A novel architecture of electro-hydrostatic actuator with digital distribution

To address the flow imbalance rapidly of the asymmetric Electro-Hydrostatic Actuator (EHA), this paper presents a novel architecture of asymmetric EHA with the Digital Distribution (EHA-DD). It also improves the flow nonlinearity and control accuracy of the pump, especially in the low-speed condition. The digital distribution with two High-Speed on–off Valves (HSVs) not only balances flow instead of the check valves, but also replaces the pump at the low-speed to control output flow by adjusting the PWM signal. The pump and HSVs are the crucial components to control flow output. Firstly, the flow calculation models of the pump and the duty ratio inversed model of the HSV are obtained through experimental tests and the identification method. To get the control input signal for the required flow, the pump speed and PWM duty ratio for the HSVs are inversed to compensate for flow output. Further, a multimode digital flow distribution control method based on pump speed, mainly including the pump-controlled mode for large flow demand and valve-controlled mode for little flow demand, is proposed to control the accurate flow output actively. The step extension experiments based on the flow calculation models are conducted on the EHA-DD prototype under elastic, opposite varying load. The results demonstrate that the EHA-DD realizes little position error by accurate flow control, and it is also beneficial to improve the service life of the pump.     

偏心撞击对撞击式喷嘴雾化特性的影响

为研究偏心撞击对撞击式喷嘴雾化特性的影响,建立了求解自燃推进剂冷态射流撞击雾化过程的数值模拟方案,计算了不同偏心度条件下的射流撞击雾化过程。采用树形自适应加密算法直接求解不可压Navier-Stokes方程组,由分段线性的流体体积(VOF)方法对流体界面进行捕捉。结果表明偏心撞击会导致雾场发生偏转,当无量纲偏心度E为1/8时,雾场偏转角度约为9.2°,应控制加工偏差小于该值。随着偏心度的增大,液膜的偏转角度增大,理论推导得到的液膜偏转角度要小于数值计算得到的液膜偏转角度。正心撞击时燃料与氧化剂流强峰值接近,雾场的流强分布呈单峰分布。当发生偏心撞击时,由于燃料与氧化剂部分射流未参与撞击导致流强峰值出现交错,雾场的流强分布呈双峰分布,混合比的空间分布发生较大改变。正心撞击时撞击点下游液滴的速度分布近似呈轴对称分布,而偏心撞击之后的速度分布则呈中心对称分布。偏心撞击导致的射流动量损失使得雾化性能变差,当无量纲偏心度E为1/8时,一甲基肼(MMH)的Sauter平均直径增大约4.8%,四氧化二氮(NTO)的Sauter平均直径增大约5.8%。      

Availability modeling for periodically inspection system with different lifetime and repair-time distribution

Availability is a main feature of design and operation of all engineering system. Recently,availability evaluation of periodical inspection systems with different structures is at the center of attention due to the wide application in engineering. In this paper, an analytical and probabilistic availability model for periodical inspection system is proposed by a new recursively algorithm,which can achieve limiting average availability and instantaneous availability of periodical inspection system under arbitrary lifetime and repair-time distributions. Then three application examples are presented, the systems lifetime and repair-time are respectively fellow exponential/exponential,Weibull/normal and Weibull/lognormal distribution. Finally, a Weibull/lognormal system is studied to analyze the dynamic relationship between inspection period and availability. The results indicate that the proposed approach can provide the technology support for improving system availability and determining reasonable inspection period.     

A new bearing fault diagnosis method based on modified convolutional neural networks

Fault diagnosis is vital in manufacturing system. However, the first step of the traditional fault diagnosis method is to process the signal, extract the features and then put the features into a selected classifier for classification. The process of feature extraction depends on the experimenters’ experience, and the classification rate of the shallow diagnostic model does not achieve satisfactory results. In view of these problems, this paper proposes a method of converting raw signals into two-dimensional images. This method can extract the features of the converted two-dimensional images and eliminate the impact of expert’s experience on the feature extraction process. And it follows by proposing an intelligent diagnosis algorithm based on Convolution Neural Network (CNN), which can automatically accomplish the process of the feature extraction and fault diagnosis. The effect of this method is verified by bearing data. The influence of different sample sizes and different load conditions on the diagnostic capability of this method is analyzed. The results show that the proposed method is effective and can meet the timeliness requirements of fault diagnosis.     

基于自适应容积粒子滤波的车辆状态估计

针对车辆状态估计中由模型的强非线性、噪声的非高斯分布等相关因素导致估计精度下降甚至发散的问题,本文提出了基于自适应容积粒子滤波(Adaptive cubature particle filter,ACPF)的车辆状态估计器。首先基于非稳态动态轮胎模型,构建高维度非线性八自由度车辆模型。其次利用自适应容积卡尔曼滤波(Adaptive cubature Kalman filter,ACKF)算法更新基本粒子滤波(Particle filter,PF)算法的重要性密度函数,以完成自适应容积粒子滤波算法设计。利用车载传感器信息,运用ACPF算法实现对车辆的侧倾角、质心侧偏角等关键状态变量高精度在线观测。搭建Simulink-Carsim联合仿真平台进行了算法的验证,结果表明该算法状态估计精度高于传统无迹粒子滤波(Unscented particle filter,UPF)算法,且算法运算效率高于UPF算法,而传统PF估计值发散。研究结果为实现车辆动力学精准控制提供了理论支持。     

基于脑电功率谱密度的作业人员脑力负荷评估方法

脑力负荷状态的准确识别对减少因作业人员无效脑力负荷导致的人因事故具有重要意义。针对人-机系统中作业人员脑力负荷客观评估问题开展了基于MATB-Ⅱ平台的3种不同脑力负荷水平下的航空情境实验，记录16名被试的NASA任务负荷指数（NASA-TLX）量表数据和脑电（EEG）信号，提出了一种基于脑电功率谱密度（PSD）和支持向量机（SVM）的个体脑力负荷评估方法。结果表明：随着实验设计脑力负荷水平增加，被试的主观脑力负荷得分显著提高（p<0.001），这表明该实验任务设计较好地诱发了低负荷、中负荷和高负荷情境。在此基础上，通过网格搜索法确定个体脑力负荷评估模型的统一优化参数，惩罚系数取3 000，核函数参数取0.000 1，模型测试正确率达到0.966 5±0.029 8，宏平均的受试者工作特征曲线下的面积（Macro-AUC）达到0.991 0±0.011 4。本文为作业人员脑力负荷状态的客观和准确评估提供了一种新的办法，为后期作业人员脑力负荷状态的实时判别提供模型基础。     

低轨天基信息定向分发区域分割编码控制方法

为提高低轨指向性信息分发链路的频谱利用效率，从天基分发平台与地面用户的相对位置关系入手，建立了分发指向、编码增益与信道传输容量的量化关系。在此基础上，提出一种低轨天基信息定向分发区域分割编码控制方法，该方法针对不同信息分发区域，采用最小均方误差(MMSE)作为区域分割准则选择编码方式，既提升了信道传输效率也便于工程实现。最后，本文通过仿真分析了方法的效能和性能影响因素，并与现有自适应编码方法进行了对比，验证了本方法的有效性和可靠性。     

三维叶轮机叶片黏性反问题设计改进方法

提出了一种改进的适用于三维黏性流场的叶轮机叶片反问题设计方法。该方法假设叶片的中弧线具有虚拟移动速度,其位移量由目标载荷与实际载荷的差值计算,并利用黏性底层厚度进行限制。采用三次B样条曲线插值方法对叶片中弧线进行光顺,新叶型通过更新后的中弧线和给定的叶片厚度得到。算例验算结果表明:该方法能够根据设计意图对叶型进行修改,鲁棒性强,收敛速度快,叶片的可变自由度高,不依赖于特定的网格和求解器,具备一定的通用性。      

分布式容错配电系统设计与仿真

阐述了分布式容错配电系统的功能需求及构型设计,完成了分布式容错配电仿真验证系统的研制,并进行了试验验证。结果表明:系统运行可靠,控制逻辑正确,系统设计满足功能要求。     

中国上市公司收入分配与所有权结构的实证分析

从公司收入分配角度研究不同所有权性质公司的企业利益和员工利益,研究发现不同所有权结构的企业生产效率差异不大,私有企业的企业利益优于国有企业,国有相对控股企业和私有相对控股企业的企业利益与员工利益相对较好,混合制企业的生产效率可能较低,企业利益与员工利益也相对较差.没有发现支持国有控股企业有大量冗员的证据,国企改革取得部分成功.