拉扭疲劳试验机同步校准技术研究

介绍了一种新型力值、扭矩多分量传感器，在此传感器的基础上，研究力值、扭矩两参数同步校准技术，从而实现了对拉扭疲劳试验机的系统校准，解决了以往分参数校准存在不可靠性的难题，保证了拉扭疲劳试验机各参数整体系统的准确性。     

飞轮微振动的组合隔振装置设计及实验研究

针对光学遥感卫星飞轮微振动引起的成像质量下降问题，设计了一种组合隔振装置，并采用仿真分析与实验测试相结合的方法对隔振方案设计的合理性进行验证。首先，将测量的飞轮扰振数据引入光学卫星的有限元模型中，计算出飞轮扰振对光学相机的像素偏移影响；其次，设计了组合隔振方案并基于有限元方法对其隔振效果进行验证；最后，搭建了光学成像微振动实验测试平台，对不同转速下飞轮微振动造成的像素偏移影响进行精确测量。实验结果表明，组合隔振装置对300 Hz以上高频段飞轮扰振有较大衰减作用，最大像素偏移降到0.01个像素以下，隔振效率达到80%以上；通过对比可知，实验测试与仿真计算得到的像素偏移结果在低频段一次谐波响应及模态响应表现出较好一致性，但在高频段二者存在一定偏差。     

Voting fusion adaptation for landmine detection

This paper presents a voting fusion application for use with a remotely controlled multisensor vehicle platform for antitank landmine detection. Data from three landmine detection sensors mounted at the front of the vehicle enhance the probability of detection and, when combined via data fusion, limit the false alarm density to practical levels. The performance of the voting fusion scheme presented in this paper is contrasted with a heuristic data fusion approach developed by General Dynamics Canada.     

建立空分中N2O的检测方法,确保设备安全运行

介绍了建立N2O检测方法原由,操作变量的选优及对空分安全生产的建议.     

A new and robust CFAR detection algorithm

A constant false alarm rate (CFAR) detection method which is based on a combination of median and morphological filters (MEMO) is proposed. The MEMO algorithm has robust performance with small CFAR loss, very good behavior at clutter edges and high detection performance in the case of closely spaced narrowband signals (targets). The proposed MEMO method is favourably compared with cell averaging (CA) and ordered statistics (OS) CFAR detectors. The Monte Carlo method is employed to analyze the MEMO-CFAR detector     

旋流杯结构及进气参数对燃烧性能的影响

为优化旋流燃烧室头部结构、提高其运行性能,针对三种旋流器文氏管和燃料喷嘴的组合结构和两种流通面积的旋流器,开展了常压下以甲烷为燃料的燃烧室性能实验研究。实验结果表明,各头部结构的冷态总压损失系数与来流速度的平方成正比,燃料喷嘴插入文氏管的位置过深或过浅都会增大流动阻力,在来流速度9.7m/s条件下,喷嘴处于中等插入位置时总压损失系数降低6%左右;开放空间下,燃料喷嘴的位置越浅越利于火焰稳定,受限条件下这种影响被缩小,并且受限火焰的稳定工作范围明显宽于相同入口条件下的开放火焰;增大旋流器流通面积有利于降低总压损失系数、增强火焰稳定、减轻火焰筒壁面振动幅度,但不利于促进燃料和空气掺混,导致NO和CO的排放浓度都变大;在临近贫油熄火状态时,火焰筒壁面振动幅度加剧,明显高于稳定燃烧时的情况。     

AC/DC converter topologies for the Space Station

A new class of AC/DC converter topologies (Type-1 converters) is described, suitable for use in an advanced single-phase sine-wave voltage, high-frequency power distribution system, of the type that was proposed for a 20 kHz Space Station primary electrical power distribution system. The converter comprises a transformer, a resonant network, a current controller, a diode rectifier, and an output filter. The input AC voltage source is converted into a sinusoidal current source using the resonant network. The output of this current source is rectified by the diode rectifier and is controlled by the current controller. The controlled rectified current is then filtered by the output filter to obtain a constant voltage across the load. Three distinct converter topologies, Type-1A, Type-1B, and Type 1-C, are described, and their performance characteristics are presented. All three types have a close-to-unity rated power factor (greater than 0.98), low total harmonic distortion in input current (less than 5%), and high conversion efficiency (greater than 96%)     

一种整体式天然气压缩机气阀故障诊断技术研究CSCD

整体式天然气压缩机在石油化工领域广泛应用,压缩机的正常工作对安全生产具有重要意义。为了有效诊断整体式压缩机气阀部件的故障,采用了Daubechies小波基函数对ZTY470型整体式天然气压缩机气阀振动信号的分解重构原理,详细介绍了以振动信号的能量为故障特征的故障诊断过程。对气阀阀片断裂和弹簧断裂的故障振动信号进行了小波包分析,并与正常工作时的信号进行了对比。实验表明该方法能准确的进行故障诊断和故障定位,证明了对整体式天然气压缩机气阀故障诊断的有效性。     

静止轨道卫星通信链路的预算与分析

星地链路计算作为卫星通信的重要技术，是卫星通信系统设计的基础和理论依据，直接决定了卫星通信系统的链路通信质量。由于影响卫星链路的因素很多，设计中存在一处不合理即使得整条星地链路不可用，造成巨大的损失。而且在实际设计中无法做到最理想的链路状态，往往需要在某方面有所取舍，这也是链路计算中的一大难点。基于目前国际通用的链路计算方法，将星地链路上下行拆分，独立计算，综合分析，再结合实际工程经验，分析和计算实际工程案例，针对不同的链路配置给出相应合理的设计方法，可作为静止轨道通信卫星星地链路计算分析的参考。