大庆RP-3航空煤油热物性分析

1引言在超燃冲压发动机的实际运行过程中,吸热碳氢燃料通常被当作冷却剂去吸收气动加热和燃烧施于机体的热量,其温度和状态随着飞行马赫数的不同而发生变化。与液态燃料相比,在加热条件下,燃料的热物理特性及其喷注、混合和燃烧等过程有很大的不同,例如,临界点附近燃料的热力学     

Experimental study on flow excursion instability of supercritical hydrocarbon fuel in scramjet regenerative cooling parallel channels

Flow instability of supercritical hydrocarbon fuel is a crucial issue in scramjet regenerative cooling structure. In this study, flow excursion instability and flow distribution in parallel tubes were experimentally studied for supercritical fluids. Two types of flow excursion occur in a single tube. Type I and Type II excursions, and they are corresponding to decreasing and increasing flow rate respectively. They can trigger flow maldistribution between parallel tubes and the hysteresis phenomenon of flow distribution. The effects of system parameters, including inlet temperature, system pressure, and heat flux, on flow distribution were analyzed. In addition, the relationship between flow excursion and the pseudo-critical interval proposed in the literature was established according to the heated tube outlet temperature at the onset of flow instability. Finally, the flow excursion instability boundary was obtained using two dimensionless parameters. These experimental results can provide helpful insight on the mechanism of Scramjet regenerative cooling.     

可压缩管流中真实气体效应的理论分析与数值模拟

为研究超燃冲压发动机冷却通道内复杂碳氢燃料的可压缩流动特性及相关影响因素,本文在典型工况条件下讨论了超声速膨胀流中真实气体效应的影响。基于平衡热力学理论,明确了气体动力学基础导数对可压缩流动的关键影响,并从气体动力学基础导数的角度出发考察了多种碳氢燃料在临界点附近的特性。同时,在数值模拟程序中耦合了立方型状态方程以准确描述超临界碳氢燃料的热物性参数。最后,对超临界条件下的二维超声速膨胀流进行了数值模拟,捕捉到了超声速扩张管道流动中马赫数下降的现象并揭示了其相应的物理机制。此外,参考发动机冷却通道内的典型工况条件,系统考察了不同入口马赫数、压力与温度等不同来流条件下真实气体效应的影响规律。     

超薄翼型上液压系统布置的设计分析

超薄翼型飞机后梁空间狭小,无法为液压管路系统提供足够的空间。分别从液压系统泄漏、液压油介质的腐蚀性、穿燃油箱的密封性、对燃油箱温度的影响以及对液压能源系统本身的影响等设计问题进行分析,提出了将部分液压管路布置在燃油箱内的方案。试验证明此设计方案能满足系统要求和适航要求。     

Pressure distribution feature-oriented sampling for statistical analysis of supercritical airfoil aerodynamics

In the field of supercritical wing design, various principles and rules have been summarized through theoretical and experimental analyses. Compared with black-box relationships between geometry parameters and performances, quantitative physical laws about pressure distributions and performances are clearer and more beneficial to designers. With the advancement of computational fluid dynamics and computational intelligence, discovering new rules through statistical analysis on computers has beco...     

A power and thermal management system for long endurance hypersonic vehicle

Due to the pneumatic heating and combustion effect, the scramjet engine of hypersonic vehicle faces high temperature challenge. It is necessary to comprehensively consider its thermal management and power generation together. A new Power and Thermal Management System (PTMS) combined with Supercritical Carbon Dioxide (SCO₂) closed Brayton cycle and fuel vapor turbine is proposed and discussed in this paper. The new PTMS can meet the cooling requirement of hypersonic vehicle at Mach number 6–7, and avoid the coking and scrapping in the scramjet cooling channels. Compared with the PTMS only based on fuel vapor turbine, the new PTMS utilizes the waste heat of scramjet to generate more electricity. In addition, it can reduce the use of fuel sink for cooling, and the additional weight penalty can be compensated for long endurance hypersonic flight.     

耐高温柔性PI 气凝胶的合成与性能

以3,3’,4,4’ -联苯四酸二酐(BPDA)和含咪唑环的芳香族二胺,2-(4-氨基苯基) -5-氨基苯并
咪唑(4-APBI)或2-(3-氨基苯基) -5-氨基苯并咪唑(3-APBI) 为聚合单体,以八( 氨基苯基) 聚倍半硅氧烷
(OAPS)为交联剂,采用超临界CO2 干燥工艺制备了两种PI 气凝胶,PIA-1(BPDA/4-APBI/ OAPS) 与PIA-2
(BPDA/3-APBI/ OAPS)。研究表明,制备的PI 气凝胶具有纳米串珠状的微观结构,其泡孔最可几孔径分别为
22 nm(PIA-1)与14 nm(PIA-2)。PIA-1 与PIA-2 的密度分别为0. 105 和0. 080 g/ cm3,BET 表面积分别为
693 和302 m2 / g。此外,制备的PI 气凝胶具有良好的柔韧性与耐热稳定性,Tg 超过了350℃,T5
d 超过了530℃。