一种基于虚拟页地址映射的NAND Flash管理算法

本文提出了一种基于虚拟页地址映射的NAND Flash管理算法.该算法通过定义坏块表、对应表等结构，以及设计的坏块替换策略和虚拟页地址到实际物理页地址的转换算法，实现上层软件采用虚拟地址对NAND Flash的无坏块连续页地址访问.该算法是一种高效的地址映射算法，能高效地对数据进行索引，占用SRAM空间较少，使系统达到高性能，并使得闪存使用的更加稳定持久.     

Establishment of atmospheric weighted mean temperature model in the polar regions

Due to the special geographical location and extreme climate environment, the polar regions (Antarctic and Arctic) have an important impact on global climate change. Atmospheric weighted mean temperature (Tm) is a crucial parameter in the retrieval of precipitable water vapor (PWV) from the zenith wet delay (ZWD) of ground-based Global Navigation Satellite System (GNSS) signal propagation. In this paper, the correlation between weighted mean temperature and surface temperature (Ts) is studied firstly. It is shown that the correlation coefficients between Tm and Ts are 0.93 in the Antarctic and 0.94 in the Arctic. The linear regression Tm model and quadratic function Tm model of the Antarctic and the Arctic are established respectively using the radiosonde profiles of 12 stations in the Antarctic and 58 stations in the Arctic from 2008 to 2015. The accuracies of the linear regression Tm model, the quadratic function Tm model and GPT2w Tm model which is a state-of-the-art global Tm model are verified using the radiosonde profiles from 2016 to 2018 in the Antarctic and Arctic. Root Mean Square (RMS) errors of the linear regression Tm model, the quadratic function Tm model and GPT2w Tm model in the Antarctic are 3.07 K, 2.87 K and 4.32 K respectively, and those in the Arctic are 3.53 K, 3.38 K and 4.82 K, which indicates that the quadratic function Tm model has a higher accuracy compared to linear regression Tm model, and the accuracies of the two regional Tm models are better than that of GPT2w Tm model in the polar regions. In order to better evaluate the accuracy of Tm in the PWV retrieval, the PWV values of radiosondes are used for comparisons as the reference value. The RMS errors of PWV derived from the two Tm models are similar for 1.28 mm in the Antarctic and 1 mm in the Arctic respectively. In addition, the spatial and temporal variation characteristics of Tm are analyzed in the polar regions by spectral analysis of Tm data using fast Fourier transform. The results show that the Tm has obvious seasonality and annual periodicity in the polar regions, and the maximum difference between warm season and cold season is about 63 K. After comparing and analyzing the influences of latitude, longitude and elevation on the Tm in the polar regions, it is found that latitude and elevation have a greater influence on the Tm than the longitude. As the latitude and elevation increase, the Tm decreases, and vice versa in the polar regions.     

水下超声速射流对上浮水雷受力特性影响研究

固体火箭发动机具有功率密度大、推力大等优势,常被用于上浮水雷的推进器。然而发动机在水下工作时燃气射流使流场压力发生剧烈脉动,进而影响发动机的推力性能及上浮水雷的受力特性。基于VOF多相流模型和理想气体模型,建立了上浮水雷在不同工作状态(欠膨胀、完全膨胀、过膨胀)下的数值模型,研究了水下燃气喷射流对上浮水雷的受力特性影响。结果显示,欠膨胀工况时,发动机推力平缓,大小为12.2KN,上浮水雷受力未出现负值;完全膨胀时,射流发生颈缩、胀鼓现象位置距离雷体较远,导致发动机推力及水雷壳体受力振荡不剧烈;过膨胀工况时,射流发生颈缩、胀鼓现象距离喷管较近,发动机推力发生剧烈脉动,产生21.37%的振荡幅度,胀鼓现象发生时,流场压力显著降低使得上浮水雷后体受力减小,壳体阻力增大,上浮水雷最大产生27KN的负推力。     

高焓激波风洞喷管流场非平衡特性研究

高焓激波风洞是开展高超声速流动研究的重要地面模拟设备,但其产生的高焓气流在喷管中的膨胀过程是一种典型的热化学非平衡流动,试验段特征参数通过直接实验测量难以完全确定。本文通过求解耦合双温度模型的轴对称Navier-Stokes方程,研究了高焓激波风洞中典型状态下气流的热化学非平衡流动特性,分析了焓值对非平衡特性的影响规律。结果表明,喷管出口自由流均匀区域达到出口截面直径的75%以上,能够为实验提供足够的空间;喷管出口自由流处于热化学非平衡状态,在喷管喉道后约1/5喷管长度处气流即已处于冻结流状态,组分浓度和振动温度随气流流动基本不变;焓值在8.4MJ/kg~19.5MJ/kg之间变化时,非平衡程度随着焓值的增加而增强,但是低焓值时非平衡程度的增强更加剧烈。     

高超声速飞行器表面温度分布与气动热耦合数值研究

针对高超声速飞行器热防护设计中的高温气体非平衡效应问题和气动热环境精确预测问题,基于流场的非平衡Navier-Stokes方程、表面的能量守恒方程和内部的热传导方程,考虑流场的非平衡效应、表面的热辐射效应、催化效应和烧蚀效应以及热防护层内部的热传导效应,建立了初步的表面温度分布与气动热的耦合计算方法,完善了高超声速飞行器气动物理流场计算软件(AEROPH_Flow)。在表面材料为碳-碳(C-C)条件下,对飞行高度为65km和飞行速度为8,10km/s的半球以及飞行高度为50km和飞行速度为8km/s的球锥模型,开展了表面温度分布与气动热的耦合计算,验证了计算方法和计算软件,分析了表面温度分布对气动热环境的影响。研究结果表明:表面温度分布对气动热的计算结果有较大影响,在气动热环境的预测中,不仅要考虑热化学非平衡效应和表面催化效应的影响,还要考虑表面温度分布的影响,最好是采用表面温度分布与气动热耦合计算的方法,以减小表面温度分布对气动热计算结果的影响。为此,需要发展完善非平衡流场/表面催化和烧蚀/热传导温度场(气/表/固)的计算模型、耦合求解技术和计算软件,实现对高超声速飞行器的真实飞行条件下高温气体非平衡效应和气动热环境的精确模拟。     

基于等效理论的蜂窝夹层板强度等效分析

通过采用三明治夹芯板等效方法计算,得到了等效物理参数,建立了三明治夹芯蜂窝板的有限元模型,完成了蜂窝夹层板模型的静力分析和随机振动分析,并对试验样机进行了静力与随机振动分析和试验验证。结果表明:基于三明治夹芯板等效理论建立的有限元模型能够准确反映蜂窝夹层板的静强度特性和结构动特性,静力应变值结果误差小于4%,振动固有频率结果误差小于5%,偏差较小,表明所建模型合理、准确。     

LENS风洞试验返回器模型气动热特性模拟

国家数值风洞高超声速流动模拟软件HyFLOW的研制对打破国外同类软件的技术壁垒具有重要意义。与国外DPLR软件进行了对比研究，同时系统介绍了HyFLOW软件求解器的数值方法、物理化学模型以及壁面催化特性计算模型等主要方法，采用典型算例对有限催化模型进行了数值验证，最后基于LENS风洞试验146 mm返回器标模外形开展了高超声速气动热特性数值模拟。研究结果表明，HyFLOW软件在高超声速热化学非平衡流动模拟与评估方面的气动力计算精度高，与国外同类软件DPLR相当，同时其壁面催化条件下的气动热计算精度可靠，可信度高。     

Prediction of shock-layer ultraviolet radiation for hypersonic vehicles in near space

A systemic and validated model was developed to predict ultraviolet spectra features from the shock layer of near-space hypersonic vehicles in the ‘‘solar blind" band region. Computational procedures were performed with 7-species thermal non-equilibrium fluid mechanics, finite rate chemistry, and radiation calculations. The thermal non-equilibrium flow field was calculated with a two-temperature model by the finite volume technique and verified against the bow-shock ultra-violet(BSUV) flight experiments. The absorption coefficient of the mixture gases was evaluated with a line-by-line method and validated through laboratory shock tube measurements. Using the line of sight(LOS) method, radiation was calculated from three BSUV flights at altitudes of 38,53.5 and 71 km. The investigation focused on the level and structure of ultraviolet spectra radiated from a NO band system in wavelengths of 200–400 nm. Results predicted by the current model show qualitative spatial agreement with the measured data. At a velocity of 3.5 km/s(about Mach11), the peak absolute intensity at an altitude of 38 km is two orders of magnitude higher than that at 53.5 km. Under the same flight conditions, the spectra structures have quite a similar distribution at different viewing angles. The present computational model performs well in the prediction of the ultraviolet spectra emitted from the shock layer and will contribute to the investigation and analysis of radiative features of hypersonic vehicles in near space.     

来流条件对热流组分扩散项影响效应分析

使用数值模拟的方法研究了高超声速热化学非平衡流动中不同来流条件对热流组分扩散项的影响。以RAM-CII飞行试验外形为例,使用AUSM+-up格式耦合LU-SGS方法求解带化学反应源项的多组分NS方程。得到如下结论:在非平衡热环境数值模拟研究中,完全催化壁时组分扩散项热流所占比率表征了壁面催化效应的强弱;在同一高度下,随着马赫数升高热流组分扩散项比例越来越显著,而马赫数相同时,随着高度增高热流组分扩散项所占比例越来越小,主要原因在于当地化学反应进行程度不同。     

均匀化处理对7A55铝合金组织与性能的影响

研究了单级均匀化和双级均匀化工艺对铸态7A55铝合金组织和性能的影响规律.结果表明,经450℃单级均匀化处理后,合金中的残留共晶仍然较多,保温60h时合金中残留共晶比例由铸态合金的15.2%减少至7.2%,合金硬度由72HRB降低至60HRB,伸长率则由2.1%增大至11.2%;经450℃/60h+470℃双级均匀化处...