Analysis of queuing behavior of automatic ESM systems

Radar electronic support measures (ESM) systems detect active emitters in a given area and determine their identities and bearings. The high arrival rate of radar pulses in dense emitter environments demands fast automatic processing of arriving pulses so that the ESM system can fulfill its functions properly in real time. Yet, the performance analysis of automatic ESM system in real life Is difficult since both pulse arrivals and widths can be specified only probabilistically. The success of queuing theory in many applications such as computer communication networks and flow-control has encouraged designers to utilize queuing theory in qualifying and judging the performance of automatic ESM systems in dense emitter environments. The queuing behavior of these systems is analytically evaluated under different service disciplines and elaborate computer simulations validate the results. The analysis involves statistical modeling of arrival and departure processes as well as distribution of service times. It permits estimating the blocking probability due to high arrival rates of intercepted radar pulses or due to limited speed of the deinterleaver processor. Queuing analysis is shown to be quite useful to quantitatively assess tradeoffs in ESM systems design     

Time-dependent thermal X-ray afterglows from GRBS

Time-dependent thermal X-ray spectra are calculated from physically plausible conditions around GRB. It is shown that account for time-dependent ionization processes strongly affects the observed spectra of hot rarefied plasma. These calculations may provide an alternative explanation to the observed X-ray lines of early GRBs afterglows (such as GRB 011211). Our technique will allow one to obtain independent constraints on the GRB collimation angle and on the clumpiness of circumstellar matter.     

The Fine Structure of the AKR Electromagnetic Field as Measured by the Interball-2 Satellite

The fine structure of the Auroral Kilometric Radiation (AKR) is studied using multicomponent measurements of the electric component of the electromagnetic field in the frequency band 4 kHz–1 MHz (the POLRAD experiment onboard the INTERBALL-2 satellite). Special attention is paid to the measurements near the source of the AKR: under conditions when the lower boundary of the emission range descended sufficiently low, down to the local gyrofrequency of electrons. From the analysis of the electric field structure the conclusion is drawn that the bulk of the AKR power is carried by the signal component fast variable in time and frequency (flickering component). The power of a constant component (continuum) is lower by at least an order of magnitude. During strong bursts of the AKR, the relative contribution of the flickering component increases. The spatial structure of the zone of generation has at least three characteristic scales along and across the magnetic field.     

Aperture error mitigation via local-state estimation for frequency-based emitter location

This paper considers the problem of locating a stationary coherent emitter via a single moving platform making frequency measurements in the presence of aperture state uncertainty. It is shown that the estimated emitter location is most sensitive to the receiving aperture velocity uncertainty. The required aperture velocity accuracy is determined through a noninfinitesimal perturbation analysis. A solution to location accuracy enhancement with a minimal hardware addition is attempted. It is shown that this can be achieved by mounting a high-resolution tri-axis microelectromechanical systems (MEMS) accelerometer at the aperture to measure its velocity, which can deviate significantly from that estimated by the on-board navigation system. The Doppler shifts of the GPS signal carrier frequency, whenever it can be acquired through the aperture, are also considered as a way to aid the aperture velocity measurement. A decentralized, federated processing method for the aperture velocity estimate referenced at the aperture, integrating all measurement data, is presented. An upper bound for the error of aperture velocity estimate is derived. The potential for significant accuracy enhancement for emitter location is demonstrated.     

Removing autocorrelation sidelobes by overlaying orthogonal coding on any train of identical pulses

A coherent train of identical linear FM (LFM) pulses is used extensively in radar because of its good range and Doppler resolution. Its relatively high autocorrelation function (ACF) sidelobes are sometimes reduced through spectrum shaping (e.g., nonlinear FM, or intrapulse weighting on receive). We show how to completely remove most of the ACF sidelobes about the mainlobe peak, without any increase to the mainlobe width, by diversifying the pulses through overlaying them with orthonormal coding. A helpful byproduct of this design is reduced ACF recurrent lobes. The overlaid signal also results in reduced Doppler tolerance, which can be considered as a drawback for some applications. The method is applied to several trains of identical pulses (LFM and others) using several orthonormal codes. The effect on the three important properties of the radar signal: ACF, ambiguity function (AY), and frequency spectrum is presented. The effect on Doppler tolerance is studied, and implementation issues are discussed. The new design is also compared with complementary and sub-complementary pulse trains and is shown to be superior in many aspects.     

Operational testing of valve regulated lead acid batteries incommercial aircraft

Valve regulated lead acid (VRLA) batteries provide electrical performance that is virtually identical to sintered plate nickel-cadmium battery systems. In addition, the VRLA batteries offer the user a no-maintenance battery and other enhanced features that make this a very desirable battery for aircraft applications. In field trials, where VRLA batteries were substituted for nickel-cadmium batteries, the VRLA provided the user with a high reliability turbine engine starting battery under a wide variety of climatic conditions     

轴对称锻件成形过程的热力耦合有限元分析技术的研究

锻件成形过程中,非稳态、不均匀的温度场对金属的塑性流动有很大的影响，尤其是高温成形过程。本文对轴对称段件成形过程的热力耦合有限元分析技术进行了研究。论述了刚塑性有限元分析方法，建立了热力耦合分析模型，开发了轴对称锻件成形过程的热力耦合有限元分析软件。通过将圆柱体镦粗过程的模拟结果与有关文献中的实验结果和模拟结果的比较，说明了该方法和软件的正确性。     

An Experimental Radar Facility

A coherent CW superheterodyne radar system operating at frequencies of 9, 17, 35, and 70 GHz is described. The radars are installed on a free-flight range to study backscattering from wakes of hypersonic-velocity projectiles. Each radar is equipped with a focused-lens antenna oriented at an angle of approximately 45° to the flight axis. Amplitude and phase of the received signal are recorded separately. Some typical results are given to demonstrate the capabilities of the equipment.     

High-Sensitivity Quartz Accelerometer for Measurements of Small Accelerations of Spacecraft

A quartz sensor of small accelerations with a capacitive transducer is designed and produced, allowing one to measure spacecraft accelerations with a resolution of 10^–7 m/s² in the range ±10^–1 m/s². The results of calibration of the sensor by the method of inclinations are presented.