The Electron Radiation Belt

Electron radiation belts can change dramatically in a few seconds or slowly over years. Important issues in understanding such changes are: (1) What is the source of electrons in the radiation belts? (2) How important is radial diffusion compared to other radial transport mechanisms? (3) What are the detailed changes in the magnetosphere that produce radial diffusion? (4) Why is the response of the electron radiation belt to changes in the solar wind different from that of substorms and of the ring current? (5) Are processes other than radial transport, such as wave-particle interactions, important in energizing electrons in the radiation belts?     

深基坑支护——土钉墙的应用

介绍了土钉墙的基本原理和应用范围，通过土钉墙在南方某地铁车站的具体实例，说细介绍了土钉墙的施工工艺及施工方法，总结了土钉墙在应用中常见的问题及处理措施。     

新建他激反激变换器方程及其解析解

引用文 [1 ]的思路 ,寻找他激反激变换器的运行状态特征参量 (磁通密度增量、剩余磁通密度和占空比 )与构成这一变换器的基本物理参量之间的函数关系。首先阐明由于频率给定 ,他激反激变换器稳态运行时会出现无剩磁工况和有剩磁工况两种。而后确定这两种工况下 ,磁路等效储能空间单位体积每个周期的传输能量 (命名为“磁能传输密度”)。在这基础上 ,分别建立和解出他激反激变换器在不同工况下稳定运行时应满足的方程。最后根据所得的解析解阐明这种变换器的特性。本文和文 [1 ],以磁路分析为基础建立了一种新的反激变换器理论。     

航天器回收用静压高度控制器的研制

静压高度控制器是载人飞船启动回收着陆系统的关键部件,也是返回式卫星和其它航天器回收系统启动信号的一种方式,其经受恶劣环境,性能、要求高。静压高度控制器又分为膜盒式和硅压力式,文章主要论述了硅压力静压高度控制器在回收系统中的作用,主要介绍了它的工作原理和组成,研制中解决的电路、结构及可靠性方面的问题,并给出了试验结果和研制结论。     

紧固件的抽样检验

从统计抽样的基本概念出发,分析了航天产品常用的紧固件抽样检验的规则并对抽样方案作了详细地介绍。     

High speed driving of a gain-switched laser diode with anexponential transmission line

With the increase of information capacity of an airborne system, high speed driving of laser diodes have been of interest. In order to match the low resistive LD, proposed in this paper is an exponential transmission line, which is used as preshaping to compensate the pattern effect in gain switching of laser diodes. It also will be used to overcome the effect of parasitic elements in high speed driving to improve the rise and trail edges of the output waveform. An accurate circuit model of the exponential line for the PSPICE program has been developed and simulations are conveniently carried out by employing PSPICE     

复合材料面内剪切Iosipescue方法分析及试验研究

讨论了采用双Ｖ形开槽试样的Ｉｏｓｉｐｅｓｃｕ剪切试验方法的应用，分析了影响试验的因素，对Ｔ３００／５２２２复合材料单向板及π／４多向铺层层合板进行了试验研究。试验结果表明，此方法可以很好地用于复合材料剪切试验。     

Dose equivalent, absorbed dose and charge spectrum investigation in low Earth orbit.

Particle intensity, dose equivalent and absorbed dose have been measured on board the space shuttle Endeavour during STS-108 in December 2001 by Dublin Institute for Advanced Studies (DIAS). The dose estimates are based on very accurate measurements of recoils produced in CR-39 by cosmic ray primary and secondary protons and heavier nuclei and by secondary neutrons. The corresponding LET spectra were used to determine dose equivalent and absorbed dose values. Estimates of the total flux of Z > or = 2 nuclei have been undertaken and a preliminary charge spectrum was measured. Some comparisons are made with preliminary data obtained on STS-105 (ISS Expedition) and other missions using CR-39 detectors.     

用于高压动态校准的快开阀装置

介绍一种高压快开阀装置。它可产生３７０ＭＰａ上升时间小于２０μｓ的阶跃压力，用于对高压传感器进行动态校准。     

复合材料层板中就位横向拉伸强度的研究

本文利用弹性力学和断裂力学方法对纤维增强复合材料的横向拉伸强度进行了分析，其中考虑了９０度开裂层厚度和开裂邻层的约束效应的影响，推导出正交各向异性对称铺层中昨合就位横向拉伸强度的数学表达式，得出开裂层的厚度和约束邻层铺设角对就位横向拉伸强度都有影响的结论，理论计算与Ｆｌａｇｇｓ实验结果吻合较好。