用ACP提高硝胺改性双基推进剂的燃速

通过添加快燃物ACP来提高硝胺改性双基推进剂的燃速，得到了ACP影响推进剂燃速的一般规律：推进剂的燃速随ACP的含量和粒度的增大而增大。运用热分析、扫描电镜、燃烧火焰单幅照相、燃烧波温度分布等分析和测试手段来研究含ACP的硝胺改性双基推进剂的燃烧过程，揭示了ACP提高推进剂燃速的机理：ACP的快速燃烧，使得推进剂燃面增大和传热量增加，导致推进剂燃速增加。     

气动加热模拟试验加热系统控制研究

本文通过理论分析和试验测试研究了可控硅功率调节装置和石英灯加热器的动特性，提出了通过系统识别的方法研究石英灯加热器的静特性；在研究被控对象特性基础上找到了对任意一个石英灯加热器组成的被控对象进行非线性PID控制器的设计方法。这些方法提高了控制的质量，缩短了试验准备的周期，并进行准自适应控制，从而改善了气动加热模拟试验加热系统的控制效果。     

航天飞机防热瓦缝隙气动加热的讨论

本文根据航天飞机防热瓦缝隙流动的特点,从二维定常不可压缩层流的 N-S方程出发,提出了一个简化流动模型,即缝隙的二维流动可近似当作两个准一维沟槽流动的线性迭加,由此给出了缝隙中的热流率与压力、压力梯度和缝隙宽度的变化规律,并利用现有的实验结果作了验证。     

极光区电离层Hall电导率的观测及其在E层电子加热情况下的特征

本文利用欧洲的ＥＩＳＣＡＴ雷达观测资料及与这配合的地磁观测数据，用电离层参数直接计算和地面磁场反演两种方法导出了极区电离层Ｈａｌｌ电导率，特别显示出在强对流电场激发的Ｅ层等离子体不稳定波对电子加热情况下，电导率明显增高。     

瞬态气动模拟加热控制中的快速高精度"E-T"转换

为了准确模拟飞行器在高速飞行时的瞬态气动加热状态,必须使用快速、高精度的计算机瞬态热能控制系统,对气动模拟试验的加热过程,实行快速、高精度的非线性动态控制.为此,传感器的快速、高精度"E-T"转换是一个必须解决的非常重要的问题.提出一种高速飞行器瞬态气动加热控制系统中传感器的快速、高精度"E-T"转换方法.该方法具有计算简单、转换速度快、校正精度高的优点,使用该方法实现了高速飞行器气动加热过程中温度场高速变化状态下的瞬态非线性动态控制.     

高空高速无人飞行器热控制系统设计

针对飞行时间短、速度和高度变化快、表面温度波动大的无人飞行器UAV(Unmanned Aerial Vehicles)热控制系统设计难题,提出了一种可解决实际工程问题的热分析计算方法.即把热天工况、冷天工况和标准天工况作为设计/试验工况;采用参考温度法、高超音速工程预测法或计算流体动力学CFD(Computational Fluid Dynamics)数值模拟法,确定了飞行器表面温度分布,并把其作为后续热分析数学模型的外边界条件;分析结构热容量对瞬态热载荷的影响,建立与之相应的边值问题方程,并采用有限差分法求解;根据高空高速飞行特点及瞬态热载荷值,确定仪器设备舱调温系统方案.     

Study of GNSS-measured ionospheric total electron content variations generated by powerful HF-heating

The purpose of this work is to report the experimental evidences for the influence of perturbations in the electron density in the dayside mid-latitude ionosphere, that are caused by high-frequency heating of the F2 layer, on the GNSS signals. The experiments were carried out at the Sura heater (Radio Physical Research Institute, N. Novgorod). During the sessions of ionospheric heating with different time modulations of the radiated power the rays linking the navigational satellites with the ground receiver intersected the heated region. Variations in the total electron content (TEC) were studied; these variations are proportional to the reduced phases of navigational signals. It is shown that with the square-wave modulation of the radiated power (with periods of 1, 6, 10 and 15 min), perturbations with periods of the main modulation of heating and its harmonics appear in the spectrum of TEC variations. Examples are presented of identification of the heating-induced variations in TEC, including determination of the amplitudes and time characteristics of these variations.     

等离子体助燃下超燃支板燃烧室燃烧特性数值研究

为了将支板喷注器与等离子体射流这两种促进超声速燃烧室燃烧的方式结合起来,设计了一种带有等离子体射流喷孔的支板燃烧室,并在超声速来流的条件下,针对燃料喷注总压、燃料喷注位置、等离子体射流介质、等离子体射流总压对燃烧室燃烧性能的影响进行了三维数值模拟。研究发现:增大燃料的喷注总压,燃烧室的燃烧范围明显增大,燃烧效率呈现出先增大后减小的趋势,在燃料喷注总压为2.0MPa时,燃烧效率达到最大值90.4%;不同的燃料喷注位置对燃烧室的燃烧范围影响较小;等离子体射流介质为O2时,燃烧效率最高,燃烧范围最广;提高等离子体射流的喷注总压,能够提升凹腔剪切层高度,有效促进燃烧,但同时也带来了更高的总压损失。     

基于自动控制的蒸汽式热压机加热控制系统研究

介绍一种用于多层加热加压聚合生产绝缘材料的热压机加热系统,它具有自动化程度高、高效、节能的特点,将现有的蒸汽式加热系统的温度均匀性控制提高到一个新的台阶。     

Numerical simulations of turbulent flows in aeroramp injector/gas-pilot flame scramjet

To uncover the internal flow characteristics in an ethylene-fueled aeroramp injector/gaspilot(ARI/G-P)flame scramjet,a Reynolds-averaged Navier-Stokes(RANS)solver is constructed under a hybrid polyhedral cell finite volume frame.The shear stress transport(SST)k-x model is used to predict the turbulence,while the Overmann’s compressibility corrected laminar flamelet model is adopted to simulate the turbulent combustion.Nonreactive computations for Case 1(G-P jet on),Case 2(ARI jets on),and Case 3(both ARI and G-P jets on)were conducted to analyze the mixing mechanism,while reactive Cases 4–7 at equivalent ratios of 0.380,0.278,0.199 and0.167 respectively were calculated to investigate the flame structure and combustion modes.The numerical results are compared well to those of the experiments.It is shown that the G-P jet plays significant role in both the fuel/air mixing and flame holding processes;the combustion for the four reactive cases takes place intensively in the regions downstream of the ARI/G-P unit;Cases 4 and 5are under subsonic combustion mode,whereas Cases 6 and 7 are mode transition critical and supersonic combustion cases,respectively;the mode transition equivalent ratio is approximately 0.20.