喷流噪声特性与控制研究

本文着重研究喷流噪声机理及工程计算方法。通过实验研究了声功率与喷流速度的关系,表明在Mα>0.4时Lighthill方程和Lilley方程均与实验数据吻合,可分别使用。而Mα<0.4时,均偏差较大,通过本文实验表明,若改为6次方关系较为恰当。文章同时对喷流噪声指向性、谱特性进行了分析。最后对一种引射消声器进行了发展性研究,获得在135dB噪声条件下,降噪17dB的效果。     

1 000 MW超超临界锅炉结渣特性预测模型

根据1 000 MW超超临界锅炉的实际运行数据,对其结渣特性进行研究和分析。建立了基于煤灰特性的锅炉结渣特性预测模型,包括单一指标和综合指标的各预测模型,这些预测模型能简单、快速地预测锅炉的结渣特性。但对于锅炉燃用煤质不均匀或采用混煤燃烧等情况,这类预测模型的准确性和可靠性将下降。同时根据锅炉运行时的实时监测数据,建立了基于炉膛清洁因子的炉膛结渣特性在线监测模型,通过炉膛出口后各受热面进出口蒸汽温度、流量,以及省煤器出口烟气温度等有关参数,利用反平衡法计算求得此时的炉膛出口烟气温度,然后求出炉膛的平均热有效性系数和炉膛清洁因子,最后根据清洁因子的大小来判断锅炉的结渣特性。该模型不仅能根据锅炉运行实时数据的采集,实现锅炉结渣特性的在线实时监测,而且能对煤质不均匀或采用混煤燃烧等情况的锅炉结渣特性做出较准确的判别。     

基于改进灰狼优化算法的涡扇发动机性能/喷流噪声综合优化控制研究

为保证整个飞行过程中满足噪声适航标准和飞行器的安全性,需要按照最严苛的噪声要求进行发动机设计,并留有很大的安全裕度,因而导致发动机的性能潜力未能得到发挥。本文对传统灰狼算法进行了改进,提出自适应概率变异策略,在优化过程中调整狩猎模式,提升了算法的全局搜索能力;基于该算法开展涡扇发动机性能/喷流噪声综合寻优控制研究,根据不同飞行需求对航空发动机性能进行优化,获得最佳控制量,在满足安全性和噪声指标的同时,提高发动机的性能。仿真结果表明,改进后的算法具有更好的全局寻优性能,最大推力模式下可提升推力13.45%,最小油耗模式可降低油耗3.19%,最低涡轮前温度模式可降低涡轮前温度2.07%。     

基于微型涡喷发动机热喷流的无源流体推力矢量喷管的控制规律

流体推力矢量喷管型面固定、活动部件少、结构重量轻，能够为高机动飞行器提供有效的飞行控制手段，但无源流体推力矢量喷管热喷流的偏转控制规律尚未完全掌握。为了推进无源流体推力矢量技术的实用化，本文设计研制了适用于微型涡喷发动机的耐高温喷管模型，对该喷管在微型涡喷发动机热喷流状态下的控制规律进行研究。利用非接触光学显示和测量手段——红外热成像拍摄和粒子图像测速（PIV）技术对主射流流动特性进行研究，获得流动矢量角随二次流控制阀门闭合度变化的控制规律；利用六分量盒式天平测力实验研究无源流体推力矢量喷管的力学特性，获得推力矢量角随二次流控制阀门闭合度变化的控制规律。研究结果表明：该构型喷管在微型涡喷发动机热喷流下主射流连续可控偏转，最大流动矢量角为-12.3°/12.3°，最大推力矢量角为-12.9°/12.8°，控制规律接近线性，不存在主射流偏转突跳问题。     

等离子体助燃下超燃支板燃烧室燃烧特性数值研究

为了将支板喷注器与等离子体射流这两种促进超声速燃烧室燃烧的方式结合起来,设计了一种带有等离子体射流喷孔的支板燃烧室,并在超声速来流的条件下,针对燃料喷注总压、燃料喷注位置、等离子体射流介质、等离子体射流总压对燃烧室燃烧性能的影响进行了三维数值模拟。研究发现:增大燃料的喷注总压,燃烧室的燃烧范围明显增大,燃烧效率呈现出先增大后减小的趋势,在燃料喷注总压为2.0MPa时,燃烧效率达到最大值90.4%;不同的燃料喷注位置对燃烧室的燃烧范围影响较小;等离子体射流介质为O2时,燃烧效率最高,燃烧范围最广;提高等离子体射流的喷注总压,能够提升凹腔剪切层高度,有效促进燃烧,但同时也带来了更高的总压损失。     

Aerodynamic performance enhancement for flapping airfoils by co-flow jet

Introducing active flow control into the design of flapping wing is an effective way to enhance its aerodynamic performance. In this paper, a novel active flow control technology called Co-Flow Jet (CFJ) is applied to flapping airfoils. The effect of CFJ on aerodynamic performance of flapping airfoils at low Reynolds number is numerically investigated using Unsteady Reynolds Averaged Navier-Stokes (URANS) simulation with Spalart-Allmaras (SA) turbulence model. Numerical methods are validated by a NACA6415-based CFJ airfoil case and a S809 pitching airfoil case. Then NACA6415 baseline airfoil and NACA6415-based CFJ airfoil with jet-off and jet-on are simulated in flapping motion, with Reynolds number 70,000 and reduced frequency 0.2. As a result, CFJ airfoils with jet-on generally have better lift and thrust characteristics than baseline airfoils and jet-off airfoil when C_μ is greater than 0.04, which results from the CFJ effect of reducing flow separation by injecting high-energy fluid into boundary layer. Besides, typical kinematic and geometric parameters, including the reduced frequency and the positions of the suction and injection slot, are systematically studied to figure out their influence on aerodynamic performance of the CFJ airfoil. And a variable C_μ jet control strategy is proposed to further improve effective propulsive efficiency. Compared with using constant C_μ, an increase of effective propulsive efficiency by 22.6% has been achieved by using prescribed variable C_μ for NACA6415-based CFJ airfoil at frequency 0.2. This study may provide some guidance to performance enhancement for Flapping wing Micro Air Vehicles (FMAV).     

空间光学载荷低温部件地面气体保护系统设计

针对空间光学载荷低温部件的特点及其对水汽污染物控制的特殊需求,分析水汽污染物对该类型部件的污染过程及防护方法,制定通过惰性气体正压保护防止水汽污染的技术途径和方案,设计地面无间断气体保护防污染系统,以实现对环境温湿度、保护气体温湿度等环境参数的全过程记录、预警/报警、局部调节等功能。系统测试结果表明,地面气体保护系统能够较好地实现预定设计功能,对该类低温部件的保护具备一定的工程实用价值。     

A general calculation method to specify center-of-buoyancy for the stratospheric airship with multiple gas cells

As the lighter-than-air (LTA) flight vehicle, the stratospheric airship is a desirable platform to provide communication and surveillance services. During the ascent from sea-level to the mission altitude, the volume of the lifting gas may change significantly, which will result in the change of the center-of-buoyancy (CB). A general calculation method is developed to specify CB for the stratospheric airship with a double-ellipsoid hull and an arbitrary number of the gas cells. The cross-section-integral (CSI) method is used as a basic calculation scenario to specify CB. Considering the complexity in determining the boundary between the helium and air in the gas cell, a searching algorithm is put forward and the specification of CB can be conducted by the iterative calculation. As an important application, the stable condition of the pitch angle is analyzed when the change of CB is involved. Under different initial configurations, the stable pitch angle of the stratospheric airship during the ascent is specified and compared, which shows the advantages of the multi-gas-cell configuration. The results of this paper may provide an important reference for the engineering application of the stratospheric airship.     

Numerical simulations of turbulent flows in aeroramp injector/gas-pilot flame scramjet

To uncover the internal flow characteristics in an ethylene-fueled aeroramp injector/gaspilot(ARI/G-P)flame scramjet,a Reynolds-averaged Navier-Stokes(RANS)solver is constructed under a hybrid polyhedral cell finite volume frame.The shear stress transport(SST)k-x model is used to predict the turbulence,while the Overmann’s compressibility corrected laminar flamelet model is adopted to simulate the turbulent combustion.Nonreactive computations for Case 1(G-P jet on),Case 2(ARI jets on),and Case 3(both ARI and G-P jets on)were conducted to analyze the mixing mechanism,while reactive Cases 4–7 at equivalent ratios of 0.380,0.278,0.199 and0.167 respectively were calculated to investigate the flame structure and combustion modes.The numerical results are compared well to those of the experiments.It is shown that the G-P jet plays significant role in both the fuel/air mixing and flame holding processes;the combustion for the four reactive cases takes place intensively in the regions downstream of the ARI/G-P unit;Cases 4 and 5are under subsonic combustion mode,whereas Cases 6 and 7 are mode transition critical and supersonic combustion cases,respectively;the mode transition equivalent ratio is approximately 0.20.     

非恒定增压式微尺度拉瓦尔喷管流动特性

针对微尺度喷流在航天器运动状态切换时出现的非恒定增压变化,采用直接模拟蒙特卡洛(DSMC)方法对阶跃式增压和线性式增压两种模式下的微尺度拉瓦尔喷管流场进行了模拟,并对其变化过程中的流动特性进行了对比分析。结果显示：阶跃式增压会导致流动特性出现较大幅值的峰谷式波动,而线性式增压下的流动特性则呈现出线性变化的特点;黏性力对微尺度喷流的非恒定增压变化产生了重要的黏滞作用,在喉部扩张段至出口的流场中尤为明显;在设定的条件下,阶跃式增压过程中喷流产生的总冲量较线性式增压高59.5%,质量流量高74.7%,单位工质提供的冲量低约8.6%,波动性也高于线性式模型,阶跃式增压适用于系统需要较大推力改变运动状态且推进剂充足的情况,而线性式增压在系统精确微调或需要推进剂产生更高效能时具有明显的优势。