Proton fluxes measured by low-orbit satellites

In this paper we consider the fluxes of protons in the energy range from 30 keV to 140 MeV recorded by instruments onboard the Russian satellites KORONAS-F and UNIVERSITETSKII and on the American satellites GOES-11 and NOAA-17. In order to estimate the reliability of the obtained data, the comparison of measurements of separate energy channels of these instruments between themselves is performed. Experimental fluxes of trapped protons are compared with the fluxes predicted by the AP8 model.     

Turbulent fluctuations of plasma and magnetic field parameters in the magnetosheath and the low-latitude boundary layer formation: Multisatellite observations on March 2, 1996

The results of simultaneous analysis of plasma and magnetic field characteristics measured on the INTERBALL/Tail Probe, WIND and Geotail satellites on March 2, 1996, are presented. During these observations the INTERBALL/Tail Probe crossed the low-latitude boundary layer, and the WIND and Geotail satellites measured the solar wind’s and magnetosheath’s parameters, respectively. The plasma and magnetic field characteristics in these regions have been compared. The data of the Corall, Electron, and MIF instruments on the INTERBALL/Tail Probe satellite are analyzed. Fluctuations of the magnetic field components and plasma velocity in the solar wind and magnetosheath, measured onboard the WIND and Geotail satellites, are compared. The causes resulting in appearance of plasma jet flows in the low-latitude boundary layer are analyzed. The amplitude of magnetic field fluctuations in the magnetosheath for a studied magnetosphere boundary crossing is shown to exceed the magnetic field value below the magnetopause near the cusp. The possibility of local violation of pressure balance on the magnetopause is discussed, as well as penetration of magnetosheath plasma into the magnetosphere, as a result of magnetic field and plasma flux fluctuations in the magnetosheath.     

“一对一”空战中载机与目标的运动特性分析

从战术与技术相结合的角度,建立了“一对一”空战中交战双方的运动学方程,运用瞬时跨距的方法分析了载机与目标的相对运动,研究了目标在载机坐标系中的运动特性。文中的研究结果对歼击机“一对一”空战的战术选择有一定的指导意义。     

The role of AVDR in linear cascade testing

Linear cascade testing plays an important role in the research and development of turbomachinery and is widely used over the world.The ideal cascade model of a turbomachinery blade row is two-dimensional.In actual linear cascade testing, the flow through the test section converges due to the development of the boundary layer and secondary flow along the sidewall surfaces of the test section.Axial velocity density ratio(AVDR) is adopted to account for the deviation of the tested cascade flow from the ideal 2D model.Among numerous published cascade works, the influence of AVDR on cascade performance is seen to be complicated with many affecting factors, such as those related to cascade/blade geometry and flow conditions.Also, controlling AVDR is limited by the facility capability.Furthermore, real blade-to-blade flow in turbomachines is usually associated with AVDR greater than unity due to limited span of blades between the hub and shroud such that cascade testing without reducing AVDR could be favored sometimes.All these facets add complexity and diversification to the matter.The current paper reviews previous studies and results on AVDR.Consolidated understanding on the role of AVDR and recommendations on how to deal with it in linear cascade testing are provided.      

基于旋转坐标系转轴振动信号的滚动轴承故障诊断方法

实验验证了基于旋转坐标系转轴振动信号的滚动轴承局部故障诊断方法.建立起滚动轴承故障实验台, 采用压电晶体加速度传感器测取转轴的振动.通过滚动轴承内环、外环、滚动体和保持架四种典型故障的实验分析结果, 证明了该方法的可行性, 并发现转轴振动信号的传递路径相对简单, 对轴承内环、滚动体和保持架早期微小故障的发现与诊断可能是有利的.      

金属橡胶阻尼器在转子系统中的应用

对带鼠笼式弹支和金属橡胶阻尼器的氢涡轮泵转子进行了试验研究。作为组合支承,金属橡胶阻尼器有它独特的优点,应用在氢涡轮泵转子上,其减振效果很明显。从接近一阶临界转速的试验来看,加阻尼器时转子系统的振动较未加阻尼器可降低90%左右。并与理论计算结果进行了对比,对比表明,其中两个临界转速点有很好的一致性。与其它类型的减振器相比,其制作工艺、安装条件几乎不受任何限制。      

逃逸飞行器模型高超声速风洞自由翻滚动导数试验技术

高超声速风洞模型自由翻滚动导数试验技术是为满足航空航天飞行器 0°～ 360°全攻角范围内的动导数测量及产生极限环振动现象的研究之急需而研制。简要介绍了试验技术研制的自由翻滚试验装置、液体轴承、角度测试系统与系统建模的大攻角非线性数据处理技术。该项技术已成功地为逃逸飞行器模型提供了满意的试验数据     

工程中圆度的多次定位测量及其数据处理

从测量实践出发,总结出一种利用多次定位技术进行圆度测量的方法.在阐述测量原理,分析测量及其数据处理过程后,给出一个测量实例,并进行了测量不确定度分析.文章给大型工程中类似情况下的测量问题以很好的启发.     

角接触球轴承生热预测方法与灵敏度分析

通过拉丁超立方实验设计法获取角接触球轴承NSK-7015C的结构参数样本数据,采用Newton-Raphson法求解轴承变形几何协调方程、滚动体平衡方程和内圈平衡方程所构成的非线性方程组。应用Kriging和Monte Carlo相结合的方法(AK-MCS)构建样本数据与轴承生热的函数关系,在此基础之上使用全局灵敏度计算方法计算轴承结构参数对轴承生热的影响。研究结果表明:在相同轴承结构参数下,采用AK-MCS法预测的轴承生热与轴承拟静力学分析模型求得的结果差值均小于0.003 W,说明AK-MCS算法的预测结果具有较高的准确性；轴承生热对轴承滚动体直径变化反应最灵敏,轴承内、外圈沟道直径影响次之,轴承内、外圈沟道曲率半径影响最小,该研究能够为轴承结构参数的设计优化和加工精度的选择提供理论依据。      

基于机匣信号的滚动轴承故障卷积神经网络诊断方法

针对在滚动轴承故障激励下的机匣微弱故障特征,提出了基于卷积神经网络(CNN)的故障诊断方法。利用矩阵图法、峭度图法以及小波尺度谱法3种振动信号的预处理方法,将一维原始信号转换为图像信号;利用卷积神经网络对故障进行识别。通过比较分析发现:通过连续小波尺度谱更易提取滚动轴承的故障特征,其故障识别率达到95.82%,均高于其他几种振动信号预处理方法;由于卷积神经网络可以利用深层网络结构自适应地提取滚动轴承故障特征,比传统支持向量机(SVM)方法的故障识别率高约7%。结果证明了该方法的有效性与可行性,且具有较好的泛化能力和稳健性。