光纤综合特性测试仪测量不确定度评定

根据计量工作中测量不确定度评定的实践经验，对光纤综合特性测试仪在计量时的测量不确定度进行了分析、评定。     

复合材料层板纯剪实验

本文提出一个测量复合材料层板面内剪切性质的方板纯剪试验法。首先对方法的可靠性进行试验检验,然后对两种复合材料层板的剪切行为进行试验。     

Temperature comparison between CHAMP radio occultation and TIMED/SABER measurements in the lower stratosphere

Global Positioning System (GPS) receiver on the CHAllenging Mini-satellite Payload (CHAMP) and the Sounding of the Atmosphere using Broadband Emission Radiometry (SABER) instrument, one of four on board the TIMED satellite, provide middle atmosphere temperature profiles by Radio Occultation (RO) and limb viewing infrared emission measurements, respectively. These temperature profiles retrieved by two different techniques in the stratosphere are compared with each other using more than 1300 correlative profiles in March, September and December 2005. The over-all mean differences averaged over 15 and 35 km are approximately −2 K and standard deviation is less than 3 K. Below 20 km of altitude, relatively small mean temperature differences ∼1 K are observed in wide latitudinal range except for June (during the SABER nighttime observation). In the middle to low latitudes, between 30°S and 30°N, the temperature difference increases with height from ∼0–1 K at 15 km, to ∼−4 K at 35 km of altitude. Large temperature differences about −4 to −6 K are observed between 60°S and 30°N and 31–35 km of altitude for all months and between 0° and 30°N below 16 km during June (nighttime).     

高性能飞行器大气数据传感技术研究进展

大气数据是飞行器导航和控制的重要参数，大气数据传感技术是实现飞行器飞行安全及性能发挥的重要保障。针对高性能飞行器对大气数据传感技术的发展需求进行分析，重点介绍了传统大气数据传感技术、嵌入式大气数据传感技术、光学大气数据传感技术及虚拟大气数据传感技术的发展和特点，并对推动嵌入式大气数据传感技术发展的相关技术问题进行了分析和总结，最后对大气数据传感技术的发展进行展望。     

Hypothesis-test-based landcover change detection using multi-temporal satellite images – A comparative study

Remote sensing images and technologies have been widely applied to environmental monitoring, in particular landuse/landcover classification and change detection. However, the uncertainties involved in such applications have not been fully addressed. In this paper two hypothesis-test-based change detection methods, namely the bivariate joint distribution method and the conditional distribution method, are proposed to tackle the uncertainties in change detection by making decisions based on the desired level of significance. Both methods require a data set of class-dependent no-change pixels to form the basis for class-dependent hypothesis test. Using an exemplar study area in central Taiwan, performance of the proposed methods are shown to be significantly superior to two other commonly applied methods (the post-classification comparison and the image differencing methods) in terms of the overall change detection accuracies. The conditional distribution method takes into consideration the correlation between digital numbers of the pre- and post-images and the effect of the known pre-image digital number on the range of the post-image digital number, and therefore yields the highest change detection accuracy. It is also demonstrated that the class-dependent change detection is crucial for accurate landuse/landcover change detection.     

芳纶复合材料用湿法环氧配方的研究

在综合考虑粘度，力学性能和储存期的基础上，研制了以混合芳香胺为固化剂的芳纶用湿法环氧配方， 注浇体力学与俄，美等国家湿法环配方及我国高性能干法配方性能相当，实验证明该湿法环氧配方与Ｆ－１２纤维浸润性及界面粘接性能均较高，其ＮＯＬ环强度转化率均达８７％。     

规则回转体自动铺丝轨迹规划与丝束增减

为满足自动铺丝轨迹的满铺覆性要求，针对现阶段自动铺丝轨迹规划存在的不足，提出了不同的丝束增减算法。首先讨论纤维铺放方向的确定和中心轨迹数量的计算，设计不同铺放方向轨迹的生成算法。然后以丝束重叠系数为重要参数，对于纤维局部堆积和空缺问题提出单侧纤维裁剪算法和双侧纤维裁剪算法，并对裁剪后的重叠区域和间隙区域进行面积求解，使得纤维丝束均匀覆于芯模表面。最后基于CATIA CAA二次开发平台，将上述算法集成到纤维铺放CAD系统中，通过运动仿真系统验证算法的正确性。利用提出的丝束增减算法，实现了间隙/重叠区的均匀分布，尽量降低了富树脂区等相关缺陷的聚集对性能的不良影响。     

PP／SCF复合材料的制备和力学性能的研究

本文制备了聚丙烯（PP）／,短炭纤维（SCF）复合材料并研究了其力学性能。结果表明,复合材料的拉伸强度随SCF含量的增加有先增加后趋于稳定的趋势,当SCF含量达到6％时,拉伸强度达到极值。随着SCF的加入,冲击强度呈先增加后略有降低的趋势,复合材料在SCF含量为6％时冲击强度达到极值。由此可知,适量的加入SCF对PP起到了较好的增强增韧效果。     

资源三号卫星廊坊地区遥感数据的融合处理

本文以资源三号卫星河北省廊坊地区2A级全色遥感影像和多光谱影像数据为基础,采用遥感数字图像处理软件ERDASIMAGINE进行了研究区域的提取,并对提取的感兴趣区进行了几何校正,即图像配准处理,然后进行了融合处理,分别采用了空间增强的分辨率融合算法、改进IHS分辨率融合算法以及小波分辨率融合算法,通过和融合前的影像进行对比,融合后的影像既保留了多光谱影像的丰富的波谱信息,同时具有了全色影像的高空间分辨率的特征,最后对比三种融合算法,得出改进的IHS分辨率融合算法效果最佳。     

一种遥感图像建筑物检测新方法

遥感图像中的建筑物检测对于土地规划和地图绘制等具有重要意义。文章针对高分辨率全色遥感图像植被覆盖中隐蔽建筑物检测问题,提出了一种结合屋顶结构信息和纹理信息的快速房屋检测方法。首先利用屋顶边缘的几何关系寻找具有矩形屋顶的建筑物;然后使用形态学方法提取屋顶较亮的建筑物;最后利用局部二值模式（Local Binary Pattern,LBP）描述屋顶的纹理特征,并利用支持向量机（Support Vector Machine,SVM）排除误检区域。通过在全色遥感图像集上的试验证明,所提方法对高分辨率遥感图像植被覆盖区域中的建筑物目标具有较高检测率和较低误检率。