全文获取类型
收费全文 | 364篇 |
免费 | 48篇 |
国内免费 | 120篇 |
专业分类
航空 | 370篇 |
航天技术 | 37篇 |
综合类 | 78篇 |
航天 | 47篇 |
出版年
2023年 | 2篇 |
2022年 | 8篇 |
2021年 | 7篇 |
2020年 | 14篇 |
2019年 | 19篇 |
2018年 | 13篇 |
2017年 | 10篇 |
2016年 | 26篇 |
2015年 | 23篇 |
2014年 | 22篇 |
2013年 | 21篇 |
2012年 | 24篇 |
2011年 | 26篇 |
2010年 | 23篇 |
2009年 | 29篇 |
2008年 | 20篇 |
2007年 | 24篇 |
2006年 | 18篇 |
2005年 | 20篇 |
2004年 | 15篇 |
2003年 | 16篇 |
2002年 | 19篇 |
2001年 | 11篇 |
2000年 | 12篇 |
1999年 | 18篇 |
1998年 | 13篇 |
1997年 | 14篇 |
1996年 | 7篇 |
1995年 | 6篇 |
1994年 | 6篇 |
1993年 | 5篇 |
1992年 | 8篇 |
1991年 | 8篇 |
1990年 | 10篇 |
1989年 | 6篇 |
1988年 | 8篇 |
1986年 | 1篇 |
排序方式: 共有532条查询结果,搜索用时 16 毫秒
61.
《中国航空学报》2021,34(4):1-18
The previous studies of time delay compensation in flight control systems are all based on the conventional aerodynamic derivative model and conducted in longitudinal motions at low angles of attack. In this investigation, the effects of time delay on the lateral-directional stability augmentation system in high-α regime are discussed based on the model, which is proposed in our previous work and proved as a more accurate aerodynamic model to reveal the lateral-directional unsteady aerodynamic characteristics at high angles of attack. Both the model and the quasi-steady model are used for simulating the effects of time delay on the flying qualities in high-α maneuvers. The comparison between the simulation results shows that the flying qualities are much more sensitive to the mismatch of feedback gains than the state errors caused by time delay. Then a typical adaptive controller based on the conventional dynamic derivative model and a gain-prediction compensator based on model are designed to address the time delay in different maneuvers. The simulation results show that the gain-prediction compensator is much simpler and more efficient at high angles of attack. Finally, the gain-prediction compensator is combined with a linearized model reference adaptive controller to compensate the adverse effects of very large time delay, which exhibits excellent performance when addressing the extreme conditions at high angles of attack. 相似文献
62.
超声速横向喷流侧向控制的数值模拟 总被引:2,自引:1,他引:1
为研究来流攻角和喷流位置对横向喷流侧向控制力的影响,通过数值方法模拟了超声速条件下的横向喷流干扰流场,计算得到的壁面沿程压力分布与实验结果吻合良好.采用喷流力放大因子和实际作用位置表征喷流侧向控制力的实际作用效果,引入法向干扰力沿程增加系数来分析弹体表面的压力特征区域对侧向控制力的影响.计算结果表明:在喷流干扰下,侧向控制力大小不等于喷流设计推力,并带有绕喷流中心位置的低头力矩;低压尾迹区是影响侧向力实际作用效果的决定因素;攻角的增大和喷流位置的后移,分别有助于削弱低压尾迹区的干扰强度和作用范围,从而增强侧向控制力的实际作用效果. 相似文献
63.
64.
首先针对具有中等前缘后掠角梯形鸭翼的缺点提出双后掠鸭翼概念,然后分别对安装梯形鸭翼和双后掠鸭翼的近距耦合鸭式布局的气动性能进行数值模拟研究,分析影响双后掠鸭翼气动性能的流动机理。研究表明:在大迎角时,对于双后掠鸭翼,具有较大前缘后掠角的外翼段可以使鸭翼涡在涡核破裂后仍能形成稳定集中涡并保持较高的强度,增加鸭翼本身的失速迎角,并通过诱导作用改善机翼外翼段流场,进而提高全机大迎角性能,但在小迎角时会破坏鸭翼附着流或前缘气泡涡的发展,造成略微的升力损失。拥有较大失速迎角的双后掠鸭翼在小迎角时具有较大的可用偏度,可以增强布局的抬头控制能力。双后掠鸭翼在满足隐身约束的前提下,超声速阻力较小,具有较好的超声速性能。 相似文献
65.
66.
67.
A formal analysis to footprint problem with effects of angle of attack (AOA) is presented. First a flexible and rapid standardized method for footprint generation is developed. Zero bank angle control strategy and the maximum crossrange method are used to obtain virtual target set; afterward, closed-loop bank angle guidance law is used to find footprint by solving closest approach problem for each element in virtual target set. Then based on quasi-equilibrium glide condition, the typical inequality reentry trajectory constraints are converted to angle of attack lower boundary constraint. Constrained by the lower boundary, an original and practical angle of attack parametric method is proposed. By using parametric angle of attack profile, optimization algorithm for angle of attack is designed and the impact of angle of attack to footprint is discussed. Simulations with different angle of attack profiles are presented to demonstrate the performance of the proposed footprint solution method and validity of optimal algorithm. 相似文献
68.
基于大涡模拟(LES)和边界元方法对轴流压气机叶栅湍流流场以及流场诱导的噪声进行计算,在不同叶栅安装角下研究来流攻角和来流雷诺数对叶栅气动噪声产生、辐射的影响。研究表明:来流雷诺数不变时,同一安装角下,随着来流攻角从-5°~20°变化,叶栅监测曲线上的声压级先减小后增大,在0°来流攻角下声压级达到最小。安装角为45°时,外场总声压级随来流攻角的分布与30°安装角变化趋势相近。但安装角为60°时,总声压级的变化则明显变缓。在0°来流攻角下,总声压级比安装角为30°和45°时增加了近6 dB,但在其他正来流攻角下,变化并不明显。叶栅的最小声压值出现在弦线方向附近,安装角改变时,最小声压级出现的位置也不同。安装角不变,随着来流雷诺数的增大,叶栅表面的分离减小,损失降低。但叶栅表面的压力脉动随着来流雷诺数的增大而增大,使外场辐射噪声增加。 相似文献
69.
70.
大迎角分离流场在等离子体控制下的特性研究 总被引:2,自引:0,他引:2
设计了一种新型的大迎角主动流动控制方法。采用圆锥-圆柱组合体模拟飞行器前体,在靠近圆锥尖端处镶嵌了一对马蹄形单电极介质阻挡放电(single_Dielectric Barrier Discharge SDBD)等离子体激励器,通过风洞实验研究了等离子体激励器在不同状态下对大迎角模型前体的非对称气动载荷的控制作用。实验结果表明,通过控制等离子体激励器的开闭可以使得圆锥-圆柱组合体在大迎角下出现的侧力改变方向。还对通过调节单侧等离子体激励器的激励电压实现圆锥前体侧力系数在正负极值间连续变化的可能性进行了初步的实验探索。 相似文献