Field formation around negatively biased solar arrays in the LEO-plasma

Heavy emission caused by impacting plasma ions results in a fast discharging effect of the initially large surface potentials on the dielectric solar cells. This eventually counteracts the energization process of the plasma ions to the cover glasses and leaves no significant electric fields. Thus, with an existing thermal plasma, electrons are again able to reach dielectric surfaces. Strong localized electric fields of the order of several 10 kV/cm form near the interconnector-cover glass interface.     

Global Response of Martian Plasma Environment to an Interplanetary Structure: From Ena and Plasma Observations at Mars

As a part of the global plasma environment study of Mars and its response to the solar wind, we have analyzed a peculiar case of the subsolar energetic neutral atom (ENA) jet observed on June 7, 2004 by the Neutral Particle Detector (NPD) on board the Mars Express satellite. The “subsolar ENA jet” is generated by the interaction between the solar wind and the Martian exosphere, and is one of the most intense sources of ENA flux observed in the vicinity of Mars. On June 7, 2004 (orbit 485 of Mars Express), the NPD observed a very intense subsolar ENA jet, which then abruptly decreased within ∼10 sec followed by quasi-periodic (∼1 min) flux variations. Simultaneously, the plasma sensors detected a solar wind structure, which was most likely an interplanetary shock surface. The abrupt decrease of the ENA flux and the quasi-periodic flux variations can be understood in the framework of the global response of the Martian plasma obstacle to the interplanetary shock. The generation region of the subsolar ENA jet was pushed towards the planet by the interplanetary shock; and therefore, Mars Express went out of the ENA jet region. Associated global vibrations of the Martian plasma obstacle may have been the cause of the quasi-periodic flux variations of the ENA flux at the spacecraft location.     

High Dynamic GPS Receiver Using Maximum Likelihood Estimationand Frequency Tracking

A new high dynamic global positioning system (GPS) receiver ispresented and its performance characterized by analysis,simulation, and demonstration. The demonstration receiver is abreadboard model capable of tracking a single simulated satellitesignal in pseudorange and range rate. Pseudorange and range rateestimates are made once every 20 ms, using a maximum likelihoodestimator, and are tracked by means of a third-order fadingmemory filter in a feedback configuration. The receiver trackspseudorange with rms errors of under 1 m when subjected tosimulated 50 g, 40 g/s circular trajectories. The tracking thresholdis approximately 28 dB·Hz, which provides 12 dB margin relativethe the minimum specified signal strength, assuming 3.5 dB systemnoise figure and 0 dB antenna gain.     

A bioreactor system for the nitrogen loop in a Controlled Ecological Life Support System.

As space missions become longer in duration, the need to recycle waste into useful compounds rises dramatically. This problem can be addressed by the development of Controlled Ecological Life Support Systems (CELSS) (i.e., Engineered Closed/Controlled Eco-Systems (ECCES)), consisting of human and plant modules. One of the waste streams leaving the human module is urine. In addition to the reclamation of water from urine, recovery of the nitrogen is important because it is an essential nutrient for the plant module. A 3-step biological process for the recycling of nitrogenous waste (urea) is proposed. A packed-bed bioreactor system for this purpose was modeled, and the issues of reaction step segregation, reactor type and volume, support particle size, and pressure drop were addressed. Based on minimization of volume, a bioreactor system consisting of a plug flow immobilized urease reactor, a completely mixed flow immobilized cell reactor to convert ammonia to nitrite, and a plug flow immobilized cell reactor to produce nitrate from nitrite is recommended. It is apparent that this 3-step bioprocess meets the requirements for space applications.     

Dose equivalent, absorbed dose and charge spectrum investigation in low Earth orbit.

Particle intensity, dose equivalent and absorbed dose have been measured on board the space shuttle Endeavour during STS-108 in December 2001 by Dublin Institute for Advanced Studies (DIAS). The dose estimates are based on very accurate measurements of recoils produced in CR-39 by cosmic ray primary and secondary protons and heavier nuclei and by secondary neutrons. The corresponding LET spectra were used to determine dose equivalent and absorbed dose values. Estimates of the total flux of Z > or = 2 nuclei have been undertaken and a preliminary charge spectrum was measured. Some comparisons are made with preliminary data obtained on STS-105 (ISS Expedition) and other missions using CR-39 detectors.     

New instrumentation for optical measuring of oxygen in gas or dissolved in liquids.

The optical oxygen sensor is a novel device for the determination of oxygen in gases or dissolved in liquids. It is based on the measurement principle of fluorescence quenching, which is completely different from that of polarographic oxygen sensors (today the most widespread devices of oxygen detection). The new instrument offers features and advantages, which render it not only a realistic alternative, but, for specific applications, make it superior to existing electrochemical methods. The system is based on low-cost semiconductor devices (light-emitting diodes, photodiodes, low-cost analogue and digital components) and new LED-compatible oxygen-sensitive membranes. The flow cell of the instrument may be thermostatted and the sensor can be calibrated by a simple two-point calibration procedure. The optical oxygen sensor is particularly suitable for measuring dissolved oxygen in respirometry, since no oxygen is consumed by the device and the signal is independent of sample flowrate or stirring speed. Typical fields of application are monitoring of oxygen in ground and drinking water, in process control in bioreactors and in breath gas and blood gas analysis.     

Injuries to plants from controlled environment contaminants.

The use of controlled environments is subject to problems from contaminants emitted from materials of the system and from plants. Many contaminants are difficult to identify because injurious dosages are very low, there is a lack of information on what compounds injure plants, because species and cultivars differ greatly in their sensitivity to injury and injury symptoms often are not distinctive. Plastics have been shown to emit many different volatile compounds. The compound, di-butyl phthalate, contained in certain flexible plastics, has been shown to be very toxic to plants. Other injuries have been produced by caulking compounds and bonded screening. Paints have been shown to release xylene that is toxic to plants. Steam for humidification can cause problems because of hydroxylamines and other compounds added to steam used for heating to control fungal growth in return lines. Mercury, from broken thermometers is a particular problem in growth chambers because small quantities can collect in cracks and slowly volatilize to slow growth of plants. Plants themselves release large quantities of volatile hydrocarbons, with ethylene being the commonly recognized chemical that can be damaging when allowed to accumulate. People release large quantities of carbon dioxide which can cause variations in the rate of growth of plants. Contaminant problems can be controlled through filtering of the air or ventilation with make-up air, however the potential for problems is always present and careful testing should be undertaken with the particular species and cultivars being grown insure that there are no toxic agents altering growth in each particular controlled environment being utilized.