Fully distributed time-varying formation tracking control for multiple quadrotor vehicles via finite-time convergent extended state observer

This paper investigates a time-varying anti-disturbance formation problem for a group of quadrotor aircrafts with time-varying uncertainties and a directed interaction topology. A novel Finite-Time Convergent Extended State Observer (FTCESO) based fully-distributed formation control scheme is proposed to enhance the disturbance rejection and the formation tracking performances for networked quadrotors. By adopting the hierarchical control strategy, the multi-quadrotor system is separated into two subsystems: the outer-loop cooperative subsystem and the inner-loop attitude subsystem. In the outer-loop subsystem, with the estimation of disturbing forces and uncertain dynamics from FTCESOs, an adaptive consensus theory based cooperative controller is exploited to ensure the multiple quadrotors form and maintain a time-varying pattern relying only on the positions of the neighboring aircrafts. In the inner-loop subsystem, the desired attitude generated by the cooperative control law is stably tracked under a FTCESO-based attitude controller in a finite time. Based on a detailed algorithm to specify the cooperative control protocol, the feasibility condition to achieve the time-varying anti-disturbance formation tracking is derived and the rigorous analysis of the whole closed-loop multi-quadrotor system is given. Some numerical examples are conducted to intuitively demonstrate the effectiveness and the improvements of the proposed control framework.     

W波段UAV MISAR实时成像运动补偿方法

建立了实时成像正侧视合成孔径雷达(SAR)运动误差模型,采用了一种基于惯导和相位梯度自聚焦(PGA)运动误差估计的中心波束平面运动补偿算法。该算法对回波包络和相位进行分开补偿,利用惯导数据把带有运动误差的回波包络拉直,再利用相位梯度自聚焦算法对回波进行相位误差估计并补偿。针对实时成像的时间少、运算量大、运算资源受限等特点,该算法取消了距离徙动校正的步骤,将运动误差矢量在斜距平面投影并完成包络校正和相位误差估计。该方法运算量小,同时能满足分辨率要求。仿真结果表明:该方法能够得到质量较高的SAR图像。     

前向数据接入方式对导航星座网络通信性能的影响分析

对采用时分多址轮询建链体制的导航星座星间链路网络，为了指导星间链路网络地面前向数据接入的应用，分析了不同地面前向数据接入方式的星-星-地联合数据交互机制及其对网络通信性能的影响，并结合应用代价给出了综合评价和使用建议。以前向数据最快路径接入方式和固定节点接入方式为代表，分析了星间链路网络与地面间星 星 地联合数据交互机制的特点，明确了两种方式下星间链路网络拓扑路由规划策略的制定原则。通过构建Walker 24/3/1导航星座星间链路网络数据处理模型及典型星地运行场景，对两种地面前向数据接入方式仿真分析了星间链路通信容量和传输时延等网络通信性能，比较分析了通信容量及数据拥塞规律，得出前向数据最快路径接入方式相比于固定节点接入方式在通信性能上有较明显优势的结论。最后，综合给出了两种星 星 地联合数据交互机制的应用性评价,同时给出了在通信容量较低且通信时延要求不高、但可靠性要求较高的应用条件下，可适度采用固定节点接入方式的建议。     

大气环境对直升机旋翼桨-涡干扰噪声辐射特性的影响

建立了一个适用于旋翼桨-涡干扰气动载荷计算的计算流体力学(Computational fluid dynamics,CFD)/自由尾迹耦合模型,为提高计算效率,提出了一种高效的耦合策略进行不同计算域间的信息交换策略。在此基础上,结合基于声类比法的FW-H方程构建了旋翼桨-涡干扰噪声的计算方法。应用所建立的方法,以OLS(Operational loads survey)旋翼为研究对象,深入分析了大气环境对旋翼噪声辐射特性的影响。研究发现:随着飞行高度的增加,旋翼噪声辐射特性发生了明显的改变,逐渐由桨盘前行侧转变为指向桨盘前方,噪声幅值先增大后减小。文中从桨-涡干扰距离、干扰位置变化角度计算分析了大气压力、音速及空气密度等环境参数对旋翼桨-涡干扰噪声辐射特性的影响,并得出了一些有实际意义的影响规律。     

多种工质下螺旋波等离子体源波场结构数值模拟

针对螺旋波等离子体放电机理，开展了多种工质条件下的螺旋波放电等离子体内波场结构数值模拟研究。计算发现:氦气等离子体的Er分量在径向边界处的峰值更为突出，有利于等离子体在径向的输运，波电场径向分量决定了电流密度径向分量在内部的表现。在0.266 Pa和1.064 Pa两种气体压强条件下，通过波场结构验证了气压对于波阻尼影响的结论。波场结构是螺旋波在等离子体内传播以及能量沉积的微观体现，研究螺旋波波场结构是揭示其高电离效率的重要途径。初步探索了功率耦合机制，为实验系统优化及实验方案设定奠定理论基础。     

Satellite launch vehicle effect on the Earth’s lower ionosphere: A case study

The effect of the rocket exhaust products on the D-region of the ionosphere is investigated with the help of Very low frequency (VLF) electromagnetic wave propagation characteristics within the Earth-ionosphere waveguide. The changes in the electron density profile are computed from the observed VLF signal amplitude perturbations about 3 dB during the rocket launch. We find a localized electron depletion in the lower ionosphere at an altitude of around 58 km, that is thought to be originated by the attachment of ionospheric ion and molecular hydrogen along with water molecule in the exhaust product of first stage burn of Geosynchronous Launch Vehicle (GSLV) rocket at the time of GSLV launched from Sriharikota, India, on 27 August 2015 at 11:22 UT (16:52 IST). The ionospheric depletion perturbed the navigational VLF signal (VTX = 17 kHz) 134 s after the launch of the GSLV rocket.     

共轴刚性旋翼气动干扰数值计算方法

建立了一个适用于共轴刚性旋翼气动特性分析的数值模拟方法。该方法采用任意拉格朗日欧拉方法(Arbitrary Lagrange Euler,ALE)描述的可压缩Navier-Stokes(N-S)方程求解流场,采用低数值耗散的Roe格式进行空间离散;使用多重嵌套网格方法以模拟双旋翼的运动。针对共轴刚性旋翼配平,引入"差量修正"策略解决了传统配平中雅克比矩阵计算复杂的问题。首先,对Harrington-2共轴双旋翼的悬停气动性能进行了计算,然后,对某2 m直径共轴双旋翼的悬停及前飞状态进行了计算,并与试验值进行了对比。结果表明:在典型状态下拉力系数的计算结果与试验值误差在3%以内,扭矩系数的计算结果与试验值误差基本在5%以内;所采用的数值计算方法对旋翼涡尾迹特征具有较高的捕捉精度,可以有效模拟共轴刚性旋翼悬停和小速度前飞下的复杂流场及其细节特征。     

Numerical investigation on flow nonuniformity-induced hysteresis in scramjet isolator

Numerical simulation and theoretical analysis were conducted to study the hysteresis inside scramjet isolator during the reciprocating process of back pressure variation. It is revealed that only a regular reflection is theoretically possible for two leading shocks when the inflow Mach number is greater than 2.0, and no hysteresis can occur in the transition between shock reflection types. Nevertheless, wall suction, gas injection, and background waves cause non-uniformity of the incoming flow and would make hysteresis possible. Besides the classical hysteresis in the transition between shock reflection, new kinds of hysteresis were found in both the deflection angle of separated boundary layer and the location of the shock train. Moreover, the occurrence of hysteresis in the deflection angle of the separated boundary layer is accompanied with the shock reflection hysteresis. In the case with background waves or gas injection, hysteresis in the starting position of leading shock was observed too. As back pressure decreases, the leading shock does not follow the same path as that as the back pressure increases, and it is anchored at the location where the background shock or the injection interacts with the leading shock. It is inferred that, if two strong adverse pressure gradient regions move towards and interact with each other, hysteresis will take place when they start to separate.     

弹丸速度对超爆轰冲压加速器性能影响

为研究超爆轰模态冲压加速器的推进性能，采用混合的Roe/HLL（Harten, Lax, Van Leer）格式，结合自适应网格加密技术(AMR )与沉浸边界法(IBM )，数值模拟了弹丸速度高于预混可燃气体C-J爆速的冲压加速器流场，揭示了弹丸速度对流场结构与推力的影响。结果表明当弹丸速度在一定范围时，斜爆轰波可驻定在弹丸肩部或头部，在弹丸尾部形成高压区加速弹丸，并且，斜爆轰波驻定在弹丸头部推力更高，稳定工作的速度范围 更宽 。     

一种冲击响应谱试验设备校准装置的研制

介绍了冲击响应谱基本概念及其试验设备的分类与工作原理，参考现行冲击试验台检定规程提出了针对该设备的校准方法，设计了一种基于虚拟仪器技术的新型冲击响应谱试验设备校准装置，给出了典型冲击波形（半正弦、矩形、后峰锯齿）的冲击响应谱仿真计算结果并进行了验证，计算结果与理论结果完全一致，证明算法准确可靠，能够实现对冲击响应谱试验设备的校准。