Application of the mechanical oscillator technique to the investigation of EVA decompression

The ultrasonic bubble detection technique has been used as a versatile tool in the investigation of hypobaric decompression procedures for the last two decades. However, this method can only detect relatively large bubbles > 30-50 micrometers (usually in venous blood) and not the very first stages of bubble formation. Recently, the mechanical oscillator technique has been applied in air diving trials in order to detect small blood density changes due to hypothetical fluid shifts. However, sharp density drops were found in the decompression process, and these have been attributed to gas bubble formation. In this study, this method was applied together with Doppler controls to a series of altitude decompressions to 300 and 500 hPa, which represents the range of EVA operational pressures currently used or planned. Six subjects participated in both series; the oscillator sample tube could be pressurized. By the application of pressure on a blood sample containing questionable gas bubbles, these are reduced in volume, like in recompression therapy, and thus the density of the sample is increased. This effect has been shown in all 6 subjects undergoing decompression to 300 hPa, whereas in the 500 hPa series only 3 out of 6 subjects corresponded with gas phase formation immediately after decompression. Typically, Doppler bubbles appeared only after some latency time between 20 and 60 min; after this time, the density effect had nearly vanished. It is concluded that the mechanical oscillator technique represents a complementary research instrument to the Doppler method, because it is able to deliver a quantitative resolution of the early stage of gas phase formation.     

Physiologic and metabolic responses of wheat seedlings to elevated and super-elevated carbon dioxide

The metabolic consequence of suboptimal (400 μmol mol⁻¹ or ppm), near-optimal (1500 ppm) and supra-optimal (10,000 ppm) atmospheric carbon dioxide concentrations [CO₂] was investigated in an attempt to reveal plausible underlying mechanisms for the differential physiological and developmental responses to increasing [CO₂]. Both non-targeted and targeted metabolite profiling by GC–MS and LC–MS were employed to examine primary and secondary metabolites in wheat (Triticum aestivum, cv Yocoro rojo) continuously exposed to these [CO₂] levels for 14, 21 and 28 days. Metabolite profile was altered by both [CO₂] and physiological age. In general, plants grown under high [CO₂] exhibited a metabolite profile characteristic of older plants under ambient CO₂. Elevated [CO₂] resulted in higher levels of phosphorylated sugar intermediates, though no clear trend in the content of reducing sugars was observed. Transient starch content was enhanced by increasing [CO₂] to a much greater extent at 10,000 ppm CO₂ than at 1500 ppm CO₂. The percentage increase of starch content resulting from CO₂ enrichment declined as plants develope. In contrast, elevated [CO₂] promoted the accumulation of secondary metabolites (flavonoids) progressively to a greater extent as plants became mature. Elevated [CO₂] to 1500 ppm induced a higher initial growth rate, while super-elevated [CO₂] appeared to negate such initial growth promotion. However, after 4 weeks, there was no difference in vegetative growth between 1500 and 10,000 ppm CO₂-grown plants, both elevated CO₂ levels resulted in an overall 25% increase in biomass over the control plants. More interestingly, elevated atmospheric [CO₂] reduced evapotranspiration rate (ET), but further increase to the supra-optimal level resulted in increased ET (a reversed trend), i.e. ET at 1500 ppm < ET at 10,000 ppm < ET at 400 ppm. The differential effect of elevated and super-elevated CO₂ on plants was further reflected in the nitrogen dynamics. These results provide the potential metabolic basis for the differential productivity and stomatal function of plants grown under elevated and super-elevated CO₂ levels.     

Cosmic ray investigation for the Voyager missions; energetic particle studies in the outer heliosphere—And beyond

A cosmic-ray detector system (CRS) has been developed for the Voyager mission which will measure the energy spectrum of electrons from 3–110 MeV and the energy spectra and elemental composition of all cosmic-ray nuclei from hydrogen through iron over an energy range from 1–500 MeV/nuc. Isotopes of hydrogen through sulfur will be resolved from 2–75 MeV/nuc. Studies with CRS data will provide information on the energy content, origin and acceleration process, life history, and dynamics of cosmic rays in the galaxy, and contribute to an understanding of the nucleosynthesis of elements in the cosmic-ray sources. Particular emphasis will be placed on low-energy phenomena that are expected to exist in interstellar space and are known to be present in the outer Solar System. This investigation will also add to our understanding of the transport of cosmic rays, Jovian electrons, and low-energy interplanetary particles over an extended region of interplanetary space. A major contribution to these areas of study will be the measurement of three-dimensional streaming patterns of nuclei from H through Fe and electrons over an extended energy range, with a precision that will allow determination of anisotropies down to 1%. The required combination of charge resolution, reliability and redundance has been achieved with systems consisting entirely of solid-state charged-particle detectors.Principal Investigator of the Voyager Cosmic Ray Experiment.     

Disturbance estimation and compensation in linear systems

Discrete-time estimation and compensation are discussed as a solution to the problems encountered when disturbances are present and degrade the performance of continuous automatic control systems. The method described, under a mild set of conditions, allows the designer to locate the closed-loop system poles substantially anywhere and provide disturbance rejection as large as desired by increasing the dimensions of the disturbance estimator. This estimation/compensation scheme results in a gain characteristic, below some frequency (ω_c ), with a slope of q×20 dB/decade. The value of q and ω_c can be chosen by the designer, within the physical limitations of the problem, so that the system error resulting from either deterministic or stochastic disturbances is sufficiently reduced. The method has been investigated for use with known linear, time-invariant systems     

A uniform anthropomorphological approach to the human conception of dimensional relations

Within psycholinguistics, the dimensional conception of space is described through a variety of theoretical constructs, e.g., frames of reference, perspectives, strategies, and patterns. The objective of this paper is to introduce a uniform classification of the alternatives of dimensionally conceiving of object relations, derived from the functional and morphological asymmetries of the human body which define an anthropomorphous Origo, and from our ability to mentally project the Origo into positions and orientations other than we actually occupy. Particularly, the conception of dimensional relations on the first horizontal line is explained through the principle of perceptual accessibility of objects; this allows for the uniform treatment of (almost) all conceptual alternatives from basic psychological principles. Finally, some implications of this anthropomorphological view for the human cognition of dimensional relations are discussed and underpinned with empirical results.     

Induced Magnetic Fields in Solar System Bodies

Electromagnetic induction is a powerful technique to study the electrical conductivity of the interior of the Earth and other solar system bodies. Information about the electrical conductivity structure can provide strong constraints on the associated internal composition of planetary bodies. Here we give a review of the basic principles of the electromagnetic induction technique and discuss its application to various bodies of our solar system. We also show that the plasma environment, in which the bodies are embedded, generates in addition to the induced magnetic fields competing plasma magnetic fields. These fields need to be treated appropriately to reliably interpret magnetic field measurements in the vicinity of solar system bodies. Induction measurements are particularly important in the search for liquid water outside of Earth. Magnetic field measurements by the Galileo spacecraft provide strong evidence for a subsurface ocean on Europa and Callisto. The induction technique will provide additional important constraints on the possible subsurface water, when used on future Europa and Ganymede orbiters. It can also be applied to probe Enceladus and Titan with Cassini and future spacecraft.     

固化过程可视化:采用集成的超声传感器监测交联反应过程

在工艺过程中,树脂的反应程度或固化度通常因为其不会导致可见的缺陷,所以常被忽视.然而,未完全固化的产品会对最终的力学性能产生很大的影响,在使用过程中伴随有较大温度变化的情况下尤其如此.     

Magnetic Polarity Transitions and Biospheric Effects

This review addresses possible biospheric effects of geomagnetic polarity transitions. During a transition the magnetic field at the surface of the Earth decreases to about 10% of its current value. If the geomagnetic field is a shield against energetic particles of solar or cosmic origin then biospheric effects can be expected. We review the early speculations on the problem and discuss in more detail its current status. We conclude that no clear picture of a geomagnetic link, a causal relation between secular magnetic field variations and the evolution of life on our planet can be drawn.     

The morphology of fair weather cumulus cloud fields as remotely-sensed from satellites and some applications

The morphology of fair weather Cumulus cloud field over several ocean areas distributed globally has been studied using LANDSAT data. Distribution functions of cloud size, spacing, perimeter and other relevant parameters have been derived, as well as their correlations and moments.Examples of distribution functions of cloud size, cloud spacing and fractal dimension of the cloud fields over oceanic areas are given and applied to several problem in Cu convection.