XMM-Newton study of soft excess X-ray emission in clusters of galaxies

We discuss the detection of soft excess X-ray emission in a sample of 19 clusters of galaxies observed by XMM-Newton. In 6/19 clusters evidence for a soft X-ray excess is found. Four of these clusters show soft X-ray and O VII line emission from gas with a temperature of 0.2 keV. The centroid of this oxygen line is consistent with the redshift of the cluster. The intensity and spatial extend of the soft excess agrees with previous PSPC measurements. These observations are interpreted as emission from warm-hot intergalactic medium filaments, with density enhancements near the cluster centers, consistent with theoretical predictions. In the other two soft excess clusters a non-thermal origin is consistent with the data.     

风洞试验中风剖面的模拟及近流场特性分析

首先简单介绍了日本东京工艺大学风工程研究中心新建的开环流低速边界层风洞中风剖面模拟的试验情况.基于试验结果,采用被广泛应用的三角尖劈加上布置粗糙元的方法,成功地模拟出日本建筑学会定义的四类不同场地对应的风剖面.通过对试验数据的比较分析,就所采用的立方体粗糙元及三角尖劈对最终模拟得到的风剖面特性的影响进行了比较分析.其次,对风剖面模拟及特性判定中的几个重要问题,如三角尖劈的形状优化、风速功率谱的一致性、积分尺度的分析方法等进行了分析.最后,基于以上分析,对在边界层风洞中模拟预定的风剖面提出几点参考意见.     

环境激励条件建筑结构的试验建模研究

通过环境激励模态识别技术对一座中高层新结构大楼环境激励试验建模研究。首先介绍了试验模型设计 ,并在现场测量整栋大楼在环境激励下的振动响应。然后采用新发展的频率空间域方法 ( FSDD)进行模态识别 ,分别在 0～ 4.5 Hz和 0～ 6.5 Hz频率范围识别出 9阶弯曲和扭转模态频率和振型。采用频率空间域方法识别了结构的阻尼特性 ,并得到满意的结果。所得试验模型已成功应用于 CFT大楼的有限元动态模型修正。所研发的试验建模技术可望在结构响应预报 ,健康监测和振动控制中发挥重要作用     

A challenge to the highest balloon altitude

Development of a balloon to fly at higher altitudes is one of the most attractive challenges for scientific balloon technologies. After reaching the highest balloon altitude of 53.0 km using the 3.4 μm film in 2002, a thinner balloon film with a thickness of 2.8 μm was developed. A 5000 m³ balloon made with this film was launched successfully in 2004. However, three 60,000 m³ balloons with the same film launched in 2005, 2006, and 2007, failed during ascent. The mechanical properties of the 2.8 μm film were investigated intensively to look for degradation of the ultimate strength and its elongation as compared to the other thicker balloon films. The requirement of the balloon film was also studied using an empirical and a physical model assuming an axis-symmetrical balloon shape and the static pressure. It was found that the film was strong enough. A stress due to the dynamic pressure by the wind shear is considered as the possible reason for the unsuccessful flights. A 80,000 m³ balloon with cap films covering 9 m from the balloon top will be launch in 2011 to test the appropriateness of this reinforcement.     

MPD arcjet system performance test

A new MPD (magnetoplasmadynamic) arcjet system was developed and tested to demonstrate its technological readiness for flight model design. The MPD arcjet, of quasisteady type, was repetitively operated. In the endurance test, more than 10⁵ shots were cleared in continuous operation. Some components cleared more than 10⁶ shots. Cathode erosion was markedly reduced through the use of newly developed material. Thermal data were obtained which define the thermal interface between the spacecraft and the MPD arcjet system. Waste heat from the electrodes was found to be 20–30% of the input power and to vary with repetition frequency. No technological difficulties are foreseen for further continuation of repetitive operation.     

Progress of super-pressure balloon development: A new “tawara” concept with improved stability

The super-pressure balloon (SPB) has been expected to be a flight vehicle that can provide a long flight duration to science. Since 1997, we have developed the SPB. Now we are at the phase of developing an SPB of a practical size. In 2009, we carried out a test flight of a pumpkin-shaped SPB with a 60,000 m³ volume. The undesirable result of this flight aroused us to resolve the deployment instability of the pumpkin-shaped SPB, which has been known as one of the most challenging issues confronting SPB development. To explore this deployment issue, in 2010, we carried out a series of ground tests. From results of these tests, we found that an SPB design modified from pumpkin, named “tawara”, can be a good candidate to greatly improve the deployment stability of the lobed SPB.     

A new balloon base in Japan

Since 1971, numerous balloons have been launched from the Japanese balloon base, the Sanriku Balloon Center (SBC). Through these years, balloon technologies have been developed continuously and many scientific achievements have resulted. Recently, however, because of the limited area of the launching pad of the SBC, we have been faced with the difficulty of safely launching large balloons. To solve this issue, we decided to move the balloon base from the SBC to the Taiki Aerospace Research Field (TARF) in northern Japan. The TARF had an existing huge hanger and a paved launch pad capable of being utilised for balloon operations. To evolve the TARF into a new balloon base, new balloon facilities have been constructed at the TARF and equipment was transferred from the SBC to the TARF during July 2007 and March 2008. The SBC was closed in September 2007, and the new base became operational in May 2008. The new base at the TARF is designed to launch larger balloons with greater safety and to perform balloon operations more effectively than ever before. In the summer of 2008, we carried out the first series of the balloon campaign at the TARF, and succeeded in two engineering flights of stratospheric balloons. By the success of these flights, we have verified that the whole system of the new balloon base is well established.     

Circular polarisation in star-forming regions: possible implications for homochirality.

Our discovery of high degrees of circular polarisation in some star-forming regions provides an attractive mechanism for the origin of homochirality. The largest degrees of circular polarisation, so far observed at near-infrared wavelengths, are thought to arise from the scattering of stellar radiation from aligned dust grains and are calculated to extend down to UV wavelengths. The extent of the region where circularly polarised light (CPL) of a single handedness originates is very large, and it is likely that the whole of a planetary system would see a single handedness of CPL also. We present the observational data, models of the scattering that leads to the production of CPL, and a model for the origin of homochirality. We also discuss briefly future laboratory and space-based experiments.