某型教练机起落架信号电路改进设计

针对某型教练机存外场使用时出现起落架未放到位，而飞行员却没能及时发现的问题，本文对飞机起落架信号电路进行了分析，并提出了相应的改进措施。     

钉头型式对复合材料层合板机械连接强度的影响

通过3种不同铺层比例的复合材料层合板机械连接接头的挤压强度测试，研究了钉头型式对复合材料层合板机械连接挤压力学性能的影响，获得了沉头螺栓挤压强度修正系数。试验数据表明：采用沉头螺栓的复合材料机械接头 的挤压强度，可达到采用凸头螺栓的复合材料机械连接挤压强度的90%左右，但接头刚度仅为采用凸头螺栓的复合材料接头刚度的40%~50%。研究采用Hashin失效准则和Tan-Camanho损伤扩展方法，对两种钉头型式的复合材料层合板机械连接接头的挤压失效过程进行了有限元分 析，预测了复合材料层合板机械连接接头的偏移挤压强度和极限挤压强度，模型预测值与试验值的误差不超过15%。     

DELMIA在某民机前货舱门装配仿真中的应用

在现代自动化作业系统中,操作和管理的大多是一些复杂系统和各种数字化设备,这对操作人员观察周围环境和完成精准操作任务的要求很高。通过人机工程技术分析,可以对这些复杂、易错的任务逐个分析,合理分配注意力、安排操作顺序,既减轻操作人员的工作负荷又避免出错,切实提高人机工效。     

A straw-soil co-composting and evaluation for plant substrate in BLSS

Material closure is important for the establishment of Bioregenerative Life Support System, and many studies have focused on transforming candidate plant residues into plant culture medium. For the limitations of using wheat straw compost as substrate for plant cultivation, a straw-soil co-composting technique was studied. The changes of pH, C/N value, germination index, cellulose, lignin and so on were monitored during the co-composting process. The maturity was evaluated by the C/N value and the germination index. The result showed that after 45 days’ fermentation, the straw-soil final co-compost with inoculation (T1) became mature, while the co-compost without inoculation (T0) was not mature. In the plant culture test, the T1 substrate could satisfy the needs for lettuce’s growth, and the edible biomass yield of lettuce averaged 74.42 g pot⁻¹ at harvest. But the lettuces in T0 substrate showed stress symptoms and have not completed the growth cycle. Moreover, the results of nitrogen (N) transformation experiment showed that about 10.0% and 3.1% N were lost during the T1 co-composting and plant cultivation, respectively, 23.5% N was absorbed by lettuce, and 63.4% N remained in the T1 substrate after cultivation.     

运用GPS空中校正飞机无线电罗差误差分析

针对某些特种飞机无线电罗差无法沿用传统校正方法在地面进行校正的状况 ,首次提出了运用 GPS接收机在空中校正飞机无线电罗差的方法。本文对影响该校正方法校正精度的各项误差因素进行了分析。     

掉头路由器场景下组播丢包故障解析

针对HWS9306交换机在掉头路由器组网环境下PIM-ASM（协议无关组播-任意源组播）丢包问题,详细分析问题发生的过程,对其产生的机理进行准确定位;提出通过延长表项生存时间保证流量检测覆盖全部表项的解决方法,同时进行了影响域分析;最后,在原有场景下测试并验证解决方案的有效性。此案例对网络通信问题的分析、定位及解决具有一定的指导意义。     

Dynamic characteristics analysis of deployable space structures considering joint clearance

The clearance in joints influences the dynamic stability and the performance of deployable space structures (DSS). A virtual experimental modal analysis (VEMA) method is proposed to deal with the effects of joint clearance and link flexibility on the dynamic characteristics of the DSS in this paper. The focus is on the finite element modeling of the clearance joint, VEMA and the modal parameters identification of the DSS. The finite element models (FEM) of the clearance joint and the deployable structure are established in ANSYS. The transient dynamic analysis is conducted to provide the time history data of excitation and response for the VEMA. The fast Fourier transform (FFT) technique is used to transform the data from time domain to frequency domain. The frequency response function is calculated to identify the modal parameters of the deployable structure. Experimental verification is provided to indicate the VEMA method is both a cost and time efficient approach to obtain the dynamic characteristics of the DSS. Finally, we analyze the effects of clearance size and gravity on the dynamic characteristics of the DSS. The analysis results indicate that the joint clearance and gravity strongly influence the dynamic characteristics of the DSS.     

专用瞄准设备自动检定系统

介绍了专用瞄准设备自动检定系统的系统配置、工作原理及软件设计，并对系统的测量不确定度进行了分析和评定。     

烟丝配料单片机控制系统

本文介绍了配料生产过程中单片机控制系统的硬件结构及软件流程。由于硬件和软件设计上都采用了模块化的结构，所以便于安装调试，整个系统可推广到诸如水泥、矿产、食品加工等生产中。     

GRACE gravity field modeling with an investigation on correlation between nuisance parameters and gravity field coefficients

The GRACE (Gravity Recovery And Climate Experiment) monthly gravity models have been independently produced and published by several research institutions, such as Center for Space Research (CSR), GeoForschungsZentrum (GFZ), Jet Propulsion Laboratory (JPL), Centre National d’Etudes Spatiales (CNES) and Delft Institute of Earth Observation and Space Systems (DEOS). According to their processing standards, above institutions use the traditional variational approach except that the DEOS exploits the acceleration approach. The background force models employed are rather similar. The produced gravity field models generally agree with one another in the spatial pattern. However, there are some discrepancies in the gravity signal amplitude between solutions produced by different institutions. In particular, 10%–30% signal amplitude differences in some river basins can be observed. In this paper, we implemented a variant of the traditional variational approach and computed two sets of monthly gravity field solutions using the data from January 2005 to December 2006. The input data are K-band range-rates (KBRR) and kinematic orbits of GRACE satellites. The main difference in the production of our two types of models is how to deal with nuisance parameters. This type of parameters is necessary to absorb low-frequency errors in the data, which are mainly the aliasing and instrument errors. One way is to remove the nuisance parameters before estimating the geopotential coefficients, called NPARB approach in the paper. The other way is to estimate the nuisance parameters and geopotential coefficients simultaneously, called NPESS approach. These two types of solutions mainly differ in geopotential coefficients from degree 2 to 5. This can be explained by the fact that the nuisance parameters and the gravity field coefficients are highly correlated, particularly at low degrees. We compare these solutions with the official and published ones by means of spectral analysis. It is found that our solutions are, in general, consistent with others in the spatial pattern. The water storage variations of the Amazon, Chari and Ganges river basins have also been computed. The variations computed with the NPARB approach are closer to those produced by JPL and DEOS solutions, while the variations produced with the NPESS approach are in good agreement with those produced by the CSR and GFZ solutions. A simulation study is implemented with considering realistic noise and low-frequency error. The two approaches are used to recover the true model. The NPESS solution appears closer to the true one. Therefore we are inclined to estimate the nuisance parameters simultaneously with the geopential coefficients.