任务空间内空间机器人鲁棒智能控制器设计

研究了基于神经网络的自由漂浮空间机器人在任务空间内的轨迹跟踪问题。首先利用RBF神经网络来逼近自由漂浮空间机器人高度非线性的动力学模型，然后设计了鲁棒控制器对逼近误差和外部干扰进行抑制。利用Lyapunov直接方法建立的新的神经网络参数和连接权值的在线学习算法，以及利用耗散理论设计的鲁棒控制器保证了系统的稳定性，并能够使系统L2增益小于给定的指标。利用该控制器对平面二连杆空间机器人进行了仿真研究，表明该智能控制方案是有效的。     

美国载人航天器的发展史实

介绍了美国各种载人航天器的研制、试验和使用情况。     

有限空间轴对称射流流场的数值模拟

本文在к－ε紊流模型下，采用罚有限元法对有限空间轴对称射流流场进行数值模拟。引用罚函数优化迎风格式和退化积分，建立有限元解法的数值矩阵，在不同截面上求得工，压力和紊流参数分布，计算结果与实验数据十分接近。本文研究结果可应用于火箭发动机的喷射设计和射流量论的研究。     

跨大气层和空间区域飞行器的液体推进剂管理

根据大气层飞行环境与机动飞行特点,以及空间飞行环境与液体推进剂特点,分析了跨大气层和空间区域飞行器的保证重力场和失重状态下均无夹气液体输送、控制液体推进剂质心位移、剩余推进剂空间排放和重复使用等液体推进剂管理技术要求。阐述了相应的关键技术,如包括无夹气输送、液体质心位移控制、失重状态下的流体动力、参数确定和结构设计等管理模式确定,以及包括模型参数确定、模型、状态模拟和验证等的管理模式试验。     

星间光通信中BER的口径自适应控制法

从接收机的比特误码率与发射机的振动关系出发,采用OOK调制方式,以APD为光电探测器,推导得到了描述发射机天线口径与发射机振动关系的数学模型。针对比特误码率(BER)随振动幅值增加而上升的问题,提出了用发射天线口径与自适应方法控制BER的解决方案。用MATLAB6.5计算得到了自适应和标准条件下BER与跟踪系统信噪比的关系曲线。计算结果表明,采用天线口径自适应方法可将BER值控制在设计要求以下。     

A Geosynchronous Orbit Search Strategy

Since more than 10 years there is evidence that small-size space debris is accumulating in the geosynchronous orbit (GEO), probably as the result of breakups. Two break-ups have been reported in GEO. The 1978 break-up of an EKRAN 2 satellite, SSN 10365, was identified in 1992, and in 1992 a Titan 3C Transtage, SSN 3432, break-up produced at least twenty observable pieces. Subsequently several nations performed optical surveys of the GEO region in the form of independent observation campaigns. Such surveys suffer from the fact that the field of view of optical telescopes is small compared with the total area covered by the GEO ring. As a consequence only a small volume of the orbital element-magnitude-space is covered by each individual survey. Results from these surveys are thus affected by observational biases and therefore difficult to compare. This paper describes the development of a common search strategy to overcome these limitations. The strategy optimizes the sampling for objects in orbits similar to the orbits of the known GEO population but does not exclude the detection of objects with other orbital planes. A properly designed common search strategy clearly eases the comparison of results from different groups and the extrapolation from the sparse (biased) samples to the entire GEO environment.     

Tether Satellite System Collision Study

A study was performed to determine the probability of collision with resident space objects and untrackable debris for the tether component of the Tethered Satellite System (TSS) after it broke away from the Space Shuttle orbiter (mission STS-75) in February 1996. Both an analytical and a numerical approach were used in this study, and the results obtained with these two methods were found to be in good agreement. These results show that the deployed tether is expected to have been impacted by several particles 0.1mm or larger in size. The probability of collision with objects 10cm in size or larger was on the order of 10^–3 per month. Since the severed tether reentered within one month after deployment, the collision hazard to other objects while in orbit was small. The analytical methods used in this study are useful for tether collision evaluations in general.     

Delta并联微操作手运动学的矢量法分析

利用矢量运算的方法,分析了三维平动Delta并联微操作手的运动学特性.基于雅可比矩阵的可逆性,研究了Delta并联机构的正逆运动奇异性问题. 研究表明,微操作手的雅可比矩阵中存在灵敏参数,灵敏参数的大小及方位影响着位移输入与输出间的关系;利用矢量运算方法进行运动学奇异性问题分析更为简洁和直接.     

建立航空发动机状态空间模型的修正方法

以阶跃输入响应进行模型的检验，提出了状态空间模型的修正方法：基于动态响应较好的状态空间模型，进行其矩阵B，D，F，G的修正，获得基于稳态修正的模型，解决了航空发动机状态空间模型检验与修正的问题。仿真表明，使用该方法修正的状态空间模型具有与原非线性数学模型完全一致的稳态响应和基本一致的动态过程响应。这种方法为航空发动机多变量数字电子控制器的设计奠定了强有力的基础。     

非线性主轴降维映射法在固体火箭发动机设计优化中的应用

为在二维或三维空间中表达固体火箭发动机高维设计空间,引入非线性主轴降维映射法对多维非线性设计优化问题进行降维处理。以某大型固体火箭发动机设计问题为例,将10变量4有效约束优化问题降维映射到二维空间进行研究,拟合的非线性主轴降维映射模型中,目标函数和约束函数的相对误差控制在1.5%以内。研究表明,非线性主轴降维映射法具有发现多变量非线性优化数学模型本征特性的特点,能对设计变量重要性排序;通过降维展示设计空间全景,为优化算法和优化初始点优选提供了直观、有力的工具;优化轨迹实时展示为优化算法性质研究及算法切换提供了依据;根据优化轨迹从优化结果在降维空间中的位置能够判断优化结果是否具有全局最优解特性。