| 基于可压缩流体的热线探针校准风洞研制 |
| |
| 引用本文： | 马护生,刘会龙,秦天超,杜炜,时培杰,任思源.基于可压缩流体的热线探针校准风洞研制[J].实验流体力学,2017,31(1):93-99. |
| |
| 作者姓名： | 马护生 刘会龙 秦天超 杜炜 时培杰 任思源 |
| |
| 作者单位： | 中国空气动力研究与发展中心, 四川 绵阳 621000 |
| |
| 摘 要： | 在可压缩流体中利用热线技术进行湍流度测量时，其输出不仅与脉动速度有关，也和流体温度、密度紧密相关。因此，需要建立与高速可压缩流体特征相似的校准装置，在使用前对热线探针进行准确校准。基于亚跨声速可压缩流体，对热线探针校准风洞的气动总体方案、关键结构设计、测控处系统研制等做了介绍和说明。风洞流场校测结果表明，模型区Ma最大偏差0.002，风洞速压可以降低至常规速压的50%以下，也可增至常规速压的1.7倍以上，温度和密度调节范围宽，流场均匀性好，满足热线探针校准需求。
|
| 关 键 词： | 可压缩流体 热线探针 校准风洞 流场校测 |
| 收稿时间： | 2016-07-08 |
Development of hot-wire probe calibration wind tunnel based on compressible fluid |
| |
| Affiliation: | China Aerodynamics Research and Development Center, Mianyang Sichuan 621000, China |
| |
| Abstract: | The output of the hot-wire is related not only to the fluctuation velocity, but also to the fluid temperature and density when the hot-wire technology is used to measure the turbulence intensity in a compressible fluid. Therefore, it is necessary to establish a calibration facility with similar characteristics to a high speed compressible fluid so that the accurate calibration of the hot-wire probe can be done before its usage. In this paper, the aerodynamic overall scheme, structural design and development of measurement and control system of the hot-wire probe calibration wind tunnel are introduced and illustrated based on subsonic and transonic compressible fluids. According to the results of the wind tunnel flow field calibration tests, the maximum deviation of the Mach number in the model area is 0.002; the dynamic pressure can be adjusted from 0.5 to 1.7 times of the normal dynamic pressure; the variation range of temperature and density is wide; the uniformity of the flow field are good. All the requirements for the hot-wire probe calibration are satisfied. |
| |
| Keywords: | |
| 本文献已被 CNKI 等数据库收录！ |
| 点击此处可从《实验流体力学》浏览原始摘要信息 |
|
点击此处可从《实验流体力学》下载全文 |
|
