首页 | 本学科首页   官方微博 | 高级检索  
相似文献
 共查询到13条相似文献,搜索用时 93 毫秒
1.
北斗信号二次编码调制了速率为1kbps的NH码,频繁的比特跳变导致传统捕获算法的效果受到抑制,并且限制了积分时间的增长。为了实现北斗弱信号的捕获,提出了一种适合北斗弱信号的捕获算法,将补零算法和差分相干积分算法相结合并进行了优化设计。对补零算法和差分相干积分算法进行了改进,将差分延迟时间调整为20ms,有效消除了NH码的影响,并增加了积分时间,提高了信噪比。采用Monte Carlo仿真测试了在载噪比为20dBHz~38dBHz的条件下,此算法与传统算法的检测性能。结果表明,相比传统算法,此算法的捕获灵敏度提高了约10dB。此算法能够有效消除北斗NH码相位变化对信号捕获的影响,并提高信噪比,适用于弱信号条件下的北斗信号捕获。  相似文献   

2.
随着低轨(LEO)卫星数量的不断增加,利用LEO星座辅助增强GNSS导航性能已经成为一种新的趋势.针对低信噪比环境下B1C信号难以捕获的问题,提出了一种基于LEO辅助的B1C信号高灵敏快速捕获算法.首先对提升接收机捕获灵敏度进行了分析,对比了相干积分与非相干积分对于信号处理增益的影响,得出在低轨导航增强信号的辅助下采用增加相干积分时间的捕获算法对低信噪比条件下B1C信号的捕获更有效.然后提出了一种基于LEO辅助的B1C高灵敏快速捕获算法,从理论分析和实验仿真两方面,对比验证了在LEO辅助下可以显著提高B1C信号的捕获灵敏度,缩短捕获时间,提高捕获效率.  相似文献   

3.
一种改进双块补零北斗导航接收机弱信号捕获方法   总被引:1,自引:1,他引:1  
利用卫星导航系统对高轨航天器进行自主导航与高精度定轨,对接收机的捕获灵敏度要求极高,双块补零(DBZP)算法是无辅助下卫星导航弱信号捕获的理想方案,然而受限于数据处理量大,DBZP实际应用难度大。在深入分析双块补零机理的基础上,结合矩阵重构的思想,提出了一种改进双块补零北斗导航接收机弱信号捕获方法。该方法对参与块内相关运算的基带信号和本地测距码分别进行重构,解决了块内点数与快速傅里叶变换输入点数之间的矛盾,提高了北斗导航接收机弱信号捕获性能。仿真实验结果分析表明,改进双块补零算法对信噪比没有损失,可以保证对低至15dB·Hz的弱信号进行有效捕获,能够满足高轨航天器定轨、室内外无缝导航等对接收机高灵敏度的需求。本方法是在块内运算层面对DBZP进行优化,具备良好的通用性和可移植性,与优化相干积分策略的各种改进DBZP算法可以无缝对接,进一步提高北斗导航接收机信号处理的效能。同时,重构的思想也适用于其他采用码分多址信号的卫星导航系统的弱信号检测和捕获,对提升多星座卫星导航系统的基带信号处理性能具有参考意义。  相似文献   

4.
为了解决低信噪比条件下高跳速DS/FH(直接扩频/跳频扩频)混合扩频信号的快速捕获问题,提出了一种FFT-IFFT(快速傅里叶变换-快速傅里叶逆变换)与非相干累加相结合的并行捕获算法。通过多支路同时运算的方式构建非相干累加矩阵,使非相干累加运算可以并行实施。分析表明,采用并行非相干累加后,既提高了捕获判决的准确性,又保证了捕获搜索的快速性。  相似文献   

5.
为提升高动态低信噪比环境下卫星导航信号的捕获性能,提出了一种基于分数阶傅里叶变换(FrFT)及部分匹配滤波(PMF)的捕获方法。在该方法中,接收机首先利用PMF对接收信号做分段相干积分,随后借助快速傅里叶变换(FFT)对分段积分结果做离散快速FrFT,最后通过检测FrFT输出的峰值完成信号的捕获。由于具有多普勒频率变化率的卫星导航信号在FrFT后呈现能量聚焦特性,所提方法能够显著提高信号的长时间相干积分增益。同时对所提算法的捕获概率、平均捕获时间以及算法复杂度等性能指标进行了理论分析及计算机仿真验证。仿真表明,与传统的PMF-FFT方法相比,所提方法能够通过延长相干积分时间的方式有效提升高动态低信噪比卫星导航信号的捕获概率、降低捕获时间。  相似文献   

6.
BOC调制是新一代卫星导航系统中广泛采用的调制方式,在时域上具有多峰值特性,副峰的存在增加了捕获的难度。采用自相关副峰消除技术(ASPeCT)在原有的BOC码相关支路的基础上增加一条伪码相关支路,可以有效削弱码相位检测函数的副峰,避免误捕获,是一种性能良好的BOC信号捕获技术。提出一种采用二维并行快速搜索的在FPGA芯片中实现ASPeCT捕获技术的方案,可以显著缩短捕获时间。在理论分析和仿真验证的基础上,采用Verilog硬件描述语言在接收机FPGA+DSP平台上编程实现,在露天测试中,成功捕获到Galileo E1B卫星导航信号,并对ChipScope采集的数字中频信号的多普勒频率和码相位静态捕获结果进行验证,与同一段信号的Matlab仿真结果一致,证明所提出的技术方案正确合理可行。  相似文献   

7.
在城市、峡谷等复杂环境下,卫星导航信号衰减严重,接收机导航定位性能变差,甚至不能工作,给国民生产生活带来诸多不便.提高接收机弱信号的跟踪能力,研究高性能的卫星导航接收机具有重要的意义和价值.在研究分析GPS、北斗D1导航电文的调制方式和相干积分方法的基础上,构建了一种改进直方图的位同步方法,该方法借鉴直方图的思想,通过设定比特跳变的统计门限上限和多组门限下限找到比特跳变边沿.在此基础上设计实现了一种长时间相干积分方法,该方法兼容GPS电文和北斗D1导航电文,可以有效地消除导航电文跳变或者NH码跳变带来的比特翻转.最后,在FPGA平台验证了该方法可以有效提高信号信噪比,以及接收机在弱信号环境下的跟踪能力.  相似文献   

8.
弱信号环境下,GPS信号中P码具有很强的抗模仿和抗欺骗能力。为了解决P码直接捕获技术中P码序列特性与无周期性,提出一种快速实现P码捕获的矩阵式直接捕获方法。在对直接平均法进行原理分析的基础上,研究了矩阵式频域直接捕获方法的模型,并对提出的P码捕获算法进行硬件系统设计和实现,在弱信号环境下对矩阵处理器进行实际测试。结果表明,与传统方法相比,算法能提高硬件效率,缩短捕获时间,提高数据处理效率。  相似文献   

9.
研究了GPS软件接收机的捕获与跟踪算法。分析了时域串行滑动相关捕获算法和频域基于FFT的并行相关捕获算法,设计了适合GPS软件接收机的并行算法,实现了对空中可见卫星的捕获。针对GPS信号的特点,设计了基于DLL与PLL相结合方法的GPS跟踪算法。利用实测中频信号对上述捕获与跟踪算法进行了验证分析,测试结果表明,基于FFT的并行相关捕获算法能够有效增强软件接收机的捕获能力,采用DLL与PLL相结合的方法能够实现对GPS信号的有效跟踪。  相似文献   

10.
针对北斗二代B1频点信号比特翻转频繁的问题,设计并实现了基于FPGA的北斗B1频点导航接收机基带处理器.该处理器在信号捕获过程中设计了频率精细搜索的精捕获算法,避免了假捕获并且提高了捕获频率的精度;在载波跟踪环路中设计2阶锁频环辅助3阶锁相环的方案,以提高环路跟踪的动态性能.其中,锁频环和锁相环均设计了对比特翻转敏感的鉴别器,保证环路跟踪的准确性.试验结果表明,该基带处理器设计具有较高精度的捕获频率和良好的高动态跟踪能力.  相似文献   

11.
A high-resolution algorithm is presented for resolving multiple incoherent and coherent plane waves that are incident on an array of sensors. The incident sources can be a mixture of narrowband and broadband sources, and, the geometry of the array is unrestricted. The algorithm makes use of a fundamental property possessed by those eigenvectors of the array spectral density matrix that are associated with eigenvalues that are larger than the sensor noise level. Specifically, it is shown that these eigenvectors can each be represented as linear combinations of the steering vectors identifying the incident plane waves. This property is then used to solve the important special cases of incoherent sources incident on a general array and coherent sources incident on an equispaced linear array. Simulation results are presented to illustrate the high-resolution performance achieved with this approach relative to that obtained with MUSIC and spatial smoothed MUSIC in which the coherent-signal-subspace focusing method is used  相似文献   

12.
A signal processor that provides ratio-squared predetection combining, has been investigated for application in an adaptive antenna array. The analysis and experimental data presented here pertain to the signal processing gain when the antenna array is illuminated by a coherent signal source and a partially coherent noise source. For a noise source which is coherent, the processing gain depends on relative strength of the signal and noise, relative directions of arrival, and the usual "array factor." The array exhibits capturing effects much as in an FM receiver. The effective antenna pattern is a superposition of two beams of different magnitudes, one directed to the signal source and the other to the noise source. When the noise is partially coherent, the behavior of the signal processor is quite complex. Analytical prediction and experimental simulation measurement on a four-channel system indicate that the partially coherent noise may be regarded as the source of an incoherent noise component plus a coherent noise component with the magnitude of the latter determined by the coherence coefficient for the noise source.  相似文献   

13.
Coherent detectors in radar and communications receivers are generally implemented in the form of two parallel baseband channels which form in-phase (I) and quadrature (Q) components of a received RF/IF signal. Phase errors of several degrees due to imperfect matching of these separate channels limit the performance achievable from signal processors such as moving target indicators (MTI), coherent integrators, Doppler filters, antenna array processors, and coherent sidelobe cancellers. Thus methods in which a single analog to digital (A/D) converter samples and digitizes the IF signal directly, eliminating the need for IF to baseband conversion, have been of recent interest and are the subject of this paper. To obtain accurate coherent detection from IF samples taken near the Nyquist rate requires interpolation based upon a number of stored samples. An algorithm derived from sampling theory is defined and used to demonstrate accurate reconstruction of the original IF signal from digitized samples. In-phase and quadrature components of the signal are shown to be available from processed samples with demonstrated phase errors less than 0.2°.  相似文献   

设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号