EUV emission from normal galaxies

Using data from the Wide Field Camera EUV all-sky survey, we have established upper limits to the EUV flux from a sample of 30 bright, nearby, non-active spiral galaxies. These galaxies were chosen to be those most likely to be detected in the EUV on the basis of (i) low interstellar absorption within our own galaxy, (ii) brightness in other wavebands, (iii) high star formation activity, and (iv) proximity. The derived EUV upper limits are restrictive, and establish for the first time that the EUV flux escaping from galaxies does not constitute a major component of their bolometric luminosity, and in particular that it cannot be the sink for the energy injected into the interstellar medium by supernova explosions, as had been suggested following the failure to detect this power in the X-ray band.     

Reconfigurable NDI controller using inertial sensor failuredetection & isolation

A modified derivation of nonlinear dynamic inversion provides the theoretical underpinnings for a reconfigurable control law for aircraft that have suffered combinations of actuator failures, missing effector surfaces, and aerodynamic changes. The approach makes use of acceleration feedback to extract information pertaining to any aerodynamic change and thus does not require a complete aerodynamic model of the aircraft. The control law does require feedback of effector positions to accommodate actuator dynamics. Both accelerometer and rate gyro failure detection and isolation (FDI) systems are implemented, allowing up to three independent failures for each FDI system as long as they are in different axes. Nonlinear simulation results show that the FDI systems improve the robustness to accelerometer/rate gyro uncertainties. An advanced tailless aircraft model is used to demonstrate the concepts. The simulation includes accelerometer and rate gyro noise and bias, failures due to accelerometers, rate gyros, and actuators, and modeled missing surfaces that cause airplane aerodynamic changes     

褶皱结构成形时的形状偏差计算

解决了褶皱结构成形时相邻的平行四边形平面元素之间连接区棱的修圆半径值预测问题。把毛坯模拟成薄板，定义了平行四边形平面元素的边界条件，采用能量法导出挠度和力函数的非线性微分方程组，利用积分－差分法实现其数值解，并提供计算结果和分析应力－应变场。采用的计算方法可用于研究毛坯的刚度参数和工艺参数对褶皱结构的形状影响。     

The Freja ultraviolet imager

Auroral images acquired by satellite instrumentation have proven to be a crucial component of the scientific equiry into the physical processes of the Earth's magnetosphere. TheFreja mission provided an opportunity to extend these measurements into the temporal and spatial regime commonly associated with ground-based optical imagers. Employing the basic procedure used successfully in theViking program allowed image repetition rates of 6 s to be achieved with simultaneous exposure of all pixels within the field-of-view. Typical exposure times of 0.3 s required development of an improved image intensifier system and operational requirements resulted in image formats covering approximately one-third of a spin. Simultaneously exposing two broad-band UV cameras, the instrument generates in its normal operational mode 264.6 kbytes per image pair. Results from initial operations confirm the design approach and suggest such imagers can be routinely included on challenging low cost missions such asFreja.     

Global Response of Martian Plasma Environment to an Interplanetary Structure: From Ena and Plasma Observations at Mars

As a part of the global plasma environment study of Mars and its response to the solar wind, we have analyzed a peculiar case of the subsolar energetic neutral atom (ENA) jet observed on June 7, 2004 by the Neutral Particle Detector (NPD) on board the Mars Express satellite. The “subsolar ENA jet” is generated by the interaction between the solar wind and the Martian exosphere, and is one of the most intense sources of ENA flux observed in the vicinity of Mars. On June 7, 2004 (orbit 485 of Mars Express), the NPD observed a very intense subsolar ENA jet, which then abruptly decreased within ∼10 sec followed by quasi-periodic (∼1 min) flux variations. Simultaneously, the plasma sensors detected a solar wind structure, which was most likely an interplanetary shock surface. The abrupt decrease of the ENA flux and the quasi-periodic flux variations can be understood in the framework of the global response of the Martian plasma obstacle to the interplanetary shock. The generation region of the subsolar ENA jet was pushed towards the planet by the interplanetary shock; and therefore, Mars Express went out of the ENA jet region. Associated global vibrations of the Martian plasma obstacle may have been the cause of the quasi-periodic flux variations of the ENA flux at the spacecraft location.     

High Dynamic GPS Receiver Using Maximum Likelihood Estimationand Frequency Tracking

A new high dynamic global positioning system (GPS) receiver ispresented and its performance characterized by analysis,simulation, and demonstration. The demonstration receiver is abreadboard model capable of tracking a single simulated satellitesignal in pseudorange and range rate. Pseudorange and range rateestimates are made once every 20 ms, using a maximum likelihoodestimator, and are tracked by means of a third-order fadingmemory filter in a feedback configuration. The receiver trackspseudorange with rms errors of under 1 m when subjected tosimulated 50 g, 40 g/s circular trajectories. The tracking thresholdis approximately 28 dB·Hz, which provides 12 dB margin relativethe the minimum specified signal strength, assuming 3.5 dB systemnoise figure and 0 dB antenna gain.     

Large-size space laboratory for biological orbit experiments.

The study of space factors on living systems has great interest and long-term experiments during orbital flight will be important tool for increasing our knowledge. Realization of such experiments is limited by constraints of modern space stations. A new technology of large-size space laboratory for biological experiments has been developed on the basis of polymerization techniques. Using this technique there are no limits of form and size of laboratory for a space station that will permit long term experiments on Earth orbit with plants and animals in sufficient volume for creation of closed self-regulating ecological systems. The technology is based on experiments of the behavior of polymer materials in simulated free space conditions during the reaction of polymerization. The influences of space vacuum, sharp temperature changes and space plasma generated by galactic rays and Sun irradiation on chemical reaction were evaluated in their impact on liquid organic materials in laboratory conditions. The results of our study shows, that the chemical reaction is sensitive to such space factors. But we believe that the technology of polymerization could be used for the creation of space biological laboratories in Earth orbit in the near future.     

Nanotechnology-based molecular test equipment (MTE)

This paper describes original research efforts in the design, simulation, and development of nanotechnology-based molecular test equipment (MTE). This is a research effort for testing printed circuit boards independent of traditional automatic test equipment (ATE) through the fabrication of MTE within integrated circuits (ICs). The MTE is embedded within the IC substrate and encapsulated within nanoprobes that connect between the surface and the substrate of the IC at various functional areas. A process is followed whereby IC device simulation is performed to assess the electrical, chemical, and structural properties of integrated and adjacent substrate devices. Through this approach the nominal and failed device performance parameters of interest to substrate-based MTE are found. Discussion of the development and application of MTE within IC architectures is provided, including such topics as the effect of substrate composition on the design and realization of MTE, interfaces between MTE and IC devices, and reporting of MTE results to the IC surface and technician. Potential application areas within different device functions will also be identified. A chemical structure diagram is also provided to illustrate the implementation of MTE using discrete device configurations with MTE-augmented logic