adjustment of the controller gains. Furthermore, a nonlinear disturbance-observer is designed to process unknown disturbance inputs and improve the BSMC performances. The closed-loop system of trajectory tracking control plant is proved to be globally asymptotically stable by using Lyapunov theory. By comparing with traditional backstepping control and SMC design, the results obtained demonstrate the capacity of the airship to execute a realistic trajectory tracking mission, even in the presence of unknown disturbances, and aerodynamic coefficient uncertainties.     

Numerical Study of Parachute-Payload Land Site Distribution with Randomize Wind Gust Model

A parachute-payload model with randomize wind gust is developed to study the landing accuracy of the parachute decelerator system,which can be exactly described by the landing site distribution.The research focuses on the steady descent phase of the parachute descent process,so the parachute and the payload suspension formulation during the phase are mainly discussed.In addition,since the wind effects have a significant impact on the land site distribution of the passive decelerator system and it is difficult to obtain the exact wind profile in practice,major features of parachute-payload system are studied via the randomized wind gust formulation.As the randomized wind gust formulation is adopted,the wind effect can be considered without the exact wind gust profile and the parachute aerodynamic simulation can be fulfilled with uncertainties.Finally,the model is validated and discussed,and the parachute land site distributions with different wind randomize profiles are presented for comparison.The results show that when parachute is less stable,the land site tends to have a larger variance.     

一种低轨双星雷达信号无模糊频差估计算法

针对低轨双星组合接收低脉冲重复频率(LPRF)雷达信号的频差(DFO)估计存在模糊的问题，提出一种基于时差差分的频差无模糊高精度估计算法，该算法通过对高精度的时差测量值进行中心差分获得无模糊的频差估值。仿真结果表明，新算法能对PRF低至300 Hz的雷达信号进行无模糊的频差估计，估计精度在信噪比高于15 dB时逼近克拉美劳下界，可有效扩大低轨双星时/频差定位系统对LPRF信号的适用范围。     

飞轮微振动的组合隔振装置设计及实验研究

针对光学遥感卫星飞轮微振动引起的成像质量下降问题，设计了一种组合隔振装置，并采用仿真分析与实验测试相结合的方法对隔振方案设计的合理性进行验证。首先，将测量的飞轮扰振数据引入光学卫星的有限元模型中，计算出飞轮扰振对光学相机的像素偏移影响；其次，设计了组合隔振方案并基于有限元方法对其隔振效果进行验证；最后，搭建了光学成像微振动实验测试平台，对不同转速下飞轮微振动造成的像素偏移影响进行精确测量。实验结果表明，组合隔振装置对300 Hz以上高频段飞轮扰振有较大衰减作用，最大像素偏移降到0.01个像素以下，隔振效率达到80%以上；通过对比可知，实验测试与仿真计算得到的像素偏移结果在低频段一次谐波响应及模态响应表现出较好一致性，但在高频段二者存在一定偏差。     

Numerical Analysis of Dry Friction-Induced Vibration of Moving Slider-Elastic Annular Beam System

A disc-pad friction system is modelled as that two moving pads act symmetrically on an annular beam with flexible boundary condition.Simulation procedure is proposed to deal with the moving interactions and calculation is carried out by using the finite difference method,which shows that only the first-order mode vibration of the beam can be induced.Then the partial differential equation of motion of the disk is reduced to a first-order mode vibration system with time-varying stiffness.As the disk speed is decreased below the critical speeds,the relative equilibrium of the pad on the disk loses its stability and stick-slip type limit cycle vibrations are resulted in all directions′movements.Acceleration of the disk motion on the frictional instability is also investigated.The period of stick-slip vibration with large amplitude will be shortened with higher moving deceleration.