首页 | 本学科首页   官方微博 | 高级检索  
文章检索
  按 检索   检索词:      
出版年份:   被引次数:   他引次数: 提示:输入*表示无穷大
  收费全文   574篇
  免费   148篇
  国内免费   53篇
航空   330篇
航天技术   224篇
综合类   30篇
航天   191篇
  2024年   1篇
  2023年   29篇
  2022年   34篇
  2021年   39篇
  2020年   40篇
  2019年   34篇
  2018年   36篇
  2017年   15篇
  2016年   20篇
  2015年   14篇
  2014年   32篇
  2013年   26篇
  2012年   33篇
  2011年   35篇
  2010年   42篇
  2009年   26篇
  2008年   34篇
  2007年   29篇
  2006年   29篇
  2005年   23篇
  2004年   18篇
  2003年   23篇
  2002年   17篇
  2001年   26篇
  2000年   21篇
  1999年   26篇
  1998年   25篇
  1997年   6篇
  1996年   8篇
  1995年   10篇
  1994年   12篇
  1993年   7篇
  1992年   1篇
  1991年   1篇
  1990年   2篇
  1989年   1篇
排序方式: 共有775条查询结果,搜索用时 15 毫秒
1.
在定向炉中分别采用籽晶法制备了[001]、[011]和[111]3种不同取向的第四代单晶高温合金DD15,在800℃研究了不同取向的高周疲劳性能,分析了合金不同取向的显微组织、疲劳断口形貌和疲劳断裂组织。结果表明:在凝固方向横截面上不同取向合金的铸态枝晶和热处理γ′相组织明显不同。合金800℃的高周疲劳性能存在各向异性,疲劳极限按[111]、[001]、[011]取向的顺序降低。不同取向合金的高周疲劳都是沿平面断裂,断裂平面与试样中心应力轴线的角度不同,角度按[011]、[001]、[111]取向的顺序逐渐减小。不同取向高周疲劳断口特征基本相同,可见疲劳源区、疲劳扩展区和瞬断区。疲劳裂纹起源于试样表面或亚表面并沿{111}平面扩展。扩展区上可见河流状花样和疲劳条带。瞬断区可见撕裂棱和解理台阶特征,其断裂机制都为类解理断裂。由于试验温度较低,不同取向疲劳断裂后的γ′相仍保持立方形状。  相似文献   
2.
针对利用OFDM信号进行定位时信号非连续性问题,提出一种粗检测和精细检测结合的测距方法,将距离测量转换为不同尺度的时延样点,采用时域粗检测快速估算接收OFDM信号的最大相关峰值,然后对传输时延进行频域精细测量,提升了小数倍采样周期时延测量的精度。在此基础上,分析了OFDM信号的定位性能,仿真结果表明,当OFDM信号在信噪比-11dB的情况下测距误差由3m左右(子载波数512)降至1m(子载波数4096)。  相似文献   
3.
This paper proposes a real-time kinematic (RTK) model that uses one common reference satellite for the Galileo system with four frequency observations. In the proposed model, the double-differenced (DD) pseudorange and carrier phase biases among the different frequencies are estimated as unknown parameters to recover the integer features of the DD ambiguities among the different frequencies for ambiguity resolution and precise positioning. Analysis results show that the E5a, E5b, and E5 frequencies have virtually the same performance in terms of the positioning accuracy, observation residuals, and ratio values of ambiguity resolution. However, the E1 frequency performs worse than the E5a, E5b, and E5 frequencies. The RTK results for the combination of multiple frequencies are much better than those for a single-frequency observation, the coordinates’ standard deviation is improved about 20–30%, and the ambiguity fix time is improved about 10%.  相似文献   
4.
In the last 20?years, and in particular in the last decade, the availability of propagation data for GNSS has increased substantially. In this sense, the ionosphere has been sounded with a large number of receivers that provide an enormous amount of ionospheric data. Moreover, the maturity of the models has also been increased in the same period of time. As an example, IGS has ionospheric maps from GNSS data back to 1998, which would allow for the correlation of these data with other quantities relevant for the user and space weather (such as Solar Flux and Kp). These large datasets would account for almost half a billion points to be analyzed. With the advent and explosion of Big Data algorithms to analyze large databases and find correlations with different kinds of data, and the availability of open source code libraries (for example, the TensorFlow libraries from Google that are used in this paper), the possibility of merging these two worlds has been widely opened. In this paper, a proof of concept for a single frequency correction algorithm based in GNSS GIM vTEC and Fully Connected Neural Networks is provided. Different Neural Network architectures have been tested, including shallow (one hidden layer) and deep (up to five hidden layers) Neural Network models. The error in training data of such models ranges from 50% to 1% depending on the architecture used. Moreover, it is shown that by adjusting a Neural Network with data from 2005 to 2009 but tested with data from 2016 to 2017, Neural Network models could be suitable for the forecast of vTEC for single frequency users. The results indicate that this kind of model can be used in combination with the Galileo Signal-in-Space (SiS) NeQuick G parameters. This combination provides a broadcast model with equivalent performances to NeQuick G and better than GPS ICA for the years 2016 and 2017, showing a 3D position Root Mean Squared (RMS) error of approximately 2?m.  相似文献   
5.
The overlapping carrier frequencies L1/E1, L5/E5a and B2/E5b from GPS/Galileo/BDS allow inter-system double-differencing of observations, which shows a clear advantage over differencing of the observations of each constellation independently. However, the inter-system biases destroy the integer nature of the inter-system double-differencing ambiguities. Two methods of direct rounding and parameter estimation are used to determine the ISB value. By analyzing data collected from Curtin University from 2015 to 2018, the phase and code inter-system bias (ISB) are related to the receiver type, firmware version and the selected overlapping frequency. Upgrade of receiver firmware version results in changes of ISB values. For example, the upgrade of Javad firmware in Dec, 15, 2017 causes the difference of 0.5 cycles ISB between BDS GEO and non-GEO satellites. By comparing the three dynamic models which include white noise process, random walk process, and random constant in the parameter estimation method, the ISB determined by the random constant model is consistent with the value obtained by the direct rounding method. After the calibration of ISBs, the performances of tightly combined positioning are assessed. The success rate of ambiguity resolution and accuracy of positioning for the tight combination (TC) are significantly improved in comparison with that for the loose combination (LC) over short baselines. For L5/E5a, on which only few satellites can be observed, the maximum increase in success rates of ambiguity resolution can reach 31.7%, i.e., from 54.9% of LC to larger than 86.6% of TC, and the positioning accuracies can even be increased by 0.13 m, i.e., from 0.208 of LC to 0.074 m of TC in East direction for the mix-receiver TRIMBLE NETR9-SEPT POLARX4 in 2018.  相似文献   
6.
《中国航空学报》2021,34(10):210-219
In kinematic navigation and positioning, abnormal observations and kinematic model disturbances are one of the key factors affecting the stability and reliability of positioning performance. Generally, robust adaptive filtering algorithm is used to reduce the influence of them on positioning results. However, it is difficult to accurately identify and separate the influence of abnormal observations and kinematic model disturbances on positioning results, especially in the application of kinematic Precise Point Positioning (PPP). This has always been a key factor limiting the performance of conventional robust adaptive filtering algorithms. To address this problem, this paper proposes a two-step robust adaptive filtering algorithm, which includes two filtering steps: without considering the kinematic model information, the first step of filtering only detects the abnormal observations. Based on the filtering results of the first step, the second step makes further detection on the kinematic model disturbances and conducts adaptive processing. Theoretical analysis and experiment results indicate that the two-step robust adaptive filtering algorithm can further enhance the robustness of the filtering against the influence of abnormal observations and kinematic model disturbances on the positioning results. Ultimately, improvement of the stability and reliability of kinematic PPP is significant.  相似文献   
7.
在免疫算法训练过程中引入近邻传播(AP)聚类与熵权法,对训练样本进行聚类与权值计算,将权值引入免疫算法中样本选择阈值的计算,以解决训练过程采用固定选择阈值所造成的检测器在部分区域过拟合,部分区域欠拟合的问题。结果表明:改进的免疫算法用于典型非线性函数的寻优时,迭代性能均优于传统免疫算法,并在大部分情况下优于粒子群算法与量子遗传算法,在进行某型发动机故障诊断的实例实验时,改进后的算法的诊断准确率达到98.06%,高于传统免疫算法的92.60%。   相似文献   
8.
介绍了微分法分析计算定位误差的原理和适用范围,通过生产实例分析,证明了该方法在解决多误差因素定位误差分析与计算中的简便与快捷,从而有效简化了复杂定位方案定位误差的分析与计算,提高了夹具的设计效率。  相似文献   
9.
对载波相位辅助条件下应用于全球定位系统(Global Positioning System,GPS)动态单点定位的各种算法进行了综合分析与比较。首先简要介绍定位算法中的基本公式与观测模型;然后分别对周跳修复与滤波解算两部分所应用的各种算法进行详细介绍并比较其性能与适用范围;最后对尚待解决的问题及可能的发展方向进行了总结。  相似文献   
10.
Since the signals of global navigation satellite system (GNSS) are blocked frequently in challenging environments, the discontinuous carrier phases seriously affect the application of GNSS precise positioning. To improve the carrier phase continuity, this paper proposes a carrier phase prediction method based on carrier open-loop tracking. In the open-loop tracking mode, the carrier numerically controlled oscillator (NCO) is controlled by the predicted Doppler, but not by the loop filter output. To improve the phase prediction effective time, accurate receiver clock drift estimation is studied in the prediction method. The phase prediction performance is tested on GNSS software receiver. In the phase prediction effective time tests, open-loop processes were set for the tested channel. The test results show that, when some satellite signals are blocked in 15?s, the probability of carrier phase error less than quarter cycles is more than 94%. In the real time kinematic (RTK) positioning tests, some satellite signals are blocked in 10–15?s repeatedly. The test results show that, the carrier phase continuity is basically not affected by the signal interruption, and the RTK can almost keep continuous centimeter-level positioning accuracy without re-fixing the integer ambiguity.  相似文献   
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号