共查询到20条相似文献,搜索用时 125 毫秒
1.
2.
3.
Anpredictionsystemforthein-ductsoundfieldinaeroenginecanprovidethetheoreticalfoundationforthepracticalengineeringsup-pressing... 相似文献
4.
5.
Denoising methods in interferometric SAR images processing 总被引:1,自引:0,他引:1
InterferometricSAR(InSAR)providesameanstoobtainhighresolutiondigitaltopo-graphicmapswithlargeswathwithouttheefectoftheweather... 相似文献
6.
7.
8.
THERMALCALCULATIONFORANTI-ICERWITHMICRO-EJECTORQuiXiegang;YuXiaozhang(NanjinjingUniversityofAeronaulicsandAstronautics,Nanjin... 相似文献
9.
10.
11.
为了提高雷达成像的质量.得到高分辨率的SAR图像就必须保证有精确的运动补偿方法来校正运动误差对成像的影响。提出了一种基于惯导数据INS的视线方向位移误差的补偿方法,采用了低精度低成本的INS.对此部分的原理及实现进行了深入的建模分析和推导,并给出仿真结果。结果表明,基于惯导进行运动补偿时低精度也可满足要求。 相似文献
12.
It is shown that synthetic-aperture radar (SAR) motion can be compensated by using an antenna-mounted strapdown inertial measurement unit (IMU) as the motion sensing system, but sensor and system errors affect SAR image quality. A strapdown IMU consists of three accelerator channels and three gyro channels. Strapdown IMU errors include gyro-scale and accelerometer-scale factor and bias errors, velocity error, platform tilt, and errors induced by limited inertial sensor bandwidth. The effects of these errors on the SAR image quality are presented in terms of the SAR impulse response. IMU errors that cause low-frequency phase errors (less than one cycle per array time) are categorized in terms of quadratic and cubic phase errors. IMU errors that cause high-frequency phase errors (greater than one cycle per array time) are categorized in terms of the integrated sidelobe ratio and peak sidelobe ratio. A motion compensation system conceptualization is described wherein a strapdown IMU is attached to an antenna and transfer-aligns to the aircraft's master navigator 相似文献
13.
用于SAR运动补偿的DGPS/SINS组合系统研究 总被引:12,自引:1,他引:11
使用考虑位置误差相关项的伪距率观测模型 ,研究了用于合成孔径雷达运动补偿的差分 GPS/ SINS伪距率组合系统。结果表明 ,组合系统的长期位置精度能达到 1 m左右。 GPS数据更新率低于 INS,在 GPS测量时间间隔内 ,组合系统的性能仅由 INS决定。虽然 INS误差随时间积累 ,在 GPS数据更新率为 1 s的情况下 ,即使采用中等精度的惯性仪表 ,其相对位置精度为厘米级 (这里相对位置精度指组合系统在 GPS测量时间间隔内位置误差的变化范围)。 相似文献
14.
针对机载合成孔径雷达(SAR)高分辨率宽测绘带(HRWS)成像问题,在分析结合两步运动误差补偿的距离徙动算法基础上,提出一种基于数值计算的空变运动误差补偿算法。通过对粗聚焦图像进行分块,在子块的两维波数域进行空变运动补偿,补偿的相位包括方位相位误差、距离相位误差以及方位和距离的耦合相位,因此该算法在复杂航迹、高分辨和宽测绘带情况下仍具有较好的鲁棒性。最后对SAR仿真数据和实测数据进行处理,并与结合两步运动误差补偿的距离徙动算法进行比较,处理结果表明该算法能够更好地补偿空变运动误差。 相似文献
15.
运动补偿用惯性器件误差对SAR成像分辨率的影响研究 总被引:1,自引:0,他引:1
为提高合成孔径雷达(SAR)系统的性价比,必须根据SAR成像分辨率的要求和整体系统参数,设计相应精度的运动补偿用捷联惯导系统。在确定SAR运动补偿系统方案和安装方式的基础上,分析不同方向的加速度计和陀螺仪误差对天线相位中心位置测量误差的影响,并利用位置测量误差与SAR成像分辨率之间的关系,进一步明确了不同方向的加速度计和陀螺仪对SAR成像分辨率的影响。研究表明:基于SAR的工作原理和安装方式,x方向加速度计和y方向陀螺仪对SAR成像分辨率的影响明显比其他惯性器件严重;相同误差水平的惯性器件对SAR成像分辨率的影响随着合成孔径时间和工作波长的不同而不同,时间越长,波长越短,影响则越严重。SAR成像仿真证明了结论的正确性。研究结果对于研制高性价比SAR成像运动补偿系统有一定的理论指导意义。 相似文献
16.
This paper addresses differential global positioning system (DGPS)/inertial measurement unit (IMU) integration-based geolocation system developed for airborne remote sensing cameras. First, we provide a brief review on sensor calibration, alignment and sensor fusion as background material of this research. After presenting those background material, as a main part of this paper we present a geolocation algorithm designed for an airborne imaging system. The geolocation system developed is tested through actual airborne experiments. For the verification of the geolocation system developed, we compare initial stationary states of the airplane before-taking off with states after-landing. From the actual test results, we find that it is critical to do an accurate time synchronization between IMU, DGPS, and airborne images, and to compensate for the data delay occurred during the network transfer. 相似文献
17.
18.
为保证机载捷联惯组的导航精度能够达到要求,需要对惯组定期进行返厂标定,成本高、周期长,也影响载机的使用效率,故而机载惯组在线标校技术的研究一直在不断进行中。对大中型运输机的机载惯组而言,由于其机体较大、机动能力较差,很难完成诸如S机动等复杂的机动动作,故而需要对其常规飞行机动状态下机载SINS/GPS组合导航系统的可观测性进行分析。利用GPS提供的速度和位置信息作为外部观测量来设计Kalman滤波器,采用基于分段线性定常系统(PWCS)的奇异值分解法(SVD),对飞机静止、起降、匀速飞行、匀加减速飞行、转弯等一系列常规机动条件下系统的可观测性和可观测度进行研究。通过Matlab仿真和转台实验,验证了组合导航系统可观测性分析结论的有效性,可为机载惯组的在线标校提供一定参考。 相似文献
19.
20.
Operational deficiencies exist in the current ability to perform high resolution synthetic aperture radar (SAR) targeting for precision strike missions in difficult electronic countermeasure (ECM) and anti-aircraft environments. Increasingly sophisticated enemy defenses require that fire control information be derived from highly maneuverable aircraft trajectories rather than traditional straight-and-level flight. In addition, target area aspect information is needed to determine optimal attack approaches. These imaging and targeting conditions impose severe performance requirements on the sensor aircraft motion compensation system (MCS), and dictate the need for sophisticated algorithms to counteract ECM threats. This paper describes the development of a user friendly “Design Tool” for modeling and analysis of airborne radar system performance for SAR imaging and Precision SAR Targeting 相似文献