全文获取类型
收费全文 | 176篇 |
免费 | 56篇 |
国内免费 | 49篇 |
专业分类
航空 | 130篇 |
航天技术 | 55篇 |
综合类 | 34篇 |
航天 | 62篇 |
出版年
2023年 | 6篇 |
2022年 | 16篇 |
2021年 | 26篇 |
2020年 | 15篇 |
2019年 | 14篇 |
2018年 | 14篇 |
2017年 | 9篇 |
2016年 | 11篇 |
2015年 | 8篇 |
2014年 | 13篇 |
2013年 | 18篇 |
2012年 | 16篇 |
2011年 | 16篇 |
2010年 | 10篇 |
2009年 | 13篇 |
2008年 | 8篇 |
2007年 | 3篇 |
2006年 | 9篇 |
2005年 | 6篇 |
2004年 | 2篇 |
2003年 | 2篇 |
2002年 | 2篇 |
2001年 | 3篇 |
2000年 | 8篇 |
1999年 | 2篇 |
1998年 | 1篇 |
1997年 | 1篇 |
1996年 | 7篇 |
1995年 | 8篇 |
1994年 | 3篇 |
1993年 | 3篇 |
1991年 | 2篇 |
1989年 | 1篇 |
1987年 | 1篇 |
1985年 | 2篇 |
1984年 | 1篇 |
1980年 | 1篇 |
排序方式: 共有281条查询结果,搜索用时 125 毫秒
1.
正A LM-3A launch vehicle lifted off from the Xichang Satellite Launch Center at21:07 Beijing time on June 5,launching the FY-2H satellite into orbit.This was the 277th flight mission of the LM family launch vehicle.FY-2H was the last flight unit of the 相似文献
2.
3.
4.
5.
本文对由一般曲线旋转得到的喷管进行了静力分析。文中讨论的喷管由缠绕复合材料构成,承受轴对称和非轴对称载荷作用。在采用有限元法分析时,通过Fourier转换将三维问题简化为二维求解。弹性矩阵中各参数采用合理假设只需由层状平面内三个弹性常数即可确定。文中给出缠绕复合材料喷管在内压和集中力作用下的位移分布算例,结果合理。本文推荐方法可供缠绕柔性喷管和其它类似结构分析时参考。 相似文献
6.
DU Xin-kang WANG Tian-min WANG Cong CHEN Bu-liang ZHOU Long 《中国航空学报》2007,20(2):140-144
Some fundamental studies on the preparation, structure and optical properties of NbN films were carried out. NbN thin films were deposited by DC reactive magnetron sputtering at different N2 partial pressures and different substrate temperatures ranging from –50 ℃ to 600 ℃. X-ray diffraction analysis (XRD) and scanning electron microscopy (SEM) were employed to characterize their phase com- ponents, microstructures, grain sizes and surface morphology. Optical properties inclusive of refractive indexes, extinction coefficients and transmittance of the NbN films under different sputtering conditions were measured. With the increase in the N2 partial pressure, δ-NbN phase structure gets forming and the grain size and lattice constant of the cubic NbN increasing. The deposited NbN film has relatively high values of refractive index and extinction coefficient in the wavelength ranging from 240 nm to 830 nm. Substrate tem- perature exerts notable influences on the microstructure and optical transmittance of the NbN films. The grain sizes of the δ-NbN film remarkably increase with the rise of the substrate temperature, while the transmittance of the films with the same thickness decreases. Ultra-fine granular film with particle size of several nanometers forms when the substrate is cooled to –50 ℃, and a remarkable aug- mentation of transmittance could be noticed under so low a temperature. 相似文献
7.
赘余桁架结构可靠性的计算方法 总被引:2,自引:0,他引:2
本文在现有的一些国际流行的有关计算赘余桁架结构可靠性方法的基础上加以改进,提出了计算赘余桁架结构可靠性的强度削减一人造外载法。它将结构的失效看作是一个前后相关的失效过程,而不是象以往的算法那样,将结构的失效看作是一些孤立的状态,因而更真实地反映了赘余结构失效的方式和实质,更准确地计算出了结构真实失效概率的上下界。算例结果表明,本文算法是切实可行的。 相似文献
8.
开孔变刚度层合板压缩屈曲性能研究 总被引:1,自引:0,他引:1
针对开孔变刚度层合板,建立3种尺寸的层合板有限元模型,采用了线性屈曲、引入残余热应力的线性屈曲和引入初始缺陷的非线性屈曲的3种分析方法,研究了开孔层合板在压缩条件下的屈曲行为,并通过自动铺丝制造层合板进行试验对比,对3种方法的合理性进行了分析。结果表明,引入残余热应力的线性屈曲分析方法与试验结果最吻合,两者仅相差0.63%。基于该方法,讨论开孔层合板残余热应力分布特点和应力水平,得出了开孔层合板的应力分布云图和应力分布规律,计算出残余热应力对开孔复合材料层合的屈曲影响。结果表明,残余热应力对传统直线开孔层合板的屈曲载荷影响很小,仅提高了3.57%,但大大提高了变刚度开孔层合板的屈曲载荷,最多可达23.40%。说明纤维曲线铺放可以改变内部残余热应力的分布,提高整个开孔层合板承载压缩载荷的能力。 相似文献
9.
10.
为了研究涡轮导叶吸力面的气膜冷却特性,在跨声速涡轮叶栅传热风洞中,采用瞬态方法实验测量了两个位置处的单排簸箕型气膜孔的冷却效率,分析了多个气动参数对其分布规律的影响。两排簸箕型孔分别位于相对弧长6.8%和21.7%处,叶栅通道基于叶片弦长的进口雷诺数为1.7×105~5.7×105,出口等熵马赫数为0.81~1.01,吹风比为0.6~2.1,涵盖了涡轮导叶典型工作状态。结果表明:对于簸箕型气膜孔,设计雷诺数条件下最佳吹风比在0.9~1.2附近,靠近前缘的孔排2的贴附性要好于孔排1;主流马赫数对孔后冷却效率的影响可以忽略,而低雷诺数下的冷却效率低于中高雷诺数工况;簸箕型气膜孔的冷却效率高于圆柱型孔,在BR1.5的中高吹风比时表现更明显;低吹风比时,凸面的冷却效率高于平板,尤其是s/d20距离内,而在高吹风比时,射流动量增加促进了气膜脱离凸面,从而降低了冷却效率。 相似文献