Tracking Accuracies with Position and Rate Measurements

Tracking accuracies for the radial component of motion are computed for a track-while-scan radar system which obtains position and rate data during the dwell time on a target These results will be of interest to persons developing trackers for pulse Doppler surveillance radars. The normalized accuracies, computed for a two state Kalman tracking filter with white noise maneuver capability, are shown to depend upon two parameters, r = 4?0/?aT2 and s = ?dT/?0. The symbols ?0 and ?d are the position and rate measurement accuracies, respectively, ?a is the standard deviation of the white noise maneuver process and T is the antenna scan time. The scalar tracking filter equations are derived and numerical results are presented. Lower steady state tracking errors plus the earlier attainment of steady state accuracies are the direct consequence of incorporating the rate measurements into the tracking filter.     

Some crucial X-ray observations — One or two SNR(s) in Crux?

A new EXOSAT (LE/CMA) observation of the region in Crux (R.A. 11h 45m, Dec. -62°) where Markert et al. (1981) reported the existence of two x-ray SNR's is presented. After cleaning the CMA field from the point source component, due to the UV emission of the numerous stars in the field, the smoothed x-ray contours are compared to the 408 MHz radio map of Caswell et al. (1983). The existence of two, well-separate x-ray emission regions is confirmed by EXOSAT, and the current x-ray/radio picture is not sufficent to distinguish clearly between the assumption of one or two (possibly interacting) SNR's in the region.     

Extensions of the Discrete-Average Models for Converter Power Stages

An improved power converter model is developed by combining the average and discrete modeling techniques. The parameter determination of the proposed discrete-average model is shown to be dependent on the type of duty cycle control law and the nature of the error processor used in the feedback loop. Furthermore, the paper pinpoints deficiencies of the conventional loop gain measurement technique which is widely used in industries.     

Position and Velocity Estimation Via Bearing Observations

The problem of performing target motion analysis using noisy bearing measurements derived from multiple observation platforms or from a single moving observer is addressed. For the latter case, the properties of an estimator based on a Cartesian model of the process are detailed. Methods of providing estimates both before an observer maneuver, when the process is unobservable, and following an observer maneuver are developed. The results of an experimental study are presented.     

Ultraviolet spectrometer experiment for the Voyager mission

The Voyager Ultraviolet Spectrometer (UVS) is an objective grating spectrometer covering the wavelength range of 500–1700 Å with 10 Å resolution. Its primary goal is the determination of the composition and structure of the atmospheres of Jupiter, Saturn, Uranus and several of their satellites. The capability for two very different observational modes have been combined in a single instrument. Observations in the airglow mode measure radiation from the atmosphere due to resonant scattering of the solar flux or energetic particle bombardment, and the occultation mode provides measurements of the atmospheric extinction of solar or stellar radiation as the spacecraft enters the shadow zone behind the target. In addition to the primary goal of the solar system atmospheric measurements, the UVS is expected to make valuable contributions to stellar astronomy at wavelengths below 1000 Å.     

Comments on "Computationally Efficient Bank of Rectangular Digital Filters"

In [1] a scheme for forming a rectangular FIR filter bank is described using only a few percent of the number of multiplications required by straightforward procedures. The sidelobe level suffers degradation. Attention is drawn to a different scheme published in [2] and [3] which needs even fewer multiplications without degradationvof the sidelobe level.     

Steady-state analysis of the constant-frequency clamped seriesresonant converter

A constant-frequency diode-clamped series resonant converter (CFCSRC) is proposed as a solution to problems associated with frequency-controlled resonant converters. This converter has two resonant frequencies, and control is achieved by varying the relative time spent at each switching frequency. Two zero-current-switching (ZCS) modes are examined and plotted in the output plane. An equation is given for the boundary between the two ZCS modes, as well as an expression for the boundary between ZCS and non-ZCS operation; both are plotted in the output plane. The output equation for the main mode is shown to be hyperbolic. Converter peak voltages limited to the input voltages, and peak currents are less than those of the frequency-controlled clamped series resonant converter over a large operating range. Data from a prototype converter are compared with theoretical data and are shown to be in good agreement with the theoretical model     

The FAST Satellite Fields Instrument

We describe the electric field sensors and electric and magnetic field signal processing on the FAST (Fast Auroral SnapshoT) satellite. The FAST satellite was designed to make high time resolution observations of particles and electromagnetic fields in the auroral zone to study small-scale plasma interactions in the auroral acceleration region. The DC and AC electric fields are measured with three-axis dipole antennas with 56 m, 8 m, and 5 m baselines. A three-axis flux-gate magnetometer measures the DC magnetic field and a three-axis search coil measures the AC magnetic field. A central signal processing system receives all signals from the electric and magnetic field sensors. Spectral coverage is from DC to 4 MHz. There are several types of processed data. Survey data are continuous over the auroral zone and have full-orbit coverage for fluxgate magnetometer data. Burst data include a few minutes of a selected region of the auroral zone at the highest time resolution. A subset of the burst data, high speed burst memory data, are waveform data at 2×10⁶ sample s^–1. Electric field and magnetic field data are primarily waveforms and power spectral density as a function of frequency and time. There are also various types of focused data processing, including cross-spectral analysis, fine-frequency plasma wave tracking, high-frequency polarity measurement, and wave-particle correlations.