Dose equivalent, absorbed dose and charge spectrum investigation in low Earth orbit.

Particle intensity, dose equivalent and absorbed dose have been measured on board the space shuttle Endeavour during STS-108 in December 2001 by Dublin Institute for Advanced Studies (DIAS). The dose estimates are based on very accurate measurements of recoils produced in CR-39 by cosmic ray primary and secondary protons and heavier nuclei and by secondary neutrons. The corresponding LET spectra were used to determine dose equivalent and absorbed dose values. Estimates of the total flux of Z > or = 2 nuclei have been undertaken and a preliminary charge spectrum was measured. Some comparisons are made with preliminary data obtained on STS-105 (ISS Expedition) and other missions using CR-39 detectors.     

New instrumentation for optical measuring of oxygen in gas or dissolved in liquids.

The optical oxygen sensor is a novel device for the determination of oxygen in gases or dissolved in liquids. It is based on the measurement principle of fluorescence quenching, which is completely different from that of polarographic oxygen sensors (today the most widespread devices of oxygen detection). The new instrument offers features and advantages, which render it not only a realistic alternative, but, for specific applications, make it superior to existing electrochemical methods. The system is based on low-cost semiconductor devices (light-emitting diodes, photodiodes, low-cost analogue and digital components) and new LED-compatible oxygen-sensitive membranes. The flow cell of the instrument may be thermostatted and the sensor can be calibrated by a simple two-point calibration procedure. The optical oxygen sensor is particularly suitable for measuring dissolved oxygen in respirometry, since no oxygen is consumed by the device and the signal is independent of sample flowrate or stirring speed. Typical fields of application are monitoring of oxygen in ground and drinking water, in process control in bioreactors and in breath gas and blood gas analysis.     

Injuries to plants from controlled environment contaminants.

The use of controlled environments is subject to problems from contaminants emitted from materials of the system and from plants. Many contaminants are difficult to identify because injurious dosages are very low, there is a lack of information on what compounds injure plants, because species and cultivars differ greatly in their sensitivity to injury and injury symptoms often are not distinctive. Plastics have been shown to emit many different volatile compounds. The compound, di-butyl phthalate, contained in certain flexible plastics, has been shown to be very toxic to plants. Other injuries have been produced by caulking compounds and bonded screening. Paints have been shown to release xylene that is toxic to plants. Steam for humidification can cause problems because of hydroxylamines and other compounds added to steam used for heating to control fungal growth in return lines. Mercury, from broken thermometers is a particular problem in growth chambers because small quantities can collect in cracks and slowly volatilize to slow growth of plants. Plants themselves release large quantities of volatile hydrocarbons, with ethylene being the commonly recognized chemical that can be damaging when allowed to accumulate. People release large quantities of carbon dioxide which can cause variations in the rate of growth of plants. Contaminant problems can be controlled through filtering of the air or ventilation with make-up air, however the potential for problems is always present and careful testing should be undertaken with the particular species and cultivars being grown insure that there are no toxic agents altering growth in each particular controlled environment being utilized.     

Use of combined light flash and plasma measurements to study hypervelocity impact processes

We present new measurements concerning generation of light flash during hypervelocity impacts. We use iron particles (10⁻¹³ to 10⁻¹⁷ kg) with velocities over the range 1 to 42 km/s impacting semi-infinite targets (aluminium and molybdenum). The main results of previous work in the field are found to be reproduced with some slight deviations. For iron projectiles with given mass and velocity the energy of the flash (normalized to mass) is proportional to velocity to the power of 3.5 for aluminium targets and 3.9 for molybdenum targets. The duration of the flash is of order 1 microsecond. Simultaneous measurements of the generation of impact plasma do not change this. The onset of plasma generation of the bulk target material does not affect the total light flash energy. We discuss the duration of the flash compared to a simple calculation of temperature in the target and plasma vs time.     

Nanotechnology-based molecular test equipment (MTE)

This paper describes original research efforts in the design, simulation, and development of nanotechnology-based molecular test equipment (MTE). This is a research effort for testing printed circuit boards independent of traditional automatic test equipment (ATE) through the fabrication of MTE within integrated circuits (ICs). The MTE is embedded within the IC substrate and encapsulated within nanoprobes that connect between the surface and the substrate of the IC at various functional areas. A process is followed whereby IC device simulation is performed to assess the electrical, chemical, and structural properties of integrated and adjacent substrate devices. Through this approach the nominal and failed device performance parameters of interest to substrate-based MTE are found. Discussion of the development and application of MTE within IC architectures is provided, including such topics as the effect of substrate composition on the design and realization of MTE, interfaces between MTE and IC devices, and reporting of MTE results to the IC surface and technician. Potential application areas within different device functions will also be identified. A chemical structure diagram is also provided to illustrate the implementation of MTE using discrete device configurations with MTE-augmented logic     

An introduction to gravity perception in plants and fungi--a multiplicity of mechanisms.

The origin and subsequent evolution of life on Earth has taken place within an environment of which a 1g gravitational force is a part. Thus, all living organisms accommodate this variable in their structure and function. Evolution has also selected mechanisms to sense gravity which, in consequence, give particular orientations to living process. It is anticipated that the higher the evolutionary status of an organism, the greater the chance that it will possess multiple mechanisms of gravisensing because evolution discards nothing that assists fitness, but only adds to existing processes. A multiplicity of mechanisms permits gravity to participate in a wide range of developmental programmes, such as taxes, morphisms and tropisms, through the action of different sensors and distinct transduction/response pathways.     

Robust Kalman filter design for predictive wind shear detection

Severe low-altitude wind shear is a threat to aviation safety. Newly developed airborne sensors measure the radial component of wind along a line directly in front of an aircraft. The authors use optimal estimation theory to define a detection algorithm to warn of hazardous wind shear from these sensors. To achieve robustness, a wind shear detection algorithm must distinguish threatening wind shear from less hazardous gustiness, despite variations in wind shear structure. Statistical analysis methods to refine wind shear detection algorithm robustness are presented. Computational methods predict the ability to warn of severe wind shear and avoid false warning. Comparative capability of the detection algorithm as a function of its design parameters is determined, identifying designs that provide robust detection of severe wind shear     

Role of BIT in support system maintenance and availability

The role of built in test (BIT) in electronic systems has grown in prominence with the advances in system complexity and concern over maintenance lifecycle costs of large systems. In an environment where standards drive system designs (and provide an avenue for focused advancement in technology), standards for BIT are very much in an evolutionary state. The reasons for advancing the effectiveness of BIT include reduced support overhead, greater, confidence in operation, and increased system availability. The cost of supporting military electronic systems (avionics, communications, and weapons systems) has driven much of the development in BIT technology. But what about the systems that support these end items that contain test and measurement instrumentation - such as automatic test equipment (ATE), simulators and avionics development suites? There has also been a beneficial effect on the maintenance and availability of these systems due to the infusion of BIT into their component assemblies. But the effect has been much more sporadic and fragmented. This paper looks at the state of BIT in test and measurement instruments, explain its affect on system readiness, and present ideas on how to improve BIT technologies and standards. This will not provide definitive answers to BIT development questions, since the factors that affect it are specific to the instrument itself. The topics covered in this paper are: definitions of built-in test, instrument BIT history, importance of BIT fault coverage and isolation in support systems, overview of BIT development process issues that limit the effectiveness of BIT Standards related to instrument BIT, making BIT more effective in support system maintenance and availability and conclusions.     

Chromosome instability of HPRT-mutant subclones induced by ionising radiation of various LET.

The induction of HPRT-mutations and survival of Chinese hamster cells (line B11ii-FAF28, clone 431) were studied after irradiation by 4He and 12C-ions of various LET (20-360 keV/micrometers), produced by the U-200 heavy ion accelerator. The RBE increases with LET up to the maximum at 100-200 keV/micrometers and then decreases. Cytogenetic analysis was performed on the HPRT-mutant subclones selected from unirradiated Chinese hamster V-79 cells and from HPRT-mutant subclones that arose after exposure to gamma-rays, 1 GeV protons and 14N-ions (LET-77 keV/micrometers), produced by the synchrophasotron and the U-400M heavy ion accelerator. Slow growing mutant subclones were observed. The cytogenetic properties of individual clones were highly heterogeneous and chromosome instability was observed in both spontaneous and radiation-induced mutants. Chromosome instability was highest among spontaneous mutants and decreased with increasing LET.     

Large angle pitch attitude maneuver of a satellite using solarradiation pressure

The force exerted by the solar radiation, though very small in magnitude, produces significant effects, especially in the case of high altitude satellites. The solar radiation pressure represents one freely available environmental force that may be put to use for various purposes. This may lead to enhancement of the life of the satellite since it consumes a very nominal amount of on-board energy. The advantages offered by the solar radiation pressure have drawn the attention of several researchers. Various controllers were proposed for many space missions, particularly for attitude control and stabilization of satellites. A controller for achieving large angle pitch attitude maneuver is described. The proposed control law is very simple in its form and requires a minimum number of on-board computations. Varieties of cases are tried and the effect of various parameters is studied