Properties and relationship between solar eruptive flares and Coronal Mass Ejections during rising phase of Solar Cycles 23 and 24

Statistical relationship between major flares and the associated CMEs during rising phases of Solar Cycles 23 and 24 are studied. Totally more than 6000 and 10,000 CMEs were observed by SOHO/LASCO (Solar and Heliospheric Observatory/Large Angle Spectrometric Coronagraph) during 23rd [May 1996–June 2002] and 24th [December 2008–December 2014] solar cycles, respectively. In particular, we studied the relationship between properties of flares and CMEs using the limb events (longitude 70–85°) to avoid projection effects of CMEs and partial occultation of flares that occurred near 90°. After selecting a sample of limb flares, we used certain spatial and temporal constraints to find the flare-CME pairs. Using these constraints, we compiled 129 events in Solar Cycle 23 and 92 events in Solar Cycle 24. We compared the flare-CME relationship in the two solar cycles and no significant differences are found between the two cycles. We only found out that the CME mean width was slightly larger and the CME mean acceleration was slightly higher in cycle 24, and that there was somewhat a better relation between flare flux and CME deceleration in cycle 24 than in cycle 23.     

Inter-agency comparison of TanDEM-X baseline solutions

TanDEM-X (TerraSAR-X add-on for Digital Elevation Measurement) is the first Synthetic Aperture Radar (SAR) mission using close formation flying for bistatic SAR interferometry. The primary goal of the mission is to generate a global digital elevation model (DEM) with 2 m height precision and 10 m ground resolution from the configurable SAR interferometer with space baselines of a few hundred meters. As a key mission requirement for the interferometric SAR processing, the relative position, or baseline vector, of the two satellites must be determined with an accuracy of 1 mm (1D RMS) from GPS measurements collected by the onboard receivers. The operational baseline products for the TanDEM-X mission are routinely generated by the German Research Center for Geosciences (GFZ) and the German Space Operations Center (DLR/GSOC) using different software packages (EPOS/BSW, GHOST) and analysis strategies. For a further independent performance assessment, TanDEM-X baseline solutions are generated at the Astronomical Institute of the University of Bern (AIUB) on a best effort basis using the Bernese Software (BSW).     

Solar and interplanetary parameters of CMEs with and without type II radio bursts

We have analyzed 101 CMEs, and their associated ICMEs and interplanetary (IP) shocks observed during the period 1997–2005. The main aim of the present work is to study the interplanetary characteristics of metric and DH type II associated CMEs such as, shock strength, IP shock speed, ICME speed, stand off distance and transit time. Among these 101 CMEs, 38 events show both metric and DH type II bursts characteristics. There are no metric and DH type II association for 52 events. While DH type II alone is found in 7 cases, metric type II alone is found in 4 events. It is found that the mean speeds of CMEs increase progressively from CMEs without type II events to CMEs associated with metric and DH type IIs as suggested by Gopalswamy et al. (2005). In addition, we found that the speeds of ICMEs and IP shocks progressively increase in the following order: events without metric and DH type IIs, events with metric alone, events with DH alone and events with both metric and DH type IIs. Similarly the Mach number is found to increase in the same order. While there is not much change in the stand-off distance among these cases, it is minimum (∼18 R_⊙) for CMEs with speed greater than 2200 km/s. The above results confirm that more energetic CMEs can produce both metric and DH type IIs for which the interplanetary parameters such as mean values of ICME speed and IP shock speed and Mach number are found to be higher.